Smart-Bus G4 Manuale utente
1
www.smarthomebus.com
How to make Smart G4 HVAC Module works stand-alone:
A typical installation of Smart G4 HVAC Module need to be paired with one DD to control
it.
In case there is no DD in your installation, HVAC can also works stand-alone using other
interface such us IOS Application, Android App and HAC Software.
Here’s the steps:
1. Your HVAC Module Firmware must be version v1.28 or above.
2. Connect an external Temperature Sensor as shown on the Diagram below.
3. Open your Smart Cloud Software and look for your HVAC Module.
4. On the HVAC tab, select Temperature Sensor.
5. Then, Select “Current module external temperature sensor”
2
www.smarthomebus.com
6. Save it.
7. You can go to the “Test” tab to test your HVAC if is working.
If you done these steps, you are now ready to put it on the SQLite database:
1. Create a Zone
2. Go to HVAC table and enter the Subnet ID and Device ID of your HVAC Module (instead of
DD )
3
www.smarthomebus.com
3. Upload the database that you created to your device and test.
Indice
Altri manuali Smart-Bus Unità di controllo
Manuali Unità di controllo popolari di altre marche
Festo
Festo Compact Performance CP-FB6-E Manuale elenco delle parti
Elo TouchSystems
Elo TouchSystems DMS-SA19P-EXTME Manuale utente
JS Automation
JS Automation MPC3034A Manuale utente
JAUDT
JAUDT SW GII 6406 Series Guida rapida
Spektrum
Spektrum Air Module System Manuale utente
BOC Edwards
BOC Edwards Q Series Manuale utente
