INSTALLATION
MOUNTING:
1. The OEM-6400.FT is design to be mounted on the License Plate bezel of a Ford Transit Van
vehicle. The particular mounting style of this camera will allow it to only be used on the
license plate lamp of this particular vehicle.
2. Unclip and remove the factory license plate illumination lamp using a screw driver or panel
removing tool (STEP 1). To do this, you may need to remove the interior panel of rear cargo
door. Be cautious not to scratch the paint on the body surface.
3. The bulb housing can be separated from the fixture once the assembly is removed. (STEP 1)
4. Route the wire harness through the fixture (STEP 2)and into the door through the license
plate limp mounting location. The wire harness can then be routed into the van through the
factory door boot.
5. Snap the OEM-6400.FT camera in place on the light fixture. Make sure it is secured tightly
once it is snapped into place. The factory license plate bulb should now be housed inside the
OEM-6400 camera. Snap the camera and fixture into place on the door (STEP 2).
NOTE: The interior panels of the rear cargo door will need to be removed in order to route the
camera cable into the car. This will also make it easier to remove the license plate lamp.
STEP 1 STEP 2
Remove the license plate lamp from the rear door
and remove the lamp housing from the fixture Replace the lamp housing with the OEM-6400.FT
camera and snap it into place on the lamp fixture.
Snap the camera/lamp assembly into place
CAMERA:
1. The color CMOS camera is maintenance-free, waterproof (IP-68) and vibration resistant.
2. This camera is designed to work well in day time or night time conditions.
3. The camera is completely electronic. There are NO manual adjustments for focus, etc.
