Pro-Ject Audio Systems Primary E Phono Manuale utente

INSTRUCTIONS FOR USE

Pro-Ject Primary E Phono

Primary E Phono

Controls, features and connections

(1) Power switch

(2) Stepped drive pulley and drive belt *

(3) Platter with felt mat *

(4) Tonearm counterweight

(5) Tonearm lift lever

(6) Tonearm rest and removable transport lock

(7) Tonearm tube

(8) Headshell with finger lift and pre-mounted Ortofon OM

(9) Lid

(10) Lid hinge

(11) Hinge fasteners

(12) Power supply socket

(13) Switch between Phono and Line output

(14) Phono output socket with earth connection

Allen key 1.5mm (not shown)*

Single adapter (not shown)*

Connection cable (not shown)*

Power supply (not shown)*

Dear Music Lover,

Congratulations and thank you for choosing Pro-Ject Audio Systems record player.

Your Primary E Phono turntable has been handcrafted and rigorously tested by skilled technicians

to give you years of enjoyable, trouble free service.

Please contact your dealer if you require additional assistance.

Important:

Your turntable was shipped partially disassembled in order to avoid damage to sensitive parts.

Please check immediately to make sure that neither the packaging nor the device was damaged in

transit. If you are missing parts or if the unit is damaged, please do not operate and contact your

dealer.

Safety instructions

The power supply is used to connect and disconnect the unit from the mains. Make sure that the

plug is easily accessible at all times.

Hold the plug when unplugging the power cord. Never

handle the power cord while your hands are wet or damp.

Avoid letting liquids enter the device. Never place any item containing liquid, like a flower vase,

on or near the device. Never spill any liquid on the device. Never place any naked flame sources,

like lighted candles, on or near the device. The product shall not be used in damp or wet locations,

ne t to a bathtub, sink, swimming pool or any other similar conditions.

Keep plastic bags away from children to prevent any risk of suffocation.

Platter and drive belt installation

Please remove brown paper insert which holds the platter in transport position. Put the felt mat on the

top of the platter. Install the drive belt as shown in the following illustration.

Cartridge downforce adjustment

The counterweight (8) supplied is suitable for cartridges weighing between 3 - 7g (weight no. 81). The

counterweight is pre-set perfectly from the factory.

In case you need to set the tracking force, please read following instructions:

Place the stylus pressure gauge onto the platter

To adjust the amount of pressure, carefully move the

counterweight along the support rod, until the stylus pressure is sufficient to raise the pressure gauge

to the level position. Moving the counterweight away from the cartridge will reduce pressure and

towards will increase pressure. Finally secure the counterweight using hexagonal key provided.

If the stylus gauge becomes level, then the correct pressure has been achieved. However if the there is

insufficient or excessive pressure the gauge will either not move or tilt down.

Connection to the amplifier

The record player has gold plated female RCA phono sockets (14) and possibility to choose between

PHONO and LINE output. With LINE OUT on, you can use a line input (such as AUX, CD, Tuner, Tape or

Video) on your amplifier. With PHONO OUT on, you can use your own PHONO Pre-amplifier (sometimes

labelled gram, disc or RIAA).

Take care to connect the left and right channels correctly. The right channel is usually marked red, the

left channel black or white. Check the manual supplied with your amplifier for relevant information.

The earthing wire of the tonearm lead should be connected to the earth terminal on your amplifier (if

provided).

For detailed product information regarding Pro-Ject Audio Phono amplifiers please refer to the Pro-

Ject web site www.project-audio.com.

The recommended load impedance for the factory fitted cartridge is: 47kohms MM input

Mains power connection

The turntable is supplied with the universal power supply with 3 exchangeable sockets adapters

suitable for all countries. Select the correct adapter for your country and insert the adapter to the

exchangeable part of the power supply.

Connect the low voltage plug from the power supply to the socket (13) on the rear of the record

player before connecting the power supply to the mains.

Fitting the lid

Fit the lid (dust cover) carefully over the hinge prongs and adjust the screws (9) until the lid stays open

where you want it to without being too stiff to open or close.

Switching on and off

Pressing the power switch (1) alternately starts or stops the motor.

Changing replay speed

Put the belt over the larger diameter part of the motor pulley (2). To revert to 33 r.p.m. repeat the

proceedings using the smaller step on the pulley.

Maintenance and cleaning

Your record player requires little or no regular maintenance. Remove dust with a slightly moistened

antistatic cloth. Never use a dry cloth because this will create static electricity which attract more dust!

Antistatic cleaning fluids are available at specialist stores but must be applied sparingly to avoid

damage to rubber parts. It is recommended to fit the needle cover before cleaning or maintenance is

carried out to avoid damage.

If the player is not used over a long period of time the drive belt can be removed to prevent unequal

stretching.

Fitting and connecting the cartridge

All cartridges with half inch mounting holes can be mounted. Leave the needle's protection cover on,

fit the cartridge to the headshell by using the supplied screws by passing one screw through each slot

in the headshell (8). Do not tighten the nuts yet.

Connect the tonearm wires with the cartridge pins as follows:

white left channel positive (L+)

red right channel positive (R+)

green right channel return (R -)

blue left channel return (L -)

The full sound quality of the record player can only be achieved if the cartridge is adjusted correctly.

Particular tools like the Pro-Ject Audio Systems alignment tool are required to accomplish this job properly.

If you are not well acquainted with the adjustment of cartridges, please call for the willing help of your

Pro-Ject Audio Systems dealer.

Please note: adjusting a cartridge and tonearm calls for the greatest care in order to avoid

damaging the cartridge or tonearm bearings. Ask your local dealer for help if you are unsure in

any of the necessary steps and precautions which must be taken.

