point ORBIT ONE Manuale utente
LDS Robotic Vacuum
Cleaner with Auto Dirt
Disposal and Mop
User Manual
CLEANING YOUR SPACE
Please read this manual carefully before use and keep it for reference.
LDS Robotic Vacuum Cleaner
with Auto Dirt Disposal
and Mop Washer
POINT Robotic Vacuum Cleaner.
Rydderer POINT-robotisk vakuum.
POINT robotdammsugare
POINT-robottipölynimurin.
POINT robotstøvsuger.
.
4 - 27
28 - 51
52 - 75
76 - 99
100 - 123
3
SAFETY PRECAUTIONS
WARNINGS (main body)
1. Do not use the appliance in or close to any wet places, such as a water
source or a bathroom.
2. Do not use the appliance to clean liquids, matches or wet waste.
3. To avoid fires, do not use the main body of the appliance to clean any
combustible liquidssuch as kerosene, or gasoline, any article with sparks, or
any combustible dust such as the carbon powder in toner cartridges, or use
the appliance close to anything above or in any flammable or explosive gas.
4. To avoid fires and/or injuries, do not disassemble, repair or refit the product
by yourself; however, you can replace the consumables as instructed in this
manual.
5. If the roller brush is found abnormal in use, please release the ON/OFF
button and check and remove any hair or any other long fiberstwined on the
roller brush in time.
6. The battery is a sealed device and is therefore safe in normal conditions.
Leakage of the liquid in it may cause irritation or burns. Please wash with
soapy water in the case of contact of skin with the liquid, or immediately
flush with water for 15 minutes at least and seek medical help in the case of
contact of eyes with the liquid.
7. The appliance is not suitable for children, people with reduced physical,
sensory or mental capabilities, or people without necessary experience or
knowledge. Their use of the appliance must be supervised.
8. Keep the appliance from electromagnetic devices in hospitals; keep children
from playing with the product; make sure the appliance is used with the
cleaning base station supplied with it;
Please read this manual before use.
To avoid personal injuries and property losses, please read the following
safety precautions carefully and abide by them. The safety precautions
include warnings and cautions, which are both significant contents about
safety in use.
Warnings are precautions for avoiding serious injuries or death in
operation.
Cautions are for avoiding minor injuries or product damage.
4
WARNINGS (cleaning base station)
9. Before discarding the appliance, power it off and take the battery pack
out of it with the correct tools: remove the screws on the bottom cover,
open the bottom cover, pull out the connection terminals of the battery
pack and take the battery out of the battery box. The waste battery pack
should not be thrown away but safely recycled.
10.
1. Do not pull the power plug with wet hands.
2.Do not use a damaged power plug or a loose power socket.
3.
In the case of long-time storage of the product, charging on a
monthly basis is recommended.
When using the cleaning base station, use an AC power supply with the
rated voltage. A generator or a DC power supply may cause fires and/or
electric shocks.
4.
appliance immediately to avoid smoke, fires and electric shocks.
7.
5.Insert the power plug fully to avoid electric shocks, short circuits and fires.
6.In the case of any faults
Remove the dust on the power plug with a dry cloth at
regular intervals to avoid fires due to poor insulation, etc.
, cut off the power supply and stop using the
If the appliance is abnormally hot, has a burning smell or sounds abnormal
during charging or usage, cut off its power supply and pull its power plug
immediately, put it in an open space away from combustibles and have it
safely replaced or repaired by a full-time maintenance person of the
manufacturer to avoid danger.
8.
9.
To avoid personal injuries and electric shocks, pull the power plug
from the power socket before cleaning or maintaining the appliance.
Do not put the main body or the power plug into water, or spray water onto
any of them.
10. Do not use any other power cable to charge the appliance.
11. When pulling the power plug, hold the insulated part of the cleaning base
station and do not pull the power cable.
12. To avoid electric shocks, do not use the cleaning base station when the
shell is damaged.
13. The cleaning base station only applies to the floor-mopping robots
designated by the manufacturer.
14. Before charging, please check whether the cleaning base station’s
specification is consistent with the supply voltage.
SAFETY PRECAUTIONS
5
CAUTIONS (main body /cleaning base station)
1. Do not use the appliance in an outdoor, non-overground or industrial place.
2.Do not use the appliance in an overhead space without a protective fence.
3.Do not block the air outlet, otherwise the main body of the appliance will
deform, fail or catch fire due to overheating.
4.
5.
Do not drag the appliance, otherwise the floor may be scratched.
To avoid personal injuries and product damage, do not wave the appliance
or have any young child play with it.
6.To avoid fires and electric shocks, do not drop the product, have it collide
with any other object or impose any pressure on it.
7. Do not use the appliance until its roller brush and filter have both been
correctly mounted, otherwise its cleaning performance can be affected.
8.
9.
Before charging, please check and make sure the charging cable of the
cleaning base station is in good condition.
