Powerware 9125 Manuale utente
Powerware®9125
User’s Guide
2500–3000 VA
www.powerware.com
Requesting a Declaration of Conformity
Units that are labeled with a CE mark comply with the following harmonized standards and EU directives:
:
Harmonized Standards: EN 50091-1-1 and EN 50091-2; IEC 950 Second Edition, Amendments A1, A2, A3, and A4
:
EU Directives: 73/23/EEC, Council Directive on equipment designed for use within certain voltage limits
93/68/EEC, Amending Directive 73/23/EEC
89/336/EEC, Council Directive relating to electromagnetic compatibility
92/31/EEC, Amending Directive 89/336/EEC relating to EMC
The EC Declaration of Conformity is available upon request for products with a CE mark. For copies of the EC
Declaration of Conformity, contact:
Powerware Corporation
Koskelontie 13
FIN-02920 Espoo
Finland
Phone: +358-9-452 661
Fax: +358-9-452 665 68
Powerware is a registered trademark and Fourth-Generation Online, Advanced Battery Management Plus (ABM Plus),
X-Slot, and ConnectUPS are trademarks of Powerware Corporation.
.
Copyright 2002 Powerware Corporation, Raleigh, NC, USA. All rights reserved. No part of this document may be
reproduced in any way without the express written approval of Powerware Corporation.
Class A EMC Statements
FCC Part 15
NOTE This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
ICES-003
This Class A Interference Causing Equipment meets all requirements of the Canadian Interference Causing Equipment
Regulations ICES-003.
Cet appareil numérique de la classe A respecte toutes les exigences du Reglement sur le matériel brouilleur du Canada.
EN50091-2
Some configurations are classified under EN50091-2 as “Class-A UPS for Unrestricted Sales Distribution.” For these
configurations, the following applies:
WARNING This is a Class A-UPS Product. In a domestic environment, this product may cause radio interference, in
which case, the user may be required to take additional measures.
Special Symbols
The following are examples of symbols used on the UPS to alert you to important information:
RISK OF ELECTRIC SHOCK - Indicates that a risk of electric shock is present and the
associated warning should be observed.
CAUTION: REFER TO OPERATOR’S MANUAL - Refer to your operator’s manual for
additional information, such as important operating and maintenance
instructions.
This symbol indicates that you should not discard the UPS or the UPS batteries
in the trash. The UPS may contain sealed, lead-acid batteries. Batteries must be
recycled.
i
Powerware®9125 User’s Guide (2500–3000 VA) :Rev B www.powerware.com
TABLE OF CONTENTS
1 Powerware 9125 – The Ultimate Online UPS! 1..........................
2 Safety Warnings 3.................................................
3 Installation 21.....................................................
Inspecting the Equipment 21........................................................
UPS Setup 21..................................................................
Rack-Mount Setup 22..........................................................
Tower Setup 23..............................................................
EBM Installation 27..............................................................
Plug-Receptacle UPS Installation 30..................................................
Hardwired UPS Installation 32......................................................
Remote Emergency Power-Off 36....................................................
UPS Rear Panels 38..............................................................
4 Operation 41......................................................
Turning the UPS On 41............................................................
Starting the UPS on Battery 41....................................................
Turning the UPS Off 41...........................................................
Initiating the Self-Test 42..........................................................
Operating Modes 42.............................................................
Normal Mode 43.............................................................
Battery Mode 44.............................................................
Bypass Mode 45..............................................................
Standby Mode 45.............................................................
Sleep Mode 45...............................................................
5 Configuration 47...................................................
Configuration Mode 47...........................................................
6 Additional UPS Features 51..........................................
X-Slot Cards 51.................................................................
Single-Port Card 52............................................................
Network Transient Protector 54.....................................................
Load Segments 55...............................................................
Table of Contents
ii Powerware®9125 User’s Guide (2500–3000 VA) :Rev B www.powerware.com
7 UPS Maintenance 57...............................................
UPS and Battery Care 57..........................................................
Storing the UPS and Batteries 57..................................................
