4
Note:
Only one 4-pole cable is
required to connect 2-channel
configurations of several M10 and
SW12 and SW18 subwoofers.
Only one 4-pole cable is required
to connect two e.g. monitor paths
elegantly without additional
reversible cables.
Description:
The M10 is a compact 2-way monitor speaker with a built-in
passive frequency crossover.
It is equipped with a 10“ cone chassis with a water-repellent
coating and a 1“ high-frequency driver.
The directivity characteristic is 60 x 90 degrees (h x v).
This loudspeaker is to be used exclusively with the
ProAudio Technology system amplifiers.
Different setups enable a practice-oriented usage with or without
SW12 and SW18 subwoofers.
Alternatively amplifiers of the Hoellstern DELTA series with built-in
DSP may be used.
Should you have any questions, please contact
ProAudio Technology regarding this subject.
Cabinet:
The cabinet is made of 15 mm birch multiply wood and coated
with a robust 2-component texture paint finish.
Two handles and four stacking feet are standard.
A water-repellent, black acoustic foam has been placed behind
the front grille.
Connection:
The connections are made on the rear side through a total of four
Neutrik NL4 SpeakON sockets which are angled in two directions
by 45 degrees relative to the rear cabinet wall.
Three of the four sockets are wired in parallel with each other.
Pin pair 1 is connected to the speaker chassis.
On the fourth SpeakON socket, which is marked correspondingly
and rotated by 180 degrees, the pins are reversed. Pin pair 2 is
connected to the speaker.
Combinations of M10 and subwoofers, which are fed via a 4-
pole lead, must be connected only to the non-marked SpeakON
sockets!
Never use the marked SpeakON socket that is arranged rotated
by 180 degrees.
Operation on System Amplifiers:
The amplifier configuration software will display help texts for the
individual loudspeakers. Select a setup which contains the name
“M10“.
On the DELTA6.2-DSP system amplifier a maximum of eight M10
can be driven per channel.
On the DELTA8.4-DSP system amplifier a maximum of four M10
can be driven per channel.
On the DELTA14.4-DSP system amplifier a maximum of eight M10
can be driven per channel.
Details will be shown by the software upon entering the number
of M10 speakers per channel.
Note:
Use the M10 monitor speaker
exclusively on system amplifiers
with the available setups.
Otherwise there will be a risk
of damage and inadequate
performance.
