Phase CI-MM3-II Guida alla configurazione
Grille
Grillesafetyclip
Screws
Speaker
Two-gangjunctionbox(installersupplied)
NOTE: the CI-MM3-II is designed to install
into a standard 2-gang junction box. Phase
Technology recommends you test the t
before installing the junction box.
Box contents
1 Speaker
2 Grilles
4 Mounting screws
2 Wire nuts
©2010PhaseTechnology. Allrights reserved. Rev08.30.10
T E C H N O L O G Y
CI-MM3-II
Install instructions for Spacia models:
8005 W. 110th St. | Suite 208 | Overland Park, KS 66210 | 855.663.5600 | www.phasetech.com | www.mseaudio.com
1. Unpack speaker.
6. Done!
1.
2.
4. Attach grille safety clip by
placing the large end of the
clip over snap-t post (1),
then sliding clip until small
end snaps into place around
post (2).
5. Align tabs on snap-t grille
with slots in bae, gently
press grille into place.
Install instructions for Spacia models, Page 2
2. Connect speaker wires to
signal wires using included
wire nuts.
3. Install the CI-MM3-II into
the installer supplied
junction box using included
fasteners.
8005 W. 110th St. | Suite 208 | Overland Park, KS 66210 | 855.663.5600 | www.phasetech.com | www.mseaudio.com
Altri manuali Phase Altoparlanti
Phase
Phase POWER FL-8 Manuale utente
Phase
Phase SOLARIS SPF-25 Manuale utente
Phase
Phase Velocity Series Manuale utente
Phase
Phase CI60 VII CI CUSTOM INSTALL SERIES Manuale utente
Phase
Phase CI110 II Manuale utente
Phase
Phase CI Series Guida alla configurazione
Phase
Phase Velocity V52 Manuale utente
Phase
Phase CI-10 VIII Manuale utente
Phase
Phase CI120 Istruzioni originali
Phase
Phase CS-6R/Micro Manuale utente
