Olympus CX43-RFAB Manuale utente
CX43-RFAB
This instruction manual is for the B excitation fluorescence illuminator.
To ensure the safety, obtain optimum performance and to familiarize yourself fully with the use of this
product, we recommend that you study this manual thoroughly before operating this product, and
always keep this manual at hand when operating this product.
Retain this instruction manual in an easily accessible place near the work desk for future reference.
INSTRUCTIONS
B excitation fluorescence illuminator
A X 8 9 1 6
Optical Microscope Accessory
In accordance with European Directive on Waste Electrical and Electronic Equipment, this symbol indicates that the
product must not be disposed of as unsorted municipal waste, but should be collected separately.
Refer to your local Olympus distributor in EU for return and/or collection systems available in your country.
For Korea only
B급 기기 (가정용 방송통신기자재)
이 기기는 가정용(B급) 전자파적합기기로서 주로 가정에서 사용하는 것을
목적으로 하며, 모든 지역에서 사용할 수 있습니다.
NOTE: This product has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the product is operated
in a commercial environment. This product generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this product in a residential area is likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
FCC WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the product.
This product is applied with the requirements of standard IEC/EN61326-1 concerning electromagnetic compatibility.
• Immunity Applied to industrial and basic environment requirements.
CX43-RFAB
Introduction ...............................................................................................................................................1
Safety precautions ..............................................................................................................................2
1 Nomenclature of microscope operating portions .............................................6
2 Reflected fluorescence observation method ........................................................7
3 Operation procedures ................................................................................................................8
1 Operating the B excitation fluorescence illuminator ..............................................................................................8
2 Escaping the condenser top lens ...........................................................................................................................................9
4Assembly ................................................................................................................................................10
1 Attaching the B excitation fluorescence illuminator ................................................................................................10
2 Connecting the AC adapter and power cord ................................................................................................................11
3 Attaching the hook stick holder ................................................................................................................................................12
5 Specifications .....................................................................................................................................13
Contents
CX43-RFAB
1
If the product is used in a manner not specified by this manual, the safety of the user may be imperiled. In addition, the
product may also be damaged. Always use the product according to this instruction manual.
Introduction
The following symbols are used in this instruction manual.
CAUTION : Indicates a potentially hazardous situation which, if not avoided, may result in
minor or moderate injury.
NOTE
: Indicates a potentially hazardous situation which, if not avoided, may result in
damage to the product or other property.
TIP
: Indicates the useful knowledge or information for use.
This product is used for a reflected light fluorescence observation in combination with the biological
microscope CX43.
2
Safety precautions
CAUTION - Electric safety -
Always use the AC adapter and power cord provided by Olympus.
If the proper AC adapter and the power cord are not used, the electric safety and the EMC (Electro-Magnetic Compat-
ibility) performance of the product cannot be assured. If no power cord is provided, please select the proper power
cord by referring to the section “Proper selection of the power cord” at the end of this instruction manual.
Always connect the ground terminal.
Check that the ground terminal of the power cord and that of the power outlet are connected properly. If the product is
not grounded, our intended electric safety and EMC performance of the product cannot be assured.
Do not use this product near the sources of strong electromagnetic radiation.
Proper operation may be interfered. Be sure to evaluate the electromagnetic environment before operating the product.
Disconnect the power cord in case of emergency.
In case of emergency, disconnect the power cord from the power cord connector of the product or from the power
outlet.
Install the product at the location where you can reach the power cord connector or the power outlet with your hand to
disconnect the power cord immediately.
This product complies with the emission and immunity requirements described in IEC61326 series.
CX43-RFAB
3
CAUTION - LED (light emitting diode) -
Do not look directly at the light from LED for a long time.
If you feel that the light from LED is too bright during observation, adjust the light intensity using the brightness adjustment
knob before continuing the observation. The LED built in this product is basically eye-safe. However, do not look directly
at the light from LED for a long time while feeling too bright, since it may cause damage to your eyes.
