Singer FHT 6320 Manuale utente

FHT 6320

2-in-1 HEATING & COOLING

2-in-1 ΘΕΡΜΑΝΣΗ & ΨΥΞΗ

INSTRUCTION MANUAL

ΒΙΒΛΙΟ ΟΔΗΓΙΩΝ

ENGLISH

PLEASE READ THESE INSTRUCTIONS CAREFULLY

BEFORE USE AND KEEP THEM FOR FUTURE

REFERENCE.

Thank you for purchasing the stand fan of Singer. Each unit has

been manufactured to ensure safety and reliability. Before ﬁrst

use, please read these instructions carefully and retain them for

future reference.

IMPORTANT SAFETY INSTRUCTIONS

1. Use the appliance only for its designated purpose.

2. Do not immerse the appliance or the base in water or any

other liquid.

3. Always disconnect the fan from the main supply when not

in use and before cleaning.

4. Never pull off the cable to disconnect it from the socket.

Instead, unplug by pulling the plug from the socket.

5. Turn off the power and pull out the plug when you go out

for long time.

6. Never attempt to put your ﬁnger and other objects into the

louver or the rear grill when the fan works.

7. Keep the cord, the base and the appliance away from hot

surfaces.

8. Check if the voltage indicated on the base of the appliance

corresponds to the local mains voltage before you connect

the appliance.

9. Keep the appliance and packaging materials away from

persons (including children) with reduced physical or

sensory capabilities, or lack of experience and knowledge.

10. Close supervision is necessary when the appliance is

used by or near children.

11. Do not attempt to dismantle any part of the desk fan. This

should only be done at a SINGER Service Center.

ENGLISH

12. Do not use the appliance if the cord, the plug, the base or

the appliance itself is damaged.

13. If the cord or any other part is damaged, you must contact

any SINGER Service Center or SINGER Client Service.

14. The appliance is intended for household use only.

15. This appliance is not intended for use by persons

(including children) with reduced physical, sensory or

mental capabilities, or lack of experience and knowledge,

unless they have been given supervision or instruction

concerning use of the appliance by a person responsible

for their safety.

16. Children should be supervised to ensure that they do not

play with the appliance.

17. Never put any object to block the air inlet/outlet.

18. Please use this product at 0~40℃, do not put the fan in

the bathroom, wet and very hot place to avoid damage to

the product.

19. Please keep the fan away from soft objects such as

curtains and door curtains, so as not to get involved in

the fan.

20. When the fan is not used for a long time, please remove the

power plug, so as not to shorten the product life and cause

accidents or dangers in the standby state for a long time.

21. The product should be kept clean and maintained

regularly.

22. Do not put the ﬁngers and other body parts into the fan to

avoid injury and damage the product.

23. Do not put wet towels on the product casually to avoid

leakage and electric shock.

24. Do not touch the operation button when remove the

protective cover, to avoid accidents in product operation.

ENGLISH

SERVICE & REPAIR

1. For service or repair under warranty, please contact the authorized service

company that is mentioned on the guarantee card and accompanies the

product.

2. Do not operate any product with a damaged cord or plug. If the supply

cord is damaged, return the appliance to a SINGER service center for

examination, repair or adjustment. Do not attempt to dismantle any part of

the appliance. This should only be done at an authorized SINGER service

center.

3. The partial or total non-respect of the safety instructions in the present

instruction manual will automatically release Singer of any type of

responsibility in case of malfunction of the machine or injuries to persons

or animals.

4. In case of manipulation, repairing or any modiﬁcation of the machine

made by unqualiﬁed persons or in case of improper use, the guarantee

will be automatically cancelled.

Note: Above speciﬁcations are subject to change without notice.

DESCRIPTION

1. Main body

2. Remote control

3. ON/OFF switch

4. Power plug

5. Indicator light

6. LED display

7. Control panel

8. Safety grill

9. Handle

ENGLISH

Control panel

1. LED display

2. Minus button

3. Plus butoon & WI-FI

4. Timer button

5. Motion button

6. ECO button

7. Heat level button

8. Fan speed button

9. ON/OFF button

Light indicators

1. Timer indication

2. ECO indication

3. Motion indicator

4. Fan speed level 4 indicator

5. Fan speed level 3 indicator

6. Fan speed level 2 indicator

7. Fan speed level 1 indicator

8. ON/OFF indicator

9. Fan indicator

10. Low heat indicator

11. High heat indicator

Remote control*

1. Fan speed button

2. ECO button

3. Timer button

4. Plus button

5. Minus button

6. Motion button

7. Heat level button

8. ON/OFF button

*Battery included

Figure 5

Figure 6

ENGLISH

INSTALLATION

The device is packed in one box. Remove all packaging material and check

that the device is not damaged. Do not use the heater if it is damaged, but

always contact your supplier. Keep the packaging for safe storage and

transport.

1. Place the device on a level and steady

surface.

2. Place the device with a minimum

distance of 1 meter to any object, wall

or ceiling.

3. Do not place the device directly below

a socket outlet.

4. Make sure the ON/OFF switch is in the

OFF position (Figure 7, pos. 1).

5. Put the power plug into an earthed

wall socket that is easily accessible.

Use an earthed wall socket with a

minimum power of 2000 Watt.

Remote control

1. Press on the lip (Figure 8, pos. 2) and

remove the slot (Figure 8).

2. Remove the battery (if present) (Figure

8, pos. 3).

3. Insert a battery (CR2025) as indicated

in the battery compartment. Make

sure to insert the battery correctly.

4. Replace the cover.

Figure 7

Figure 8

ENGLISH

OPERATION

WARNING

Before every use, make sure that:

• you operate the device with dry hands

• the device is clean and dry

• the device is not damaged

CAUTION

When the device is turned on it can give off smoke and an odor. This

is normal and will disappear after a few minutes.

