Safety Guidelines
Read the instructions carefully. Keep this document for future reference. Follow all
warnings and instructions marked on the product.
● Operate on a table or flat, stable surface, ensuring that the machine cannot fall and
is level;
● Do not operate outdoors;
● Do not allow resin or any liquids to get inside the chassis, wipe up any liquid spills
immediately;
● Do not use solvents to clean the printer as they may damage the screen. Use a little
detergent and warm water to clean any resin spills;
● Disconnect the printer from the power before storage or when not used for a long
period of time. This 3D printer is connected to the electrical network with an input of
110 or 240 V AC, 50/60 Hz;
● Do not allow anything to rest on the power cord. Do not locate this product where
people will walk on the cord;
● If an extension cord is used with this product, make sure that the total ampere rating
of the equipment plugged into the extension cord does not exceed the extension
cord ampere rating. Also, make sure that the total rating of all products plugged into
the wall outlet does not exceed the fuse rating;
● Do not overload a power outlet, strip or receptacle by plugging in too many devices;
● Use the product only with the supplied power cable. If you need to replace the
power cable, make sure that the new power cable meets the following
requirements: detachable type, UL listed/CSA certified, VDE approved or its
equivalent, 4.5 meters (15 feet) maximum;
● In case of malfunction, disconnect the printer immediately from the power;
● Do not attempt to fix this product by yourself, as opening or removing covers may
expose you to dangerous voltage points or other risks. Refer all repairs to qualified
service personnel. Please send an email to your national supplier or contact
4
