7 8
Camera ID – Selecting camera
Pan/tilt speed
Home Point
Line Scan
Presets
When powered on, the display will mark the camera’s ID A001,
Example - “ A001”
“A“ = Represents the cameras ID address, means it shows you that
current camera being controlled is #001.
To change camera press CAM on the remote,
If the camera number is higher than 9, press the -/-- button,
And write the camera number.
Example: CAM - -/-- - 9 - 0 - ENTER - To select camera
number 90.
You can control the speed of pan/tilt movement.
When pressing SPEED on the remote, the display shows “S-63”.
S=Speed, 63 speed value, you can change the value between 1 to
63, when 63 is the fastest.
To change the speed:
- Press SPEED button and then a number between 1 to 63.
- When using a value higher then 9, press the -/-- button,
and write the camera number.
- Press ENTER to confirm.
To set a preset:
- Press and hold PRESET button for 3 second or until display
shows “SET“
- Enter a number between 1-9, if you want to use higher number
then 9, Press the -/-- button after pressing PRESET
- After typing a number press “ENTER” to confirm.
Example: PRESET - -/-- - 1 - 5 - ENTER - To set preset 15.
To switch between presets press SHOT, Then press the desired
preset number.
To move to the preset you programmed
- Press SHOT on the remote and then the desired preset number.
- If you want to use higher number then 9, Press the -/-- button after
pressing SHOT.
Example To call preset 15 SHOT - -/-- - 1 - 5.
When pressing HOME on the remote control the display shows
HOME
You can set a home point preset, so that when you press HOME
on the remote control, the camera will move to your pre-selected
home point from any position she is in.
To set a home point:
- Move the camera to desired location.
- Press and hold PRESET button on the remote control.
When the display shows “SET“, press HOME.
You can set 2 points for the camera to perform a scan between them.
These two points are Aand Bon the remote control.
When pressing Aon the remote- display shows “LF-A”
When pressing Bon the remote- display shows “LF-B”
To set the left/right limits:
- Set the camera to the desired location.
- Press and hold PRESET button for 3 seconds until display shows
“SET“.
