RJ45 Ports on IP Flush/OR
Master Stations
RJ45 Ports on IP Substation
PCB
If you decide not to use a PoE switch, the IP station can useL
a 24 VDC power supply. See the STENTOFON IP Station
Manual for information on connecting local power supply.
Logging on to the System Master2.2.2
Access the System Master station by logging into the
web interface using a standard web browser:
Open a web browser1.
In the browser’s address bar, type2. 169.254.1.100
and press the ENTER key
169.254.1.100 is the default IP address of the IP station-
The station Login page is displayed.-
To log into the station:
Click1. Login
Enter the default User2.
name: admin
Enter the default password:3. alphaadmin
The Station Information page will now be displayed,
showing the default IP master station conguration.
In order for your PC to communicate with the station it isL
necessary to change its Internet Protocol Properties to use
an IP address that is in the same range as 169.254.1.100,
e.g. 169.254.1.1 with subnet mask 255.255.255.0
Setting up System Master2.2.3
Under the●Station Main tab, click Main Settings
to congure station mode and IP parameters.
Station Mode
Since this is the System Master station, it will function
as the server or exchange:
Select the●Use Pulse Server radio-button
IP Settings
Select the●Static IP radio-button
Enter values for the●IP address (e.g.
169.254.1.99), Subnet mask, and Gateway
Click●Save followed by Apply to restart the System
Master station.
Connect other Intercom Stations2.3
Connect all other IP intercom stations to the network.
Note that all other IP intercom stations have to be on
the same LAN (IP subnet) as the System Master.
Wait for the stations to boot up (approximately 60
seconds) before proceeding to the next step.
Congure Directory (Phonebook)2.4
Log into the System Master station with the new IP
address (e.g. 169.254.1.99) that you have just set
under Station Main > Main Settings. After login, you
will nd a new Server Management tab
Under the●Server Management tab, select Server
Conguration >Directory Settings
The System Master station will auto-discover all the
other stations in the LAN.
To identify the individual stations in the LAN:
Click Play●
You should now hear a tone from the station you selected.-
You can now set directory numbers, names, IP
addresses, proles, etc. for all the stations in the
network. In our example, the System Master station is
designated as Reception Desk with directory number
10 while the two substations are the Main Entrance
and Rear Entrance with directory numbers 11 and 12
respectively.
Click●Save followed by Apply
When you click- Apply, the System Master will download
the directory settings to all the STENTOFON IP intercom
stations and do a system reboot.
PasswordL is an optional eld you can set to increase the
security level. The password is used by other intercom
stations to register with the System Master.
