Qlogic QLogic 12000 Series Manuale utente

[Quick Start Guide ]

QUICK START GUIDE

INFINIBAND SWITCH INSTALLATION

QLogic 12000 Series

Purchasers of OEM products should consult with the OEM for support.

Support Headquarters QLogic Corporation

4601 Dean Lakes Blvd

Shakopee, MN 55379

QLogic Web Site www.qlogic.com

Technical Support Web Site support.qlogic.com

Technical Support Email support@qlogic.com

Technical Training Email tech.training@qlogic.com

Support phone numbers are available in the

Contact Support area of the QLogic support

website:

support.qlogic.com

QLogic 12000

Quick Start Guide

Installation Instructions

This guide describes the steps to install and activate a 12000-series InfiniBand switch. For detailed instructions, refer

to the QLogic 12000 Hardware Installation Guide.

Step 1. Check the Packing List

Verifyallorderedequipmenthasbeenreceived.The12000switchesshipwithallcomponentspre-installed.Thefollowing

table lists the maximum configuration of installed components for each switch:

Step 2. Mount the Switch

Installapplicablerackmounting hardwareand switchinastandard19"rack asdescribedinthe QLogic12000Hardware

Installation Guide.

Table 1. 12000-Series Components

Component 12200 12300 12800-040 12800-180 12800-360

Fans N/A N/A 4 Intake 5 Intake

3 Exhaust 10 Intake

10 Exhaust

Power Supplies

or Blank Fillers N/A 2

Power/Fanunits 4 6 12

IBLeafModules/

Blanks N/A N/A 4 18 36

Spine Modules/

Blanks N/A N/A 159

Management

Modules/

Blanks

N/A N/A 222

Hardware

Installation kit

(mounting rails,

etc.)

11111

DB-9 to RJ-11

adapter N/A N/A 222

RJ-11 Serial

cable 1 (Managed

only) 1222

Power Cords 2 2 4 6 12

Step 3. Apply Power to the Switch

❑Attach the AC power cord(s) to the switch and wall outlets or power strips.

❑When the switch is plugged into an AC power outlet:

❑The system powers up.

❑The fans start.

❑The switch, power supply, and fan LEDs light up.

NOTE: For the 12800 switches, make certain the DC On switch is illuminated. If it is not, press

the button to supply power.

Step 4. Connect Cables

❑Connecta Category5or6(Cat5/6)Ethernetcableto theRJ-45connector(s)on theswitch.Connecttheother

end of the Cat 5/6 to the OOB LAN workstation or Ethernet switch.

❑Connect a DB-9 to RJ-11 adapter to each RJ-11 cable.

❑Connect an RJ-11 cable to each serial port on the switch.

❑Connect the switch to IB-enabled hosts using QSFP IB copper or fiber-optic cables.

Step 5. Change the Default System IP Address and Gateway IP Address

ChangethedefaultsystemIPaddress(192.168.100.9)andgatewayIPaddress(255.255.255.0)asdetailedintheQLogic

12000 Hardware Installation Guide. Obtain the new IP address and subnet mask from a network administrator.

Step 6. Add equipment to the network

QLogic Service Initiation

Included with the purchase ofa QLogic switch is a one year service plan. To activate the service plan register at

http://servicereg.qlogic.com.

By registering, QLogic technical support can quickly provide assistance with product-related questions. QLogic or its

authorized service provider handles all aspects of technical support for the switch.

To initiate the service plan, please register at http://servicereg.qlogic.com where you will submit:

❑Company Name and Address

❑Contact Information

❑Serial Number of your switch

❑Company you purchased the service plan from

After registering, you will receive an email within 5 business days that confirms your service contract, and terms and

conditions.

To upgrade your service plan to include comprehensive break/fix support or to lock in prices with a 3 year contract,

contact your reseller, or call QLogic at 1-800-662-4471 or 1-949-389-6000.

Obtaining Software and Documentation

To obtain QLogic 12000 software and documentation, go the QLogic.com Downloads page at

http://driverdownloads.qlogic.com/QLogicDriverDownloads_UI/default.aspx.

Figure 1. QLogic.com Downloads Page

Switch-Based QLogic Fabric Manager License Key

Certain packagesof the InfiniBand Fabric Suite entitlethe user to the switch-based QLogicFabric Manager. Refer to the

licensing documentation that comes with the InfiniBand Fabric Suite for instructions on generating the license key.

Figure 2. InfiniBand Fabric Suite Licensing Information

For detailed license key activation information, refer to the QLogic 12000 Hardware Installation Guide.

China RoHS Electronic Information

Table 2. China RoHS

Part Name * Toxic and Hazardous Substances and Elements

Lead

(Pb)

Mercury

(Hg)

Cadmium

(Cd)

Hexavalent

Chromium

(Cr6+)

Polybrominated

Biphenyls

(PBB)

Polybrominated

dipheny ethers

(PBDE)

Printed circuit assembly X 0 0 0 0 0

Internal power supply unit X 0 0 0 0 0

Fan X 0 0 0 0 0

AC power inlet X 0 0 0 0 0

Cable and connector assemblies 0 0 0 0 0 0

Power cord 0 0 0 0 0 0

Enclosure and fasteners 0 0 0 0 0 0

EMI gasket 0 0 0 0 0 0

Optics module 0 0 0 0 0 0

Adapter unit 0 0 0 0 0 0

Mounting rails 0 0 0 0 0 0

* If the listed part is present in this product, then the substances are as identified

in this table.

