12. If reduction in backwash flow is observed, repeat steps 5 through 10 until
backwash operates normally.
13. Finally, fully open a cold-water fixture and insure service flow is adequate.
14. If a reduction in service flow is observed, repeat steps 5 through 10 until
household service flow is normal.
15. With backwash and service flow adequate, set time of day on the control
valve by using the up and down buttons. Installation and verification are
complete.
Notes:
A. Check static (no water flowing) water pressure in pounds per
square inch (psi) using an accurate gauge, as close to the water
main as possible. Water pressure less than 40 psi may present
problems with the Healthy Home service flow, and compromising
the backwashing capability of the system.
B. Any addition to household plumbing can cause a drop in pressure
and/or flow rates. Great care has been taken in the design of the
Healthy Home to minimize these affects.
