Securitytronix ST-D1000P-W Manuale utente

INSTALLATION MANUAL

ST-D1000P-W

Infrared Dome Camera

v1.0 8/4/14 1

PACKAGE CONTENTS

This package contains:

One ST-D1000P-W infrared dome color camera

Mounting Hardware

One installation manual

Note: The ST-D1000P-W requires a minimum 12VDC 200mA power supply such as the

ST-PS12VDC1A or ST-PS12VDC2A.

PRODUCT DESCRIPTION

The ST-D1000P-W is an infrared color dome camera. The camera uses a 1/3” Color CCD sensor

providing 1000TV lines of resolution. The ST-D1000P-W has a 3.6mm lens for optimal viewing. The 3-

axis mount makes this camera very easy to install and position. The 4 infrared LEDs support low light

illumination down to 0 Lux.

SPECIFICATIONS

ST-D1000P-W

Specifications (Typical)

Image Sensor

1/3” CCD

Scanning System

NTSC

Horizontal Resolution

1000TV Lines

Synchronization

Internal, Negative Sync

Minimum Illumination

0 lux B&W

Auto Electronic Shutter

1/60s~1/100,000s

Lens

3.6mm

S/N Ratio

>50dB

IR LED

4 pcs

10.

IR Distance

80ft

11.

IR Power On

CDS Auto Control

12.

Video Output

1.0Vp-p @ 75

13.

Operating Temperature

14F- 113F

14.

Operating Humidity

<95%

15.

Power Requirements

200mA @ 12VDC

16.

Dimensions

4.4”x3”

17. Weight

14.1 oz

v1.0 8/4/14 2

INSTALLATION AND OPERATION

This symbol is intended to alert the user to the presence of important operating

and maintenance (servicing) instructions.

This symbol is intended to alert the user to the presence of uninsulated “dangerous

voltage” within the product’s enclosure that may be of sufficient magnitude to constitute

a risk of electrical shock.

CAUTION: To reduce the risk of electrical shock do not remove the cover or back of

this unit. No user serviceable parts are inside.

CAUTION: To prevent electric shocks and risk of fire hazards, do not use other

than specified power source.

1. UNPACKING and HANDLING

Each unit is shipped assembled and factory tested.

Ensure that all accessories are removed from the container before discarding packing material

2. MECHANICAL INSPECTION

Inspect the front and rear of the equipment for shipping damage. Make sure the equipment is

clean, and no connectors are broken, damaged, or loose. If equipment appears to be damaged or

defective please contact your distributor or SecurityTronix at 1-610-429-1511 for assistance.

3. SPECIAL ATTENTION

a. The installer must comply with electrical safety standards. There must be sufficient

space between the camera’s power supply and video line and any high voltage

equipment and/or cables.

b. To help ensure the camera’s life and proper operation do not point the camera

towards the sun or strong light.

c. Do not install the camera in an environment where the temperature is above 113F.

d. Do not install the camera near a magnetic field or a high-power motor.

e. Do not mount the camera near a radiator or heater.

f. Only use a dry cloth to clean the camera. If there is dirt that is difficult to remove wipe

gently with a mild detergent. Never use strong or abrasive detergents.

g. This camera requires a 12VDC 200mA power supply. Using AC power or a power

supply other than specified will damage the camera.

h. Only qualified installers are allowed to install, test and disassemble the camera.

i. The camera is a low voltage product.

v1.0 8/4/14 3

4. WIRING CONNECTIONS

a. Connect the power supply’s DC plug to the camera’s power port.

b. Connect the camera to the monitor with a 75coaxial video cable.

c. Connect power supply’s AC plug to a suitable AC power outlet.

d. Adjust the lens direction according to the required surveillance area and environment.

v1.0 8/4/14 4

5. TROUBLESHOOTING

a. No picture after applying power –(i) check all plugs and cables are securely

connected to the proper connectors; (ii) ensure your power supply is providing the

correct voltage and current.

