
ISSUED: 05-19-04 SHEET #: 081-9032-3 02-14-06
For customer service call 1-800-729-0307 or 708-865-8870.
Visit the Peerless Web Site at www.peerlessindustries.com 5 of 5
If adhesive foam (H) is covering slots, trim foam (H) to expose slots. Insert four carriage bolts (D)into
slots of upper DVD mount (A). Loosely attach lower DVD mount (A) using four #10 SAE washers (F)
and #10-24 nylock nuts (E). This will allow access to the vertical adjustment screws of the upper mount
by being able to easily move the lower mount. Note: TV and TV mount not shown in illustrations.
Installing Multiple DVD/DVR/VCR Mounts
Adjust size of the upper DVD mount (A) to fit media player by loosening screws on both sides. Insert
mediaplayerandalign front of player with front of TV onTVmount.Tightenverticaland horizontal
adjustment screws where shown on both sides until player securely fits in mount.
Note: To access the vertical adjustment screws of the upper mount, slide the lower mount to the side.
Repeatfortheopposite side.
Centerlower DVD mount(A) and securely tightenfour nuts (E). Repeat beginning of this step to install
the media player into the lower DVD mount.
©2004PeerlessIndustries,Inc.Allrightsreserved.
PeerlessandJumboareregisteredtrademarksandPenta-PinisatrademarkofPeerlessIndustries,Inc.
Allotherbrandandproductnamesaretrademarksorregisteredtrademarksoftheirrespectiveowners.
• Do not stack more than three DVD/DVR/VCR Mounts
fromaTV mount.
WARNING
• Stacked load cannot exceed 50 lb.
WARNING
UPPERMOUNT(A)
LOWERMOUNT(A)
H
VERTICAL
ADJUSTMENT
SCREW
DETAIL 1
E
D
F
UPPERMOUNT
LOWERMOUNT
MEDIAPLAYER
HORIZONTAL ADJUSTMENT
VERTICALADJUSTMENT