Useful tips

The record player should be positioned on a low-resonance surface such as wood or multiple layer ply

board to avoid structural vibrations disturbing replay.

Technical specifications Pro Ject Primary E Phono / Pro Ject 8.6E

Nominal speeds 33 45 r.p.m.

Speed variance 33: 0,80% 45: 0,70%

Wow and flutter 33: 0,29% 45: 0,27%

Signal to noise -65dB

Effective tonearm mass

Effective tonearm length 8,6" (218,5mm)

Overhang 22mm

Power consumption 4.5W

Power cord suitable for your country's mains supply (EU, UK, US, AUS)

Dimensions (W x H x D) 420 x 112 x 330mm (WxHxD)

Weight 4.0kg

Technical specifications MM Cartridge Ortofon OM

Frequency range 20-22.000Hz

Channel separation 20dB 1kHz

Output voltage 4.5mV

Recommended load

impedance

47kohms amplifier connection – MM-input

Compliance stylus type 20µm mN – Spherical

Recommended tracking force 17.5mN

Weight 5g

Technical specifications moving magnet phono pre-amplifier

Gain 32dB

Output voltage typically 200mV 1kHz at 5mV 1kHz input

Input impedance 47kohms 100pF

Noise floor -68dB

RIAA-equalisation curve accuracy

20Hz-20kHz max. 0,5dB

Potential incorrect use and fault conditions

Pro-Ject turntables are manufactured to the highest standards and undergo strict quality controls

before leaving the factory. Faults that may possibly occur are not necessarily due to material or

production faults but can sometimes be caused by incorrect use or unfortunate circumstances. Therefore

the following list of common fault symptoms is included.

The platter doesn't turn although the unit is switched on:

The unit is not connected to the mains power supply.

No mains at the socket.

Drive belt is not fitted or has slipped off.

No signal through one or other channel or both channels:

No signal contact from the cartridge to the internal tonearm wiring or from that to the arm lead or

from that to the phono box or between that and the amplifier. This could be due to a faulty plug,

broken wire or solder joint or simply loose plug socket connection.

Phono input not selected at amplifier.

Amplifier not switched on.

Amplifier or speakers is defective or muted.

No connection to the loudspeakers.

Strong hum on phono input:

No earth connection from cartridge or arm or arm cable to amplifier, or earth loop.

Distorted or inconsistent sound from one or both channels:

Record player is connected to wrong input of amplifier, or MM MC switch incorrectly set.

Needle or cantilever damaged.

Wrong r.p.m., drive belt is overstretched or dirty, platter bearing without oil, dirty or damaged.

Service

Should you encounter a problem which you are not able to alleviate or identify despite the above

information, please contact your dealer for further advice. Only when the problem cannot be resolved

there should the unit be sent to the responsible distributor in your country.

Guarantee repairs will only be effected if the unit is returned correctly packaged. For this reason we

recommend keeping the original packaging.

Never return a record player without making sure that is it safely disassembled and correctly packaged

in the original packaging according to the diagrams on the last page of this user guide.

Fit the cartridge protection cap and the transport lock for the tonearm tube (66), prior to carefully

packaging the record player.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these

instructions for use and/or by transportation without the original packaging. Modification or

change to any part of the product by unauthorized persons, release the manufacturer from any

liability over and above the lawful rights of the customer.

Pro-Ject Audio Systems is a Registered Trademark of

H. Lichtenegger.

This guide was produced by: Pro-Ject Audio

Systems Copyright

The information was correct at the time of going

to press. The manufacturer reserves the right to

make changes to the technical specification

without prior notice as deemed necessary to

uphold the ongoing process of technical

development.

Indice

Altri manuali Pro-Ject Audio Systems Giradischi

Pro-Ject Audio Systems

Pro-Ject Audio Systems 6 PerspeX Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Speed Box MK II Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Xtension Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems T1 Phono SB Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pro-Ject RPM 10 Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems SIGNATURE 10 Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Xtension 12 Evolution Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems 2 Xperience Basic + Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems RPM 10.1 Evolution Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems RPM 1.3 Genie Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Debut PRO Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Pro-Ject DEBUT III PHONO SB Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems 2 Xperience Basic + Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Xtension Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems 2 xperience sb s Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems 1 Xpression Carbon Classic Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Debut III Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems RPM 9.2 Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems T2 W Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Debut Carbon Phono/USB Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Juke Box Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Debut Carbon DC Esprit SB Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems Elemental Manuale utente

Pro-Ject Audio Systems

Pro-Ject Audio Systems T1 Phono SB Manuale utente

Manuali Giradischi popolari di altre marche

Gemini

Gemini CDT-05 MKII Manuale utente

Rotel

Rotel RP-820 Manuale utente

Shuman

Shuman MC-250BT Manuale utente

Stanton

Stanton STR8-150 Manuale utente

Audio Technica

Audio Technica AT-LPW40WN Manuale utente

Crosley

Crosley McQueen CR7011-GY Manuale utente

Reloop

Reloop SMP-1 Manuale utente

auna

auna TT-Classic Plus Manuale utente

COMO AUDIO

COMO AUDIO Turntable Analog Manuale utente

Dual

Dual 1009 F Manuale utente

REED

REED Muse3C Manuale utente

AXIOMTEK

AXIOMTEK OPS883-H Series Manuale utente

Pioneer

Pioneer PL-71 Manuale utente

Vestax

Vestax PDX-a1 Manuale utente

Denon

Denon DP-400 Manuale utente

Dual

Dual 504 Manuale utente

Audio-Techica

Audio-Techica AT-LP60XBT Manuale utente

Goldring

Goldring G99 Manuale utente