"0" indicates the hazardous and toxic substance content of the part (at the

homogenous material level) is lower than the threshold defined by

SJ/T11363-2006 (Electronic Information Product Virulent Deleterious Substance

Limits Quantity Request).

"X" indicates the hazardous and toxic substance content of the part (at the

homogenous material level) is over the threshold defined by SJ/T11363-2006

(Electronic Information Product Virulent Deleterious Substance Limits Quantity

Request).

In all cases where an X is shown, QLogic complies with the allowable exemption

summarized in Article 7 of the Directive 2002/95/EC of the European Parliament

And Of The Council of 27 January 2003.

The number identified within the EIP pollution control logo is based on normal

operating conditions.

Table 3. China RoHS Translated

部件名称 *有毒 , 有害物质和元素

铅

(Pb)

汞

(Hg)

镉

(Cd)

六价铬

(Cr6+)

多溴联苯

(PBB)

多溴二苯醚

(PBDE)

印刷电路板 X0 00 0 0

内接电源 X0 00 0 0

风扇 X0 00 0 0

电源插口 X0 00 0 0

缆绳和连接器组件 00 00 0 0

电源线 00 00 0 0

机壳和螺钉固定件 00 00 0 0

EMI 垫圈 00 00 0 0

光学模块 00 00 0 0

转换器 00 00 0 0

安装轨道 00 00 0 0

* 表中列出此产品含有有毒和有害物质及元素的部件名称。

"0" 表示此部件使用的所有同类材料中，此种有毒和有害物质

低于 SJ/T11363-2006 标准规定的限制要求。

"X" 表示此部件使用的所有同类材料中，此种有毒和有害物质

高于 SJ/T11363-2006 标准规定的限制要求。

此表中所有名称含 “X”标志的部件均符合欧盟 RoHS 立法

— “2003 年 1 月 27 日欧洲议会和欧洲理事会关于在电气电子

设备中限制使用某些有害物质的指令 2002/95/EC”。

—此 QLogic 产品符合欧盟豁免清单。

注：所引用的环保使用期限标记根据产品的正常操作使用条件

（如温度和湿度）确定。

Altri manuali per QLogic 12000 Series

Indice

Altri manuali Qlogic Interruttore

Qlogic

Qlogic SANbox 5600 Series Manuale utente

Qlogic

Qlogic 5600Q Manuale utente

Qlogic

Qlogic SANbox 5602 Manuale utente

Qlogic

Qlogic SANbox 5200 Series Manuale utente

Qlogic

Qlogic SANbox 1400 Series Manuale utente

Qlogic

Qlogic SANbox 5600 Series Manuale utente

Qlogic

Qlogic SANbox 3810 Manuale utente

Qlogic

Qlogic SANbox2 SANbox2-64 Manuale utente

Qlogic

Qlogic SilverStorm 9120 Manuale utente

Qlogic

Qlogic SANbox 5602 Manuale utente

Qlogic

Qlogic SANbox 5802V Manuale utente

Qlogic

Qlogic SANbox2 SANbox2-64 Manuale

Qlogic

Qlogic SANbox 3050 Manuale utente

Qlogic

Qlogic SANbox 5600 Series Manuale utente

Qlogic

Qlogic SANbox 5600 Series Manuale utente

Qlogic

Qlogic SANbox 3810 Manuale utente

Qlogic

Qlogic SANbox 5800V Series Manuale utente

Qlogic

Qlogic SANbox 5600 Series Manuale utente

Qlogic

Qlogic SANbox 9000 Series Manuale utente

Qlogic

Qlogic 3000 Series Manuale utente

Qlogic

Qlogic SANbox 1400 Series Manuale

Qlogic

Qlogic SANbox 5800V Series Manuale utente

Qlogic

Qlogic InfiniBand 12200-BS01 Manuale utente

Qlogic

Qlogic SANbox2 SANbox2-64 Manuale

Manuali Interruttore popolari di altre marche

URC

URC Total Control MFS-8 Manuale utente

Azbil

Azbil HPQ-D11 Manuale utente

Sony

Sony DFS-900M Manuale utente

SICK

SICK i17S Manuale utente

F&F

F&F SZR-277 Manuale utente

Shure

Shure UAMS/BK Manuale utente

Dräger

Dräger X-zone Switch Off Manuale utente

Asco

Asco Joucomatic 349 Series Manuale utente

BT Mini Hub Manuale utente

D-Link

D-Link DES-1226G Manuale utente

Johnson Controls

Johnson Controls FS80-C Manuale utente

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manuale utente

MicroNet

MicroNet SP1200A Manuale utente

Ruijie

Ruijie RG-PF2920 Series Manuale di installazione e funzionamento

Altinex

Altinex DA1914SX Manuale utente

MiLAN

MiLAN MIL-SM2401M Manuale utente

RJM

RJM MASTERMIND PBC/6X Manuale utente

Atlas

Atlas MMK-KVM8 Manuale utente