Skywalker X-5 Manuale utente
Skywalker X-5 Fly wing for FPV
Welcome to buy X-5 fly wing, this is a small sized FPV aircraft, but it has enough lift area to carry
C or gopro. It is suitable for cruising at a speed of 60KM/H. It also has a relatively spacious
cabin and is convenient to carry around. The installation is very simple. Look at its accessories
and installation instructions below .
Parts in the accessories bag: 1 glue , 2 steel tie rods, 2 extension cords , 2 rudder horns and quick
connector. And 4 fixed screws for motor and 2 for hatch cover.
First disconnect the winglets
Spread the glue evenly over the winglets and fuselage and wait for five minutes, then adhere the
winglets to the fuselage.
Installation of motor: here for 2212 ~ 2215 KV 1600~1900 outer rotor brushless motor, generally
it is high speed flight, so we need to adjust the thrust line with two gaskets.
Spread the glue evenly between the motor base and the layer, wait until it is non-sticky, they can
be pressed, as for binding benchmark, the bottom edge shall prevail.
The angle is like this after binding
Glue the servo and rudder horn, power on the receiver and make servo stop in the mid-position,
and then lock the regulator. After that cut the aileron. Here are advices for players who are new to
this fly wing : aileron deflection angle ,which is -20/+20 degrees, is more appropriate. Increase the
rudder quantity as you adapt to this.
Spray paint on the hatch cover
Cut some CC briquette in front of hatch
Gluing on the fuselage
Gluing the antenna base of the data radio
Try whether CC is suitable for installation
Basically completed
Altri manuali Skywalker Giocattolo