1. Press the ON/OFF switch in the ON

position (Figure 9, pos. 2).

2. Press the ON/OFF button on the

control panel (Figure 9, pos. 4) or on

the remote control (Figure 9, pos. 1).

3. The ON/OFF indicator (Figure 9, pos.

3) switches on.

Fan mode

1. Press the fan speed button on the control panel or remote control until

the desired fan speed is reached:

• level 1: fan indicator and level 1 indicator light up

• level 2: fan indicator and level 2 indicator light up

• level 3: fan indicator and level 3 indicator light up

• level 4: fan indicator and level 4 indicator light up

2. The indicator light turns blue.

3. The LED display shows the current temperature.

Figure 9

ENGLISH

Heating mode

The heating mode only works at fan speed level 2.

1. Press the heat level button on the control panel or remote control until

the desired heating level is reached:

• level 1: low heat indicator lights up, P1 appears on the display

• level 2: high heat indicator lights up, P2 appears on the display

2. The indicator light turns red.

3. The LED display shows the current temperature.

Temperature mode (HEATING & ECO mode)

1. Press the heat level button on the control panel or remote control.

2. Use the plus or minus button to set the desired temperature (from 10°C

to 35°C). 3. The device automatically adjusts the settings to reach

the given temperature.

4. The indicator light turns:

• red, when in heating mode

• blue, when the desired temperature reaches

5. The LED display shows the current temperature

ECO mode (HEATING mode)

The ECO mode is an energy-efﬁcient mode; the device maintains the room

temperature at 23°C. This means that if the room temperature

• is lower than 17°C, the device will work on high heat setting.

• is higher than 17°C and lower than 20°C, the device will work on low

heat setting.

• Is higher than 20°C, the device will activate the fan setting.

1. Press the ECO button on the control panel or remote control; the ECO

indicator lights up.

2. The indicator light turns green.

3. The LED display shows the current temperature.

4. Press the ECO button again to deactivate.

ENGLISH

Motion mode

1. Press the motion button on the control

panel (Figure 11, pos. 3) or remote

control (Figure 11, pos. 1).

2. The motion indicator switches on.

3. The device (Figure 11, pos. 4) starts

rotating from left to right at an angle

of 70°.

4. Press the motion button again to

deactivate.

Timer mode

1. Press the timer button on the control panel or on the remote control.

2. Use the plus or minus button to set the desired timer (from 1 to 24 hours).

3. The device automatically goes in standby mode at set timer.

Standby mode

1. Press the OFF button on the control panel (Figure 10, pos. 4) or on the

remote control (Figure 10, pos. 1).

2. The device keeps operating in fan mode for 30 seconds. The LED

display will countdown from 30 to 1.

3. After 30 seconds the device switches to standby mode.

After operation

CAUTION

Do not use the power cable to unplug or carry the device. Do not

wind the power cable too tightly or in sharp corners. Do not wrap the

power cable around the device.

1. Make sure the ON/OFF switch is in the OFF position (Figure 10, pos. 2).

2. Disconnect the power plug from the power outlet.

3. Let the device cool down before touching it.

4. Wind the power cable.

5. Remove the battery from the remote control.

Figure 10

ENGLISH

Maintenance

WARNING

Do not perform any repairs or modiﬁcations to this device.

WARNING

The device becomes very hot. Make sure the device is turned off,

unplugged and completely cooled down.

CAUTION

Do not use:

• scouring pads

• hard brushes

• ﬂammable, aggressive or chemical cleaning products.

Prevent water from entering the device. Do not immerse any part of the

device in water or other liquids.

It is recommended to clean the device after each use and prior to storage.

1. Carefully vacuum the openings to remove dust and dirt.

2. Wipe the device with a damp, clean, soft, lint-free cloth, or a soft brush.

3. Let the device dry completely prior to use and storage.

Transport and storage

• Clean the device before storing it.

• Transport the device upright.

• Store the device upright in its original packaging in a cool, dry and dust-

free area.

Indice

Lingue:

Altri manuali Singer Stufa

Singer

Singer SOFR09 Manuale utente

Singer

Singer SFH-41 Manuale utente

Singer

Singer MICA MIR 6010 Manuale utente

Singer

Singer SFH-200CBA Manuale utente

Singer

Singer HAL1200 Manuale utente

Singer

Singer SCQH-15 Manuale utente

Singer

Singer SRMH-25 Manuale utente

Singer

Singer BFH-2000 Manuale utente

Singer

Singer SRMH-15 Manuale utente

Singer

Singer SCH-17 Manuale utente

Singer

Singer SCQH-20 Manuale utente

Manuali Stufa popolari di altre marche

oventrop

oventrop Regucor Series Manuale utente

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuale utente

ELMEKO

ELMEKO ML 150 Manuale utente

BN Thermic

BN Thermic 830T Manuale utente

KING

KING K Series Guida

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guida rapida

Well Straler

Well Straler RC-16B Manuale utente

EUROM

EUROM 333299 Manuale utente

Heylo

Heylo K 170 Manuale utente

Eterna

Eterna TR70W Manuale utente

Clarke

Clarke GRH15 Manuale di istruzioni

IRSAP

IRSAP The Radiator Company Ovali Manuale utente

Empire Heating Systems

Empire Heating Systems WCC65 Manuale utente

Wetekom

Wetekom 92 86 43 Manuale utente

Desa

Desa SPC170-F Manuale utente

Watlow

Watlow Watrod Electric Tubular Heaters Manuale utente

Haverland

Haverland ECO-DRY GPS Series Manuale elenco delle parti

Stelpro

Stelpro ASILVC2060 Series Manuale utente