05
12
3. TO INSTALL THE REAR WHEELS
A
www.britax.com.au www.britax.com.au
AStore the bassinette handles inside the zipped
pockets and fold the bassinette canopy back
towards the rear of the bassinette. (For a more
compact fold it is optional to release the bassinette
frame rods towards the middle of the bassinette
and push lightly down until the bassinette
collapses). Standing behind the stroller pull both
locks (refer to section 10 A). Push the handle
forward allowing the stroller and bassinette to fold
until the chassis moves into a fully folded position.
BApply the frame lock catch.
15. TO INSTALL THE TODDLER SEAT (where supplied)
WARNING: Always remove your child from the stroller/
toddler seat prior to installation or removal.
ARemove the arm bar (if fitted) as described in
section 9.
BThe toddler seat has locating slots on the lower
mounting brackets. Rotate these slots until they
align with the opening in the moulding.
CAlign the slots on the lower mounting brackets with
the tongues on the inside of the stroller frame, then
push the lower mounting brackets into the tongues.
DRotate the upper mounting brackets outwards,
then raise the toddler seat to an upright position.
Push the circular hole in the upper mounting
bracket fully over the stud on the stroller frame 1
then pull the upper mounting bracket forward until
it locks into position 2 . Repeat this process for
both upper mounting brackets.
ECheck the toddler seat is securely in place by
pulling on it.
FRefer to section 8 to secure child in the harness.
CAUTION: Do not lift the stroller by the toddler seat. It
may disengage.
14. TO FOLD THE STROLLER WITH BASSINETTE
A
B
C
D
E
A
A
B
C
A
A Push each rear wheel into the chassis until they
lock into position.
BCheck the wheels are correctly fitted by trying to
pull them out.
NOTE: The rear wheels can be removed for more
compact storage. Do this by lifting the lock lever
(shown by arrow ) on the top of the rear wheel
housing, then pull the wheel out.
4. TO USE THE STROLLER CANOPY
WARNING: Do not use the stroller canopy when
bassinette is in use.
ATo fit the canopy push the clips onto the handle
frame (shown by arrows) on both sides of the
stroller and attach the press fit studs onto the clips.
BOpen the canopy by pulling the front of the canopy
forward and push the canopy hinges down on each
side to lock it in open position.
CTo open the canopy window (where fitted) pull the
flap away from the canopy and roll it up. Hold it in
place by attaching the fastener.
DTo remove the canopy remove clips from the frame
on both sides.
A
