Pulsar Y302 Manuale utente

ENGLISH

CAL. Y301, Y302

SUPER ACCURATE ANALOGUE WATCHES

Y301

●3 hands without calendar

●Accuracy :±10 seconds/year

Y302

●3 hands with date calendar

●Accuracy :±20 seconds/year

English

■SCREW DOWN CROWN [for models with screw down crown]

1Turn Crown counterclockwise until you no

longer feel the threads turning.

2Crown can be pulled out.

Unlocking the crown

1Push Crown back in to normal position.

2Turn Crown clockwise while pressing it lightly

until tight.

Locking the crown

* When using the watch in water:

Before using the watch in water, be sure the crown is screwed in completely.

Do not operate the crown when the watch is wet or in water.

English

TIME SETTING FOR CAL. Y301

CROWN

1Pull out when Second hand points at 12

o’clock.

2Turn in the desired direction to set the

time.

3Push back in to normal position in

accordance with a time signal.

TIME/CALENDAR SETTING FOR CAL. Y302

CROWN

1Pull out to the first click.

2Turn until the previous day’s date

appears in the calendar frame.

3PullouttothesecondclickwhenSecond

hand points at 12 o’clock.

English

4Turn until the desired date appears.

*Turn Crown to advance Hour and Minute hands.

5Turn in the desired direction to set the time.

6Push back in to normal position in accordance with a time signal.

NOTES:

1 Do not set the date between 9:00 p.m. and 1:00 a.m. Otherwise, it may not

change properly.

* If it is necessary to set the date during that time period, first change the time

to any time outside it, set the date and then reset the correct time.

2 When setting Hour hand, check that AM/PM is correctly set.

* The watch is so designed that the date changes once in 24 hours. Turn the

hands past the 12 o’clock marker to determine whether the watch is set for

the A.M. or P.M. period. If the date changes, the time is set for the A.M.

period. If the date does not change, the time is set for the P.M. period.

3 When setting Minute hand, first advance it 4 to 5 minutes ahead of the desired

time and then turn it back to the exact minute.

4 It is necessary to adjust the date at the end of February and 30-day months.

English

Battery life : Approx. 3 years

Battery : SEIKO SR716SW

●

As the battery is inserted at the factory to check the function and performance of

the watch, its actual life once in your possession may be less than the specified

period.

●

When the battery expires, be sure to replace it as soon as possible to prevent any

malfunction.

●

We recommend that you contact an AUTHORIZED PULSAR DEALER for battery

replacement.

Years

WARNING

●Do not remove the battery from the watch.

●If it is necessary to take out the battery, keep it out of the reach of

children. If a child swallows it, consult a doctor immediately.

●Never short-circuit, tamper with or heat the battery, and never expose

it to fire. The battery may burst, become very hot or catch fire.

English

CAUTION

●The battery is not rechargeable. Never attempt to recharge it, as this

may cause battery leakage or damage to the battery.

●Loss/gain in normal temperatures of between 5°C ~ 35°C (41°F ~ 95°F).

Annual rate : Approximately 10 seconds (Cal. Y301) / 20 seconds (Cal.

Y302) when used on the wrist approximately 12 hours a

day.

Monthly rate :±2 seconds (Cal. Y301) / ±4 seconds (Cal. Y302)

depending on the manner in which the watch is used.

●Note on annual rate:

Annual rate is not an aggregate of monthly loss/gain that accumulates in a

English

year. The amount of loss/gain fluctuates depending on the condition of use

as shown in the figure below. Annual rate specifies the range of loss/gain

that is never exceeded at any given time of a year.

+ 5

+ 10

– 5

– 10

(sec.)

Gain

Loss

(Ex. 2)

(Ex. 3) (Ex. 1)

A1A2

(month)

121110

65432

* None of A

, A

, B

and B

will exceed 10 seconds.

