PIKA T1/E1 Manuale utente
PIKA T1/E1 (HMP) PCIe
Board
Copyright (c) 2010. All rights reserved.
Table of Contents
Copyright Information 1
Contacting PIKA Technologies 2
Preface 3
Related Documentation 4
Introduction 5
Compliance 5
Board Description 8
Block Diagram 8
Board Dimensions and Component Layout 9
Jumper Settings 10
Expansion Boards 10
Connector Pinouts 10
Technical Specifications 12
Glossary 14
Index a
PIKA T1/E1 (HMP) PCIe Board
iii
1Copyright Information
COPYRIGHTS
Copyright 2010 PIKA Technologies Inc.
TRADEMARKS
PIKA is a registered trademark of PIKA Technologies Inc. All other trademarks, product names and company names and/or logos
cited herein, if any, are the property of their respective holders.
DISCLAIMER
This document is provided to you for informational purposes only and is believed to be accurate as of the date of its publication,
and is subject to change without notice. PIKA Technologies Inc. assumes no responsibility for any errors or omissions in this
document and shall have no obligation to you as a result of having made this document available to you or based upon the
information it contains.
1 PIKA T1/E1 (HMP) PCIe Board
1
1
2Contacting PIKA Technologies
Customer Care
For support issues, phone or e-mail our Customer Care department at the following:
Tel: +1-613-591-1555
FAX: +1-613-591-9295
Email: [email protected]
International Headquarters
PIKA Technologies Inc.
535 Legget Drive, Suite 400
Ottawa, Ontario, Canada K2K 3B8
Tel: +1-613-591-1555
FAX: +1-613-591-9295
Email: [email protected]
Internet
Visit our website at www.pikatechnologies.com for the latest news, product announcements, downloads, online community,
documentation updates, and contact information.
PIKA T1/E1 (HMP) PCIe Board 2
2
2
3Preface
Organization
The document is divided into several sections, each of which covers a particular section of the PIKA Digital T1/E1 PCIe hardware.
Regulatory Warnings
Industry Canada (IC)
Equipment Attachment Limitations
NOTICE: The Industry Canada label identifies certified equipment. This certification means the equipment meets certain
telecommunications network protective, operational safety requirements. The department does not guarantee the equipment will
operate to the user’s satisfaction.
Before installing this equipment, users should ensure it is permissible to be connected to the facilities of the local
telecommunications company (Telco). The equipment must also be installed using an acceptable method of connection. The
customer should be aware that compliance with the above conditions might not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier. Any
repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company
cause to request the user to disconnect the equipment.
For their own protection, users should ensure the electrical ground connections of the power utility, telephone lines and internal
metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.
CAUTION: Users should not attempt to make such connections themselves, but should contact the appropriate electric
inspection authority, or electrician, as appropriate.
Federal Communications Commission (FCC)
This equipment complies with Part 68 of the Federal Communications Commission (FCC) rules for the United States.
A label is located on the solder side of the unit containing the FCC registration number. You must, upon request, provide the
following information to your local telephone company:
3 PIKA T1/E1 (HMP) PCIe Board
3
3
Facility Interface Code: 04DU9-BN/DN/1KN/1SN
Service Order Code: 6.0Y
USOC Jack Type: RJ48C
This equipment cannot be used on public coin phone service provided by the telephone company. Connection to party line service
is subject to state tariffs.
Your telephone company may discontinue your service if your equipment causes harm to the telephone network. They will notify
you in advance of disconnection, if possible. During notification, you will be informed of your right to file a complaint to the FCC.
Occasionally, your telephone company may make changes in its facilities, equipment, operation, or procedures that could affect the
operation of your equipment. If so, you will be given advance notice of the change to give you an opportunity to maintain
uninterrupted service.
3.1 Related Documentation
The following documents are related to the PIKA Digital T1/E1 PCIe Board Hardware Manual. These documents are linked
together and constitute the complete set of documentation for the AoH SDK product.
Software
PIKA HMP Low Level API Reference
PIKA HMP Low Level API Programmer's Guide
PIKA HMP Getting Started Guide
PIKA HMP Release Notes
PIKA T1/E1 (HMP) PCIe Board 3.1 Related Documentation
4
3
4Introduction
The PIKA Digital T1/E1 PCIe card provides a solution for voice and data applications with four spans available for use with T1 or
E1 connectivity (SW configurable). The card is part of the HMP family of PIKA cards; all digital signal processing is done on the
host processor.
The card supports several types of Telco central office switches and private branch exchanges (PBX).
Features
• Quad span
• Total bandwidth of up to 6.176 Mb/s in T1 mode and up to 8.192 Mb/s in E1 mode
• 8.192 MHz span-multiplexed local TDM bus (128 timeslots)
• Dual reference PLL for line clock referencing, control and monitoring
• Integrated support for PIKA Technologies’ AllOnHost architecture
• Host processing architecture enabling customers to benefit from market improvements in PCI and processor architectures
Interfaces
The Digital T1/E1 PCIe Board has a PCI Express 1.0a compliant host interface for installation in standard IBM x86 or compatible
computers. It also provides four digital line interfaces. The digital line interfaces are used to connect to Telco-provided T1 or E1
digital lines.
Part Number and Serial Number
Each board has a part number and a serial number label. The part number is in the form PN PIK-xxx-yyyyy and the serial number is
in the form SN PIK-xx-yyyyy.
4.1 Compliance
The Digital T1/E1 PCIe board is certified compliant for use in the United States, Canada, and European Union countries. The
following tables list approval information for EMC/EMI, Telecom, and Safety standards.
4.1 Compliance PIKA T1/E1 (HMP) PCIe Board
5
4
NOTE: The term self-declared indicates the card was tested by a third-party test facility, but does not require an official approval
number by a country or region’s approval standard authority. For the TBR21 Telecom specification, testing was
performed by an in-house test facility.
EMC/EMI
EMC/EMI standards govern the amount of electromagnetic interference and immunity of electrical devices. The following table
lists each country or region, its approval standard, registered approval numbers (if any), and a short description of the approval
standard.
Country /
Region Approval Standard Approval Number Approval Description
United States /
Canada
FCC Part 15, Subpart
D
Self-declared Rules for registration of telephone equipment.
Europe EN55022 Self-declared Limits and measurement of EM Emissions.
Europe EN55024 Self-declared Limits and measurement of EM Immunity.
Telecom
Telecom standards govern the necessary electrical signals and protocols of telecommunications devices. The following table lists
each country or region, its approval standard, registered approval numbers (if any), and a short description of the approval standard.
Country /
Region Approval Standard Approval Number Approval Description
United States FCC Part 68, Subpart D 6PR-DDNAN99XX82X Rules for registration of telephone equipment.
Canada CS-03 Issue 8 1689A-99XX82X
Europe TBR4 Self-declared Requirements for terminal equipment connecting to
ISDN service.
Safety
Safety standards govern the human safety of all electrical devices. The following table lists each country or region, its approval
standard, registered approval numbers (if any), and a short description of the approval standard.
PIKA T1/E1 (HMP) PCIe Board 4.1 Compliance
6
4
Indice
Manuali Scheda di rete popolari di altre marche
Buffalo
Buffalo AirStation WLI-PCM-L11GP Manuale utente
National Instruments
National Instruments NI 9234 Manuale utente
Hama
Hama 49276 Manuale utente
Linksys
Linksys WCF54G - Wireless-G Compact Flash Card Manuale operativo
Compaq
Compaq Wireless LAN 100 Manuale utente
Bose
Bose PowerMatch Dante Manuale utente