When to Replace Batteries 57......................................................
Replacing Batteries 58............................................................
How to Replace Extended Battery Modules 58.........................................
How to Replace Internal Batteries 60...............................................
Testing New Batteries 61..........................................................
Recycling the Used Battery 62......................................................
8 Specifications 63..................................................
9 Troubleshooting 67.................................................
Audible Alarms and UPS Conditions 67................................................
Silencing an Audible Alarm 67....................................................
Service and Support 70...........................................................
1
Powerware®9125 User’s Guide (2500–3000 VA) :Rev B www.powerware.com
CHAPTER 1
POWERWARE 9125 – THE ULTIMATE ONLINE UPS!
The Powerware
9
9125 uninterruptible power system (UPS) protects
your sensitive electronic equipment from the most common power
problems including power failures, power sags, power surges,
brownouts, line noise, high voltage spikes, frequency variations,
switching transients, and harmonic distortion.
Power outages can occur when you least expect it and power quality can
be erratic. These power problems have the potential to corrupt critical
data, destroy unsaved work sessions, and damage hardware — causing
hours of lost productivity and expensive repairs.
With the Powerware 9125, you can safely eliminate the effects of power
disturbances and guard the integrity of your equipment. Figure 1 shows
the Powerware 9125 UPS with an optional Extended Battery Module
(EBM).
Figure 1. The Powerware 9125
Providing outstanding performance and reliability, the Powerware
9125’s unique benefits include the following:
:Fourth-Generation OnlineZdesign with pure sine wave output. The
UPS filters and regulates incoming AC power and provides consistent
power to your equipment without draining the battery.
:2U rack height conserves valuable rack space.
:Advanced Battery Management Plus (ABM PlusZ) doubles battery
service life, optimizes recharge time, and provides a warning before
the end of useful battery life.
Powerware 9125 –THE ULTIMATE ONLINE UPS!
2Powerware®9125 User’s Guide (2500–3000 VA) :Rev B www.powerware.com
:With the two-in-one form factor, you can use the UPS in a
rack-mount configuration or as a standalone cabinet.
:Hours of extended run time with up to four EBMs.
:Advanced power management with the Powerware Software Suite CD
for graceful shutdowns and power monitoring.
:Sequential shutdown and load management through separate
receptacle groups, called load segments.
:Hot-swappable batteries simplify maintenance by allowing you to
replace batteries safely without powering down the critical load.
:Network Transient Protector guards your network communications
equipment from surges. Low voltage models can also protect
modems, fax machines, or other telecommunications equipment.
:Emergency shutdown control through the Remote Emergency
Power-Off (REPO) port.
:Start-on-battery capability allows you to power up the UPS even if
utility power is not available.
:Optional X-SlotZcards provide enhanced communication
capabilities for increased power protection and control.
:Flash memory provides easy upgrades or reconfiguration capability
without requiring a service call.
:The Powerware 9125 is backed by worldwide agency approvals.
3
Powerware®9125 User’s Guide (2500–3000 VA) :Rev B www.powerware.com
CHAPTER 2
SAFETY WARNINGS
Read the following precautions before you install the UPS.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS. This manual contains important instructions that you
should follow during installation and maintenance of the UPS and batteries. Please
read all instructions before operating the equipment and save this manual for future
reference.
DANGER
This UPS contains LETHAL VOLTAGES. All repairs and service should be performed
by AUTHORIZED SERVICE PERSONNEL ONLY. There are NO USER
SERVICEABLE PARTS inside the UPS.
WARNING
:This UPS contains its own energy source (batteries). The output receptacles may
carry live voltage even when the UPS is not connected to an AC supply.
:Do not remove or unplug the input cord when the UPS is turned on. This removes
the safety ground from the UPS and the equipment connected to the UPS.
:To reduce the risk of fire or electric shock, install this UPS in a temperature and
humidity controlled, indoor environment, free of conductive contaminants. Ambient
temperature must not exceed 40C (104F). Do not operate near water or
excessive humidity (95% max).