CAUTION - Light from the objective -
Do not look directly at the light coming out from the objective or the light reflected from the specimen.
Be careful about the light coming out from the objective, since not only visible light but also light of invisible wavelengths
(such as ultraviolet and infrared) may be emitted depending on the illumination methods.
4
CAUTION - Safety symbols -
The following symbols are attached to the product.
Study the meaning of the symbols and always use the product in the safest possible manner.
Symbol Meaning
Indicates a non-specific general hazard. Follow the description given after this symbol
or in the instruction manual.
Indicates that the main switch is ON.
Indicates that the main switch is OFF.
Handling precautions
· This product is a precision instrument. Handle it with care and avoid subjecting it to a sudden or
severe impact.
· Never disassemble any part of the product. Otherwise, failure could be caused.
· Do not carry the microscope keeping the AC adapter connected to the microscope. The AC adapter or
the microscope may be damaged by hitting the output connector of the AC adapter.
NOTE
CX43-RFAB
5
Maintenance and storage
1. Do not leave stains or fingerprints on the lenses and filters. If they get dirty, blow away dust with a commercially avail-
able blower and gently wipe the lens or filter with a piece of cleaning paper (or clean gauze). Only when cleaning
fingerprints and oil stains, slightly moisten a piece of cleaning paper with commercially available absolute alcohol
and wipe them off with it.
Since the absolute alcohol is highly flammable, it must be handled carefully. Be sure to keep it away
from open flames or potential sources of electrical sparks. For example, the electrical equipment that
is switched ON and OFF may cause the ignition of a fire. Also, always use absolute alcohol only in a
well-ventilated room.
2. Wipe the portions other than the lens with a dry soft cloth. If the dirt cannot be removed by dry-wiping, moisten a soft
cloth with diluted neutral detergent and wipe the dirty surface with it.
Do not use organic solvents because they may deteriorate the coated surface or plastic parts.
3. When disposing of this product, be sure to follow the regulations and rules of your local government. Contact Olympus
for any questions.
CAUTION
NOTE
6
1 Nomenclature of microscope operating portions
1
* : For operating procedures, refer to the instruction manual of the microscope frame (CX43).
Y-axis knob
*
Revolving nosepiece
*
X-axis knob
*
Main switch
*
: Power is ON.
: Power is OFF.
Fine focusing knob
*
Coarse focusing knob
*
Aperture diaphragm
lever
*
Specimen holder
*
Condenser turret
*
Brightness
adjustment knob *
Diopter
adjustment ring
*
Binocular portion*
Condenser top lens
(see page 9)
Aperture diaphragm
Aperture diaphragm
lever
*
B excitation fluorescence
illuminator (see page 8)
Y-axis knob
*
X-axis knob
*
2c
49
6
7
5a
8
d
3
3
3
5af
5af
bef
The number indicating the operation portion corresponds to the observation method described on the next page.
1
Main switch
*
Indice
Altri manuali Olympus Microscopio
Olympus
Olympus VM Series Manuale utente
Olympus
Olympus BX53-P Manuale utente
Olympus
Olympus BX51 Manuale utente
Olympus
Olympus BX51 Manuale utente
Olympus
Olympus BX-FLA Manuale utente
Olympus
Olympus DP21 Manuale utente
Olympus
Olympus BHTP Manuale utente
Olympus
Olympus Fluoview FV1000 Manuale utente
Olympus
Olympus BH2 Series Manuale utente
Olympus
Olympus BH2-5RE Istruzioni per l'installazione
Olympus
Olympus IX2-DSU Manuale utente
Olympus
Olympus Fluoview FV1000 Manuale utente
Olympus
Olympus BHA-P Manuale utente
Olympus
Olympus MIC-D Manuale utente
Olympus
Olympus bx40 Manuale utente
Olympus
Olympus IX71 Manuale utente
Olympus
Olympus Fluoview FV1000 Manuale utente
Olympus
Olympus SZX16 Manuale utente
Olympus
Olympus CX31 Manuale utente
Olympus
Olympus CHBS Manuale utente
