National Instruments SCXI-1181K Manuale utente

371063A-01 © 1994 National Instruments Corporation. All rights reserved August 1998

Installation Guide

SCXI-1181K Custom Module Assembly

This guide documents the contents of your SCXI-1181K custom module assembly kit and

includes illustrations of the circuit board specifications and the module assembly.

Introduction

The SCXI-1181K custom module assembly kit includes the unassembled components you need

to build a custom SCXI module, but not the actual circuit board. All of the mechanical

components of an SCXI module, such as the metal enclosure, front and back panels, and

connectors, are included.

The SCXI-1181K is intended for developers of custom SCXI modules who design and lay out

custom circuit boards for modules. For prototyping or building low-volume custom SCXI

modules, the fully assembled SCXI-1181 breadboard moduleis more appropriate.

What Your Kit Should Contain

The SCXI-1181K custom module assembly kit (part number 776572-81K) contains the

components listed in the following table. The reference numbers in the left column of the table

refer to callouts in Figure 1.

Reference

Number Component Quantity

1 Module front panel 1

2

3 Thumb screw, 2.5 mm 2

4 #4 x 5/16 in. Phillips screw, flat head 2

5 Enclosure base 1

6 Module rear panel 1

7 #4 x 5/16 in. Phillips screw, pan head 3

8 Enclosure cover 1

9 Identification label 1

J1 3 x 32 position Deutsche Industrie Norme

connector header 1

J2 50 position connector header 1

P1 4 x 6, 2 mm connector, push-fit 4

— Installation guide 1

1

Module front panel overlay

SCXI-1181K Custom Module Assembly Install. Guide 2 © National Instruments Corporation

Refer to the reference numbers of the components in the previous table and the corresponding

components in Figure 1 for module assembly.

Note: The four P1 connectors have a push-fit peg. Secure the P1 connectors to the printed

wire circuit board (PWB) by pushing the connector onto the PWB so that the middle

peg of the connector presses into the 0.081 in. hole in the PWB. National Instruments

recommends using the push-fit peg hand tool (part number CTHT-200) manufactured

by ITT Cannon for this installation. You can contact ITT Cannon at (800) 845-7000.

Figure 2 shows the SCXI module PWB outline.

Questo manuale è adatto per i seguenti modelli

1

Indice

Altri manuali National Instruments Unità di controllo

National Instruments

National Instruments NI PXIe-7976R Manuale utente

National Instruments

National Instruments NI 9246 Manuale utente

National Instruments

National Instruments SCXI Series Manuale utente

National Instruments

National Instruments sbRIO-9651 Guida

National Instruments

National Instruments PXIe-5693 Manuale utente

National Instruments

National Instruments NI 9234 Manuale utente

National Instruments

National Instruments PXI-6682 Series Manuale utente

National Instruments

National Instruments FD-11634 Manuale utente

National Instruments

National Instruments SCC-TC Series Manuale utente

National Instruments

National Instruments SCC-FT01 Manuale utente

National Instruments

National Instruments LabVIEW Robotics Module Manuale utente

National Instruments

National Instruments SCC-FV01 Manuale utente

National Instruments

National Instruments SCXI-1120/D Manuale

National Instruments

National Instruments PXI-6683 Series Manuale utente

National Instruments

National Instruments ELVIS RIO CM Manuale utente

National Instruments

National Instruments PXIe-8246 Manuale utente

National Instruments

National Instruments PXIe-6591R Manuale utente

National Instruments

National Instruments Module SCXI-1125 Manuale utente

National Instruments

National Instruments 9472 Manuale utente

National Instruments

National Instruments NI 9203 Manuale

National Instruments

National Instruments TB-4304 Manuale utente

National Instruments

National Instruments Phase Matrix PXI-1420 Manuale utente

National Instruments

National Instruments 5772R Manuale utente

National Instruments

National Instruments SCXI-1000 Manuale utente

Manuali Unità di controllo popolari di altre marche

Festo

Festo Compact Performance CP-FB6-E Manuale elenco delle parti

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuale utente

JS Automation

JS Automation MPC3034A Manuale utente

JAUDT

JAUDT SW GII 6406 Series Guida rapida

Spektrum

Spektrum Air Module System Manuale utente

BOC Edwards

BOC Edwards Q Series Manuale utente

KHADAS

KHADAS BT Magic Manuale utente

Etherma

Etherma eNEXHO-IL Manuale utente

PMFoundations

PMFoundations Attenuverter Manuale utente

GEA

GEA VARIVENT Manuale utente

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuale utente

Altronix

Altronix LINQ8PD Istruzioni per il montaggio

Eaton

Eaton Powerware Series Manuale utente

WAGO

WAGO 750-407/040-000 Manuale utente

Sony

Sony CCU-590 Manuale utente

Graco

Graco 25D614 Manuale utente

Task Force Tips

Task Force Tips YE-RF-900 Manuale di programmazione

Shini

Shini SPV-U Series Manuale utente