Pro-Ject Audio Systems Pro-Ject Head Box S Manuale utente

INSTRUCTIONS FOR USE

Pro-Ject Head Box S

Dear music lover,

thank you for purchasing a PRO-JECT AUDIO headphone amplifier.

In order to achieve maximum performance and reliability you should study these instructions for use carefully.

Warning of a hazard for the user, the unit or possible misuse.

Important notice.

Safety instructions

AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the

voltage in your area meets the voltage requirements printed on the power supply.

The power supply is used to disconnect the unit from the mains. Make sure that the power supply is easily

accessible at all times. Never handle the device, the power supply while your hands are wet or damp.

Avoid letting liquids enter the device or the power supply. Never place any item containing liquid,

such as a flower vase on or near the device. Never spill any liquid on the device or the power supply.

Never place any naked flame sources, such as lighted candles on or near the device. The product shall not

be used in damp or wet locations, next to a bathtub, sink, swimming pool or any other similar conditions.

Connections

Pro-Ject Audio Systems, Vienna, Austria

In Out

Right

LeftLeft Right 18V

Make all connections, except the connection to the headphone, whilst the unit is disconnected from

the power supply. Take care to connect the left and right channels correctly. The right channel is usually

marked red, the left channel black or white.

Please turn the volume level to minimum before connecting the headphone.

Minimum impedance of the head phone 30ohms.

Never use any other power supply than the one supplied with the unit.

Connection to the amplifier (recorder)

Connect the TAPE / RECORD OUT RCA/phono sockets from your amplifier to the In RCA/phono sockets of

the headphone amplifier. The Out RCA/phono sockets of the headphone amplifier can be connected to the

input sockets of your recorder.

Alternatively analog sources like CD player or tuner can be reconnected to the In RCA/phono sockets directly.

Connecting a headphone, volume control

Connect the headphones to the ¼“ (6,3mm ) jack socket on the front of the headphone amplifier. Use the

control knob to adjust the level to the required volume.

Headphone replay

Use the input selector of the amplifier to choose the source you wish to hear.

Mains power connection

Connect the low voltage plug from the power supply to the Power 18V "socket before connecting the

power supply to the mains.

To switch on from standby or to standby

The push button on the left hand side will toggle the unit between its fully operational status and standby. The

blue LED above the stand-by push button shows that the unit is switched on.

Technical specifications Pro-Ject Head Box S

Power output: 330mW/30ohms, 60mW/300ohms

Headphone connection: >30ohms

Signal to noise: 112dB (A weighted) at full output

Frequency response: 30Hz – 20kHz/-0,05dB (10Hz – 120kHz/-1dB)

THD (IMD): 0,003% (0,002%)

Gain: 11dB

Headphone jack: 3-pole ¼“ (6,3mm ) co-axial jack

Line-level output: 1 pair RCA/phono sockets

Outboard power supply: 18V/500mA DC, suitable for your country's mains supply

Power consumption: 100mA DC, <1W in standby

Dimensions W x H x D (D with sockets): 103 x 36 x 104 (109)mm

Weight: 600g without power supply

Potential incorrect use and fault conditions

No signal on one or both channels:

No connection between headphone and headphone amplifier ore amplifier. This could be due

to a faulty plug, broken wire or solder joint or simply loose plug/socket connection.

Headphone does not work:

Headphone volume control is at minimum.

Amplifier Tape-Monitor circuit is not activated.

Service

Should you encounter a problem which you are not able to alleviate or identify despite the above information,

please contact your dealer for further advice. Only when the problem cannot be resolved there should the

unit be sent to the responsible distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions

for use. Modification or change to any part of the product by unauthorized persons release the

manufacturer from any liability over and above the lawful rights of the customer.

PRO-JECT is a Registered Trademark of H. Lichtenegger.

This guide was produced by: Audio Trade GmbH

The information was correct at the time of going to

press. The manufacturer reserves the right to make

changes to the technical specification without prior

notice as deemed necessary to uphold the ongoing

process of technical development.

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Pro-Ject Audio Systems Amplificatore

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pro-Ject Head Box II Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Phono Box II Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Phono Box RS Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems DS2 Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Tube Box SE II Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Box S USB Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pro-Ject MaiA DS Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems DS2 Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems BOX-DESIGN Stereo Box DS2 Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Amp Box SE Mono Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Xpression II Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Remote Box S2 Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Phono Box SE II Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Record Box E Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Head Box SE II Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Amp Box Mono Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Tube Box DS Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Phono Box USB Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Record Box USB Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Phono Box II USB Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Box S USB Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pre Box S Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Tube Box DS Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Tube Box DS2 Manuale utente

Manuali Amplificatore popolari di altre marche

ASTRO

ASTRO HVO V40 P Manuale utente

Marantz

Marantz SUPERSCOPE BLA-545 Istruzioni per il montaggio

NAD

NAD CI980 Manuale utente

Technics

Technics SE-CH770 Manuale utente

Harman Kardon

Harman Kardon HK6300 Manuale utente

NAD

NAD T975 Manuale utente

McIntosh

McIntosh MA6850 Manuale utente

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Manuale utente

Viatron

Viatron Autrix Manuale utente

GME

GME GA9800 Manuale utente

Atlas

Atlas CP700 Manuale utente

Roland

Roland KC-1000 Manuale utente

Pyle

Pyle PFMRA350BW Manuale utente

Advantage

Advantage S-250 Manuale utente

IRT Electronics

IRT Electronics DVA-3007 Manuale utente

Dimavery

Dimavery BA-100 Series Manuale utente

Sony

Sony XM-S400D Manuale utente

Schertler

Schertler ROY X Manuale utente