Parago! GoSafe 230 Manuale utente
230
Quick Start Guide
使用說明
Guide d'utilisation
Disclaimer
1.Please follow the set-up and usage instructions in the print material that
came with this Dashboard Camera (dash cam) product.
2.You should not set/install this dash cam at a place that would obstruct or
reduce a driver’s view; make sure your usage comply with pertinent vehicle
codes of your state, province, territory or country.
3.You should post the required notices of recordation to occupants inside the
vehicle, if voices or other information/signal pertaining to in-vehicle
activities will be recorded.
4.You should not change the dash cam’s setting or mode of operation when
the vehicle is in motion.
5.The optional driving warning signals, including any visual or audible
reminder signals, should not replace your decision-making and judgment
that are needed for the proper operation of the vehicle.
6.You should not leave the dash cam in a visible spot when no one is inside
the vehicle, to avoid attracting break-ins to steal the unit, or other property.
7.You should avoid extended exposure of the dash cam to direct sunlight or
extreme temperatures (either high or low temperature) which tend to
degrade or damage the unit and its normal functionality.
8.You should examine, check and/or verify the dash cam at least every six
(6) months, including the associated memory cards, to ensure the video
reception and recording are working properly. For each use, you should
verify that the dash cam unit, the visible lights and the audible sounds are
working normally. If there are signs of non-operation or mal-function, you
should immediately seek to replace the product and check to see if the
product is covered under any applicable warranty.
9.The dash cam unit may have additional functionality, such as transmission
and recordation of audible or GPS signal or other identification information.
If you have privacy concerns about these functions, make sure you follow
the instruction to disable these functions.
10.You should use the dash cam unit in the way it is intended. You should
not use the dash cam unit in a way that would be illegal or that tends to
physically damage the unit, or tends to cause danger to the safe operation
of the vehicle or the occupants.
English 1
English 2
Attention please
【About Usage】
①If your vehicle still provides power when the vehicle is off, unplug the
device when you plan to have your vehicle parked for a long period to
avoid draining your vehicle’s battery.
②To avoid file corruption, don’t eject the Micro SD Card immediately after
powering off.
③ It is recommended to use adapter provided.
④To enable monitoring function, the power supplier must be enabled.
【About Micro SD Card】
①Use only Class 10 Micro SD Cards with at least 8GB memory (Up to
32GB).
②Format Micro SD Card before using.
To format card press “Menu button”, when you get to settings----Format
---- OK
*Product features may change without notice
according to region in which it is purchased.
1. Product Introduction
1.1 Package Contents
Check the items in your package with the list below. If any of the below items
is damaged or missing, contact your retailer.
English 3
①Device ③Car Charging Cable
④Quick Start Guide ⑤Warranty Card ⑥8GB MicroSD
②Suction Mount
1.2 Driving Recorder Overview
English 4
LED light
Display
SD card Slot
AV-OUT Slot
USB Slot
Bracket hole
Power button
Up button
Menu button
OK button
Mode button
Down button
Reset button
Mic
Speaker
Lens
Fill Light
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
10
10
11
11
12
12
13
13
14
14
15
15
16
16
17
17
◄
►
MENU MODE
OK
R
2. Installation and removal
English 5
①For better view, try to install in the center of the windshield.
②To ensure view is clear, make sure the lens is located in a place where the
windshield wiper wipes the window.
③Make sure device is not installed where it will interfere with the air bag.
④Make sure the device will not be obstructed by windshield’s window tint.
⑤Clean the area you wish to place the dash cam before mounting
the device. DO NOT move the device for a 24-hour period.
2.1 Location
Best mounting
location
Connect to
car charger
Windshield
Caution: We are not responsible for any damage caused to,
or caused by, the air bag due to incorrectly placing the
device within the range of the safety bag area.
English 6
3. Start and Go
Insert the car charger cable into the car’s cigarette lighter and the other end
into the Mini USB port on the device. Make sure to install the Micro SD Card
into the Micro SD Card slot on device. After turning on, the system will start
recording automatically. The LED light will turn Red when recording mode
has started.
Reminder: Please format Micro SD card before you start recording. Please
refer to page 2 for instructions.
3.1 Power On
To Turn off device, hold the power button for at 3 seconds. To avoid
corrupting the last file recorded, do not eject SD Card immediately after
powering off.
To turn it back on, simply hold power button for at least 1 second.
3.2 Power Off
3.3 LED
LED Color
Red LED blinking
Red LED on
Green LED on
Behavior
Recording
Standby
Charging
English 7
Buttons Behavior
3.4 Buttons
Power
◄
Up
►
Down
Menu
Mode
OK/REC
Non-recording mode: Leads to Settings.
Recording mode: Turn on Emergency Recording.
Browse mode: Up
Recording mode: Start/stop recording.
Camera mode: Takes a picture.
Browse mode: Play/pause file.
Non-recording mode: Switches modes. This dash camera has
three modes to choose from: Record/Camera/Browse.
Recording mode: Turns audio recording on/off.
Browse mode: Down
Reset Reboots dash cam.
One long press to turn device on/off.
3.5 Recording
White Balance
Mode 00:00:26
01/19/2017 00:00:26
FHD
AUTO
Emergency
Recording
Loop
Recording
Fill Light
Video Recording Time
Current date & time
Memory
Card
Charge
Recording
Resolution
Audio Recording Indicator
Motion Detection
English 8
English 9
4. Settings
A. Video Menu Settings
Press the Menu button once to enter Video menu settings. Use the up /
down buttons to select the listed settings. Press the OK button to select and
confirm options. To Exit, press the Menu button twice.
● Specific menu is as follows:
1. Resolution: 1080FHD/720P/WVGA/VGA
2. Loop Recording: off /1 /2 /3 / 5 minutes
3. Exposure: Value can be set between -2 and +2.
4. White Balance: Automatic / Daylight / Cloudy / Tungsten / Fluorescent
5. Motion Detection: Off / On
6. Date Stamp: Off / On
B. Main menu settings:
Press Menu button twice to enter the Main menu settings. Use the up / down
buttons to select the listed settings. Press the OK button to select and
confirm options. To Exit, press the Menu button.
● Specific menu is as follows:
1. Beep (Key) Sound: On / Off
2. Record Audio: On / Off
3. Fill Light: On / Off
4. Frequency: 50HZ / 60HZ
5. Auto Power Off: Off/ 1 Min / 3 Min / 5 Min
6. Screen Saver: Off / 10 Sec / 30 Sec / 1 Min
7. Date/Time – Set
8. Language: English / Traditional Chinese / Français / Español / Portuguese
9. TV Out: NTSC / PAL
10. Format: (To format SD Card. Note: All data will be deleted)
11. Version: (To view software version)
12. Default Setting
Indice
Lingue:
Altri manuali Parago! Telecamera da cruscotto