b. The picture has ripples –(i) check to see if the power supply is experiencing AC ripple, if

so a filter may be required; (ii) determine if the monitor is faulty; (iii) determine if other

peripheral equipment is causing ripple and if so make the necessary adjustments.

c. The picture background continuously changes color –a fluorescent lamp’s magnetic

field may cause color roll, therefore, reduce the number of fluorescent lamps or

increase the distance between the camera and the lamps.

d. The picture appears smeared –(i) the power supply voltage level may be unstable,

therefore, try another power supply; (ii) ensure the cables are correctly connected

and/or the cables are of the correct impedance.

e. Other interference may require a Securitytronix ground loop isolation filter.

f. Additional troubleshooting assistance can be found on-line at www.securitytronix.com in

addition to support from Securitytronix technicians at 1-800-688-9282, option 3, then

option 2.

v1.0 8/4/14 5

Indice

Altri manuali Securitytronix Telecamera di sicurezza

Securitytronix

Securitytronix ST-IP-BT3.6-1 Manuale utente

Securitytronix

Securitytronix ST-IP2VFB Manuale utente

Securitytronix

Securitytronix ST-HD-BT3.6-1MP Manuale utente

Securitytronix

Securitytronix HD-Coaxinator ST-HD-D2812-1MP Manuale utente

Securitytronix

Securitytronix ST-BTLI540IRVFDV Manuale utente

Securitytronix

Securitytronix HD-COAXINATOR ST-HD-TD3.6-1MP Manuale utente

Securitytronix

Securitytronix ST-DWDIRVF2812-720B Manuale utente

Securitytronix

Securitytronix ST-IP2FB Manuale utente

Securitytronix

Securitytronix ST-D420IR3.6 Manuale utente

Securitytronix

Securitytronix HD-COAXINATORTVI ST-HDC2FD Manuale utente

Securitytronix

Securitytronix ST-D600IR2812-HB Manuale utente

Securitytronix

Securitytronix ST-HD-D2812M-2MP Manuale utente

Securitytronix

Securitytronix ST-DLI6502812-JBX-B Manuale utente

Securitytronix

Securitytronix ST-D4203.6B Manuale utente

Securitytronix

Securitytronix ST-D540IRVP2812 Manuale utente

Securitytronix

Securitytronix ST-BTLI540IR30-B Manuale utente

Securitytronix

Securitytronix HD-COAXINATOR ST-HD-PTZ-2MP Manuale utente

Securitytronix

Securitytronix ST-WD600PTZMINI-IR Manuale utente

Securitytronix

Securitytronix ST-HDC2FB Manuale utente

Securitytronix

Securitytronix ST-DLI540IRVP-B Manuale utente

Securitytronix

Securitytronix ST-CVTMD520-WPIR-W Manuale utente

Securitytronix

Securitytronix ST-PTZMINI-540W Manuale utente

Securitytronix

Securitytronix HD-COAXINATOR TVI ST-HDC2FB-CNV Manuale utente

Securitytronix

Securitytronix ST-BT650IRVFDV –B Manuale utente

Manuali Telecamera di sicurezza popolari di altre marche

Okina USA

Okina USA SIR36-870VF650LP Manuale utente

Divio

Divio NDR155PA Manuale utente

Canon

Canon VB-C500D Manuale utente

Easy Access

Easy Access EasyGuard Manuale utente

Vivotek

Vivotek FD9389-EHV-v2 Manuale utente

TUYA

TUYA COSMO W2 Manuale utente

Eusso

Eusso UNC7500-IR Guida all'installazione

urmet domus

urmet domus 1096/204 Manuale utente

VC VC20 series Manuale utente

Axis

Axis Q1614 Manuale utente

ieGeek

ieGeek DD201 Manuale utente

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manuale utente

Vicon

Vicon V662-D-1 Istruzioni operative

Grundig

Grundig GCH-K0274P Manuale utente

Lorex

Lorex VANTAGE LBC7032 Manuale utente

4xem

4xem WPT Manuale utente

Samsung

Samsung SCV-3082 Manuale utente

Vitek

Vitek VTC-C544 Manuale utente