Siemens MPS-6 Manuale utente

Installation Instructions

Model MPS-6

Power Supply Module

P/N 315-090334-8

OPERATION

The Model MPS-6 from Siemens Industry, Inc. is a

fully supervised power supply that provides the MXL

System with primary 24 VDC power. It is rated at 6.5

amps and is unfiltered and unregulated. The MPS-6

supplies the MXL Control Panel or PSR-1 and its

expansion modules with the power required for

normal operation. The module incorporates a 2 amp

resettable circuitbreaker on the primary input and

includes a built-in AC line filter for surge and noise

suppression. The MPS-6 mounts in an MXL enclo-

sure backbox.

INSTALLATION

Always remove power before installation.

The installation kit for the MPS-6 includes the

following:

Four #10 nuts

Two #10 lockwashers

Two #10 flat washers

Two ¼" nuts

One 14 gauge green ground strap

The MPS-6 is designed to operate from a 120 VAC,

60 Hz power source. Use a separate or dedicated

circuitbreaker. Wire in accordance with local codes

and Article 760 of the NEC, NFPA 70, latest edition.

Run the earth ground from a suitable source to the

MPS-6. Check local requirements. Conduit is not

an acceptable conductor.

1. Make sure that the dedicated circuitbreaker

for the MPS-6 is turned off at the mains.

2. Place the mounting bracket for the MPS-6 over

the two studs provided in the enclosure. (Refer to

Figure 1.)

3. Secure the MPS-6 to the enclosure by slipping the

flat washers, then the lockwashers, and finally the

nuts over the two studs. Tighten them securely.

4. Connect the AC mains to the MPS-6:

Terminal

Black (hot) 1

White (neutral) 2

Green (earth ground) 3

5. Install the 14 gauge green ground strap spade lug

side to Terminal 3 (green, earth ground) of the

MPS-6. Secure the ring lug side of the ground

strap to the nearest available stud in the enclo-

sure. The stud size may vary depending on the

actual system modules and enclosure used.

Because the stud may be either a #10 thread or

¼" thread, nuts for both have been provided. The

ground strap provided is long enough for all

applications and the ring lug is good for both #10

and ¼" studs. If possible, install the ring lug under

one of the lock-washers and nuts which secure

the MPS-6 itself.

6. When used with a PSR-1:

Connect the 3-wire cable coming from the MPS-6

to the PSR at P12.

When used with an MMB-1/-2/-3 or SMB-1/2:

Connect the 3-wire cable coming from the MPS-6

to the MMB-1/-2/-3 or the SMB-1/2 at P1.

Siemens Industry, Inc.

Building Technologies Division

Florham Park, NJ

Siemens Building Technologies, Ltd.

Fire Safety & Security Products

2 Kenview Boulevard

Brampton, Ontario

L6T 5E4 Canada

P/N 315-090334-8

Figure 2

Front of MPS-6

Figure 1

MPS-6 in MXL Enclosure

POWER CABLE TO:

MMB-1/-2/-3, P1

SMB-1/-2, P1

PSR-1, P12

Altri manuali Siemens Unità di controllo

Siemens

Siemens SM 338 Manuale utente

Siemens

Siemens SIRIUS ACT 3SU1400-1EK10-6AA0 Manuale utente

Siemens

Siemens 3TK2811 Manuale utente

Siemens

Siemens SIMOTION D425 Manuale utente

Siemens

Siemens SINUMERIK 840D sl Manuale del proprietario

Siemens

Siemens SINAMICS G120P Istruzioni per il montaggio

Siemens

Siemens Simatic S7-300 Manuale utente

Siemens

Siemens P Series Manuale utente

Siemens

Siemens MEM-1 Manuale utente

Siemens

Siemens SIWAREX MS Manuale utente

Siemens

Siemens SIMATIC FM 351 Manuale utente

Siemens

Siemens DMS8000 MP4 Series Istruzioni operative e di manutenzione

Siemens

Siemens RUGGEDCOM RS900F Manuale utente

Siemens

Siemens SIRIUS Manuale utente

Siemens

Siemens SIMOTION D410 Manuale utente

Siemens

Siemens SINAMICS G120 Manuale utente

Siemens

Siemens SIMOTION D4x5 Series Manuale utente

Siemens

Siemens SINUMERIK 808D Guida all'installazione

Siemens

Siemens SINUMERIK 840D sl Guida rapida

Siemens

Siemens SIMADYN D T400 Manuale elenco delle parti

Siemens

Siemens 6MB5110-1 Manuale utente

Siemens

Siemens SINUMERIK 840DE SL Manuale elenco delle parti

Siemens

Siemens QAW910 Manuale utente

Siemens

Siemens SIMATIC ET 200SP Manuale utente

Manuali Unità di controllo popolari di altre marche

Festo

Festo Compact Performance CP-FB6-E Manuale elenco delle parti

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuale utente

JS Automation

JS Automation MPC3034A Manuale utente

JAUDT

JAUDT SW GII 6406 Series Guida rapida

Spektrum

Spektrum Air Module System Manuale utente

BOC Edwards

BOC Edwards Q Series Manuale utente

KHADAS

KHADAS BT Magic Manuale utente

Etherma

Etherma eNEXHO-IL Manuale utente

PMFoundations

PMFoundations Attenuverter Manuale utente

GEA

GEA VARIVENT Manuale utente

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuale utente

Altronix

Altronix LINQ8PD Istruzioni per il montaggio

Eaton

Eaton Powerware Series Manuale utente

WAGO

WAGO 750-407/040-000 Manuale utente

Sony

Sony CCU-590 Manuale utente

Graco

Graco 25D614 Manuale utente

Task Force Tips

Task Force Tips YE-RF-900 Manuale di programmazione

Shini

Shini SPV-U Series Manuale utente