:To comply with international standards and wiring regulations, the total equipment
connected to the output of this UPS must not have an earth leakage current
greater than 1.5 milliamperes.
:For UPS models with hardwired outputs, overcurrent protection for the output AC
circuit(s) is to be provided by others.
:For UPS models with hardwired outputs, suitably rated disconnect switches for the
output AC circuit(s) are to be provided by others.
Safety Warnings
4Powerware®9125 User’s Guide (2500–3000 VA) :Rev B www.powerware.com
CAUTION
:Batteries can present a risk of electrical shock or burn from high short-circuit
current. Observe proper precautions. Servicing should be performed by qualified
service personnel knowledgeable of batteries and required precautions. Keep
unauthorized personnel away from batteries.
:Proper disposal of batteries is required. Refer to your local codes for disposal
requirements.
:Never dispose of batteries in a fire. Batteries may explode when exposed to flame.
Sikkerhedsanvisninger
VIGTIGE SIKKERHEDSANVISNINGER
GEM DISSE ANVISNINGER
DENNE BRUGERVEJLEDNING INDEHOLDER VIGTIGE
SIKKERHEDSANVISNINGER
FARE
Denne UPS indeholder LIVSFARLIG HØJSPÆNDING. Alle reparationer og
vedligeholdelse bør kun udføres af en AUTORISERET SERVICETEKNIKER. Ingen af
UPS’ens indvendige dele kan repareres af brugeren.
ADVARSEL!
:Denne UPS indeholder egen energiforsyning (batterier). Udgangsnetstikkene kan
lede strøm, selv når UPS’en ikke er tilsat en AC-energikilde.
:Netledningen må ikke fjernes og stikket må ikke trækkes ud, mens UPS’en er
tændt. Dette fjerner sikkerhedsjorden fra UPS’en og fra det udstyr, der er sat til.
:Installér denne UPS i et temperatur- og fugtighedskontrolleret indendørsmiljø, frit
for ledende forureningsstoffer for at formindske risikoen for brand og elektrisk
stød. Rumtemperaturen må ikke overstige 40C. UPS’en bør ikke betjenes nær
vand eller høj fugtighed (maksimalt 95%).
:I overensstemmelse med internationale normer og bestemmelser for el-installation
må det udstyr, der er forbundet til udgangen af denne UPS, tilsammen ikke
overskride en jordafdelingsspænding på mere end 1,5 milliampere.
Altri manuali per 9125
5
Indice
Altri manuali Powerware UPS
Powerware
Powerware Prestige 6000 Guida all'installazione
Powerware
Powerware 9315 Manuale utente
Powerware
Powerware 9125 Manuale utente
Powerware
Powerware 9120 Manuale utente
Powerware
Powerware 5125 P33 Manuale utente
Powerware
Powerware PW5110 Manuale utente
Powerware
Powerware 9305 HS Series Manuale operativo
Powerware
Powerware 9305 Manuale operativo
Powerware
Powerware BPIV 30 kVA Manuale utente
Powerware
Powerware 9305 Manuale operativo
Powerware
Powerware 9330 Manuale utente
Powerware
Powerware 5110 Manuale utente
Powerware
Powerware 9125 Manuale utente
Powerware
Powerware 8 - 15 kVA Manuale utente
Powerware
Powerware UPS 1000 - 2200 Manuale utente
Powerware
Powerware 9395 Manuale utente
Powerware
Powerware 5115 RM Manuale utente
Powerware
Powerware 9315 Manuale utente
Powerware
Powerware 9170+ Manuale utente
Powerware
Powerware 5115 Manuale utente
Manuali UPS popolari di altre marche
Pylontech
Pylontech Victron & Pylontech US5000 Manuale utente
Tecnoware
Tecnoware EVO DSP PLUS MM 6.8 Manuale utente
Mecer
Mecer ME-1000-WTU Manuale utente
Mustek
Mustek PowerMust 530(B) Plus Manuale di installazione e funzionamento
Emerson
Emerson Liebert NXL series Manuale utente
MAKELSAN
MAKELSAN BOXER SERIES Manuale utente