Before use, please put the table, chairs, and other floor-type articles in
When in use, do not stand in front of the main body of the appliance,
order and put away any power cablesor small articleson the floor to
ensure smooth movement of the appliance.
10.Make the carpets flat to ensure smooth moving of the appliance.
11.
otherwise the main body will fail to identify the areas to clean.
such as an extreme temperature. It is suggested to store or use it in a dry
and
12.Do not store or use the appliance in any extreme adverse conditions,
cool indoor place with ambient temperature.
SAFETY PRECAUTIONS
6
PRODUCT INTRODUCTION
Cover plate buckle location
Laser radar sensor
Panel
Infrared receiving sensor
Function buttons
Bumper
Infrared window sensor
Dust box dismounting button
along-wall motion sensor
Reset button
Dust box
Air outlet
Charging contact (×2)
Infrared receiving sensor
Dust collection port
Carpet sensor
omni-directional wheel
Side brush
Cli sensor (4)
Roller brush box release button
Driving wheel (2)
Roller brush
Mop (2)
Directional wheel
MAIN BODY
Dust box
Partial cleaning button
If it is short pressed, the main body will get recharged automati-
cally after partial cleaning.
If short pressed in operation, the device will pause.
ON/OFF button
If it is short pressed, the device will get recharged automatically
after overall cleaning.
If it is long pressed, the device will get powered o.
Charging button
If it is short pressed in operation, the device will get back to
charge.
Function buttons
Dust box release buckle
Dust box filter
screen Dust inlet
7
Function buttons
Start/Pause
Recall
Mop
Automatic dust collection
Infrared lens
Power interface
Dust collection port
Charging contact (×2)
Sewage outlet
Top cover
Cleaning brush
Dust bag
Clean water tank
Sewage tank
Display
Guide pulley (×2)
infrared lens (×2)
cleaning tray
CLEANING BASE STATION
PRODUCT OPERATION
Step 2: Paste the mop in the pasting
area of the mop holder and
mount the mop holder
Subassembly.
Step 1: Dismount the stopper
protective sponges on two
sides of the bumper; stopper
into the groove on the bottom.
8
1. Avoid using this appliance in aroom with infants and pets, and keep away from
infants and pets to avoid danger.
2. In order to facilitate the robot to return to the cleaning base station after cleaning,
it is recommended that the robot start from the cleaning base station and the
cleaning base station is not moved during cleaning.
3. The cleaning base station has the functions of collecting dust, charging, cleaning
mop and air-drying mop. A new dust bag has been installed before packing.
4. Do not use the mop on carpet.
PRODUCT OPERATION
ATTENTION
Step 4: Take out the clean water
tank, remove the cover of
the clean water tank, put
the clean water tank after
adding water back to the
cleaning base station, and
cover the top cover of the
cleaning base station.
Step 3: Find a suitable place to place
the cleaning base station,
and ensure that the cleaning
base station is placed
horizontally.
power and pair the robot with the base station. You need to press the
"On/Off key + partial cleaning key" on the robot for 5 Seconds, and
the "Start key + recall key” on the base station for 5 Seconds. You will
have 1 minute to pair. After successful pairing, the mainframe is
Step 5: As the base station is shown in the picture below. Connect the
placed on the base station for charging.
Longer than 0.5 m
Longer than 1.5 m Water injection
Partial cleaning button
On/o button
Recharging button
Longer than
0.5 m
9
APP CONNECTION
Smart Life
1. Scan the QR code to
download the “Smart
Life” APP. Or search
for the "Smart Life"
APP in APP stores.
2. Click "Add Device", or
the "+" sign in the
upper right corner.
3. Select "Small Home
Appliances", then
click "Robot Vacuum
(Wi-Fi)".
4. Please make sure the
mobile phone is
connected to the
2.4GHz Wi-Fi network,
enter the Wi-Fi name
and password to log in,
then click "Next".
5. Please confirm the device is turned
on, press and hold " + " for 3
seconds at the same time, you will
hear the voice prompt "Wi-Fi has
reset", then start to flash, the
device is ready for connection, click
"Confirm the indicator is blinking".
6. Select “AP Mode”.
10
Indice
Altri manuali point Aspirapolvere
point
point DUSTY700 Manuale utente
point
point POPENCIL Manuale utente
point
point pro Series Manuale utente
point
point DUSTY500 Manuale utente
point
point POVC112BLKIT Manuale utente
point
point pro Series Manuale utente
point
point DUSTY300 Manuale utente
point
point pro Series Manuale utente
point
point POVCKIT Manuale utente
point
point POVCB50GR Manuale utente
point
point DUSTY700 Manuale utente
point
point POVC618DB Manuale utente
point
point pro Series Manuale utente
point
point pro Series Manuale utente
point
point DUSTY510WET Manuale utente
point
point pro Series Manuale utente
point
point pro Series Manuale utente
point
point PO42GR Manuale utente
point
point pro Series Manuale utente
