Siemens SiPass Driver Manuale utente

Installation Instructions

Document No. 565-722

August 2, 2013

SiPass Driver for PXC Modular and PXC-36

Item Number: 565-722, Rev. BA

Page 1 of 2

These installation instructions cover the connection of

the Siemens SiPass Driver to the SiPass system

only.

For hardware installation of the PXC Modular, see

the

PXC Modular Series Installation Instructions

(553-638).

For hardware installation of the PXC-36, see the

PXC Compact 36 Installation Instructions

(553-504).

Product Description

The Siemens SiPass Driver enables communication

between the APOGEE® Automation System and the

Siemens SiPass system.

Product Numbers

License

LSM-INT-SBTSPSS

License to enable the Siemens SiPass

Driver on PXC Modular or PXC-36

hardware.

PXC Modular Series

PXC00-PE96.A

PXC Modular, Ethernet or RS-485

ALN, 96 FLN nodes

PXC00-E96.A

PXC Modular, BACnet/IP or MS/TP

ALN, 96 FLN nodes

PXC100-PE96.A

PXC Modular, Ethernet or RS-485

ALN, 96 FLN nodes, TX-I/O module

support

PXC100-E96.A

PXC Modular, BACnet/IP or MS/TP

ALN, 96 FLN nodes, TX-I/O module

support

PXX-485.3

Expansion Module, three RS-485 FLN

connections

PXC Compact Series

PXC36-PE.A

PXC Compact, 36 point, Ethernet/IP or

RS-485 ALN

PXC36-E.A

PXC Compact, 36 point, BACnet/IP or

MS/TP ALN

Accessories

538-670

Trunk Interface II, 115V

538-675

Trunk Interface II, 230V

536-004

RS-232 Cable

Caution Notation

CAUTION

Equipment damage or loss of data may

occur if you do not follow a procedure as

specified.

Expected Installation Time

30 minutes

Required Tools and Materials

Flat-blade screwdriver (1/8-inch blade width).

Wire strippers.

Cabling and connectors. See the

Connecting the

Driver to the

SiPass System

section.

CAUTION

Always wear an electro-static discharge

(ESD) wrist strap and discharge

accumulated static before touching field

panel components.

Document No. 565-722

Installation Instructions

August 2, 2013

Information in this document is based on specifications believed correct at the time of publication. The right is reserved to make changes as

design improvements are introduced. APOGEE, Insight, and SiPass are registered trademarks of Siemens Industry, Inc. Other product or

Siemens Industry, Inc.

Building Technologies Division

1000 Deerfield Parkway

Buffalo Grove, IL 60089-4513

USA

Tel. 1 + 847-215-1000

Your feedback is important to us. If you have

comments about this document, please send them

to SBT_technical.editor.us.sbt@siemens.com.

Document No. 565-722

Printed in the USA

Page 2 of 2

Prerequisites

Driver hardware is installed according to its

respective installation instructions.

FLN termination blocks are installed.

One 115V or 230V receptacle (depending on

device) is available to power the Trunk Interface

II.

Ethernet infrastructure is installed.

Depending on the type of installation, other

prerequisites may have to be completed.

Connecting the Driver to the SiPass

System

Follow these steps to connect the driver to the SiPass

System:

1. Install the Trunk Interface II per the diagram in

Figure 1.

2. Connect cables per the diagram in Figure 1.

3. Plug in the power supply for the Trunk Interface II

per the diagram in Figure 1.

Figure 1: Connecting the Driver to the SiPass System.

Table 1. Wiring Pin-outs for RS-232 Cable

(P/N 536-004).

Trunk Interface

(DB-25 Male)

SiPass

(9-pin Female)

Indice

Altri manuali Siemens Unità di controllo

Siemens

Siemens HOTEL SOLUTION HTC3.1/A Manuale utente

Siemens

Siemens Add 7 AddFEM Manuale utente

Siemens

Siemens SIMATIC ET 200SP Manuale utente

Siemens

Siemens SINUMERIK 840D Manuale elenco delle parti

Siemens

Siemens SIPROTEC 7SJ80 Manuale utente

Siemens

Siemens simatic ET 200MP Manuale utente

Siemens

Siemens SINUMERIK 840Di Manuale

Siemens

Siemens Simatic S7-1500 Manuale utente

Siemens

Siemens LMO14 Series Manuale utente

Siemens

Siemens Sinamics G120 CU240E Manuale utente

Siemens

Siemens SIMATIC ET 200SP Manuale utente

Siemens

Siemens PM240 Istruzioni per il montaggio

Siemens

Siemens WF 725 Manuale tecnico

Siemens

Siemens SIMATIC ET 200SP Manuale utente

Siemens

Siemens MXG461B Series Manuale del proprietario

Siemens

Siemens SIRIUS 3RT1.5 Manuale utente

Siemens

Siemens VBI60.15-5L Manuale utente

Siemens

Siemens SIMATIC ET 200SP Manuale utente

Siemens

Siemens ASIsafe 3RK1205-0B.00 Manuale utente

Siemens

Siemens SMF6120 Manuale utente

Siemens

Siemens AP 641 Manuale di servizio

Siemens

Siemens SIMATIC NET CP 1243-1 DNP3 Foglio di istruzioni

Siemens

Siemens SINAMICS DCM Manuale utente

Siemens

Siemens SENTRON ATC6500 Manuale utente

Manuali Unità di controllo popolari di altre marche

Festo

Festo Compact Performance CP-FB6-E Manuale elenco delle parti

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuale utente

JS Automation

JS Automation MPC3034A Manuale utente

JAUDT

JAUDT SW GII 6406 Series Guida rapida

Spektrum

Spektrum Air Module System Manuale utente

BOC Edwards

BOC Edwards Q Series Manuale utente

KHADAS

KHADAS BT Magic Manuale utente

Etherma

Etherma eNEXHO-IL Manuale utente

PMFoundations

PMFoundations Attenuverter Manuale utente

GEA

GEA VARIVENT Manuale utente

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuale utente

Altronix

Altronix LINQ8PD Istruzioni per il montaggio

Eaton

Eaton Powerware Series Manuale utente

WAGO

WAGO 750-407/040-000 Manuale utente

Sony

Sony CCU-590 Manuale utente

Graco

Graco 25D614 Manuale utente

Task Force Tips

Task Force Tips YE-RF-900 Manuale di programmazione

Shini

Shini SPV-U Series Manuale utente