Examples of monthly fluctuations of loss/gain:

In case of a watch with the yearly loss/gain of 10 seconds

NOTE:

To maintain the accuracy of the watch, it is recommended that it be kept in a

temperature range between 5

C and 35

C when it is not worn on the wrist.

English

WATER RESISTANCE

●Non-water resistant

• If the watch becomes wet, have it checked by an AUTHORIZED

PULSAR DEALER or SERVICE CENTER.

●Water resistant 5/10/15/20 bar

• Before using in water, be sure the crown is pushed in completely.

• Do not operate the crown when the watch is wet or in water.

If used in sea water, rinse the watch in fresh water and dry it

completely.

• When taking a shower with the water resistant 5 bar watch, or

taking a bath with the water resistant 10, 15 or 20 bar watch, be

sure to observe the following:

* Do not operate the crown when the watch is wet with soapy water

or shampoo.

* If the watch is left in warm water, a slight time loss or gain may

be caused. This condition, however, will be corrected when the

watch returns to normal temperature.

10/15/20

bar WR

5 bar WR

English

* Pressure in bar is a test pressure and should not be considered as corresponding

to actual diving depth since swimming movement tends to increase the pressure

at a given depth. Care should also be taken on diving into water.

** We recommend that you wear a PULSAR Diver’s Watch for scuba diving.

TEMPERATURES

+60°C

-10°C

MAGNETISM

The watch will be

adversely affected by

strong magnetism. Keep

it away from close contact

with magnetic objects.

Temperatures over 60°C or 140°F

may cause battery leakage or shorten

the battery life.

Do not leave your watch in very low

temperatures below –10°C or +14°

F for a long time since the cold may

cause a slight time loss or gain.

However, the above conditions will

be corrected when the watch returns

to normal temperature.

Normal accuracy will return if the watch

is moved away from the magnetic field.

CARE OF CASE AND BRACELET

To prevent possible

rusting of the case and

bracelet caused by dust,

moisture and perspiration,

wipe them periodically

with a soft dry cloth.

Your watch works with

stable accuracy within a

temperature range of 5°

C and 35°C (41°F and

95°F).

English

SHOCKS & VIBRATION

Light activities will not

affect your watch, but be

careful not to drop your

watch or hit it against hard

surfaces, as this may

cause damage.

PERIODIC CHECK

It is recommended that the

watch be checked once

every 2 to 3 years. Have

your watch checked by an

AUTHORIZED PULSAR

2 - 3

Years

CHEMICALS

Be careful not to expose

the watch to solvents,

mercury, cosmetic spray,

detergents, adhesives or

paints. Otherwise, the

PRECAUTION REGARDING

CASE BACK PROTECTIVE FILM

case, bracelet, etc. may become

discolored, deteriorated or damaged.

DEALER or SERVICE CENTER to

ensure that the case, crown, gasket

and crystal seal remain intact.

If your watch has a

protective film and/or a

sticker on the case back,

be sure to peel them off

before using your watch.

Questo manuale è adatto per i seguenti modelli

Indice

Manuali Orologio popolari di altre marche

Pandora

Pandora WATCH2 Manuale utente

Casio

Casio QW-4343 Manuale utente

Suunto

Suunto X6 Manuale utente

Seiko

Seiko N830 Manuale utente

MotionX

MotionX 365 Manuale utente

Garmin

Garmin VENU SQ 2 Manuale utente

QCY

QCY Watch GTC Manuale utente

Canyon

Canyon Cindy CNE-KW41WP Manuale utente

Esq

Esq Watches Guida all'installazione

Crane

Crane AA5-CDSM-3A Manuale utente

Timex

Timex W-214 Manuale utente

DETOMASO

DETOMASO MATERA Manuale utente

Geemarc

Geemarc Watch N Shake Manuale utente

LORUS

LORUS W590 Manuale utente

STENLILLE

STENLILLE Actío Manuale utente

Casio

Casio 5594 Manuale utente

Sinn

Sinn HUNTER'S WATCH 3. Edition Manuale utente

Slazenger

Slazenger SLZ800 Manuale utente