PF3100 Ion Pilot Card Product Manual
PROFIRE
1.855.776.3473
solutions@profireenergy.com Page 10 of 12
6. Enclosure Specifications
The Ion Pilot card is mounted in the EPX enclosure
Top Width 11.7cm (4.61 inches)
Base Width 16.8cm (6.63 inches)
Height 21.7cm (8.53 inches)
Depth 13.3cm (5.25 inches)
Class I, Div 1, GRP BCD, Type 4x; Class I, Zone 1, Aex d IIB + H2 T6
Gb; Ex db IIB + H2 T6 Gb, IECEx
7. Instructions for Use
The Ion Pilot card is designed to be used with the PF3101-00 BMS controller card as part of the PF3100 platform.
Operation
Operating controls and their uses are described under “Terminal Descriptions” above.
8. Preventative Maintenance & Inspection
In order to ensure that the Ion Pilot card works correctly and efficiently, the following maintenance and
inspection procedures should be followed:
➢Ensure that all wires are connected correctly.
➢Minimize copper wire exposure.
➢Check for corrosion and ensure that no wires are frayed or worn, and all insulation is intact.
➢Confirm no moisture or condensation is apparent on the board or in the enclosure.
➢Ensure that the board does not show any sign of mechanical damage (e.g. –damage from an impact such as
dropping an item).
➢Check that the board does not show any sign of electrical damage (components should not be burnt or
damaged in any way).
➢Confirm that the temperature of the board is within ambient temperature operating limits.
➢Check that the enclosure is secured and that the device is not subject to excessive vibration.
➢Routine inspections of all equipment should be performed. If any abnormality is found, corrective actions
should be taken. If the abnormality cannot be corrected, contact PROFIRE.
➢A qualified technician should perform any tests necessary to confirm that the equipment is still in a safe
condition.
oEnsure power LED is lit (blue)
