SUGA SWP23MA-3 Manuale utente
Suga Electronics Limited
© Suga Electronics Limited. All Rights Reserved.
Information in this document is subject to change without prior notice.
P. 1
802.11b/g/n (2T2R) WLAN AP/Router Module
User Manual
Model: WP23MA-3
Version: 1.0
June 2014
Contents
1. FCC & IC tatement............................................................................................... 2
1.1. FCC Caution..................................................................................................2
1.2. FCC Radiation Exposure tatement ...........................................................2
1.3. IC Warning ....................................................................................................3
2. Hardware Installation............................................................................................. 4
2.1. Hardware Installation Procedures...............................................................4
3. oftware Installation ............................................................................................... 6
3.1. Booting up ......................................................................................................6
3.2. Operation Mode Configuration ...................................................................7
3.3. Local Area Network (LAN) ettings............................................................8
3.4. Basic Wireless ettings..................................................................................9
3.5. Advanced Wireless ettings ........................................................................10
3.6. Wireless ecurity / Encryption ettings ....................................................11
3.7. tation List ...................................................................................................12
4. Device Labeling ..................................................................................................... 13
5. Disclaimer .............................................................................................................. 13
Suga Electronics Limited
© Suga Electronics Limited. All Rights Reserved.
Information in this document is subject to change without prior notice.
P. 2
1. FCC & IC tatement
1.1. FCC Caution
Any hanges or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the F Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
1.2. FCC Radiation Exposure tatement
IMPORTANT NOTE:
This equipment complies with F radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Suga Electronics Limited
© Suga Electronics Limited. All Rights Reserved.
Information in this document is subject to change without prior notice.
P. 3
1.3. IC Warning
RSS ( ategory I Equipment):
This device complies with Industry anada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux NR d'Industrie anada applicables aux
appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
Under Industry anada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry anada.
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not
more than that necessary for successful communication.
onformément à la réglementation d'Industrie anada, le présent émetteur radio peut
fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé
pour l'émetteur par Industrie anada. Dans le but de réduire les risques de brouillage
radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et
son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse
pas l'intensité nécessaire à l'établissement d'une communication satisfaisante.
I RF Exposure Statement
This equipment complies with I radiation exposure limits set forth for an
uncontrolled environment.
et appareil est conforme aux limites d'exposition aux rayonnements définies pour un
environnement non contrôlé.
Suga Electronics Limited
© Suga Electronics Limited. All Rights Reserved.
Information in this document is subject to change without prior notice.
P. 4
2. Hardware Installation
2.1. Hardware Installation Procedures
IMPORTANT: MU T DI CONNECT POWER BEFORE IN TALLATION.
(1) Plug the module into the host mother board by the 40-pin connector J6. Press the
module gently until the connectors are mated.
Suga Electronics Limited
© Suga Electronics Limited. All Rights Reserved.
Information in this document is subject to change without prior notice.
P. 5
(2) Plug antenna_0 into the RF connector port.
(3) Plug antenna_1 into the RF connector port.
(4) Plug the LAN/WAN cable in to the LAN/WAN RJ45 socket J5.
Suga Electronics Limited
© Suga Electronics Limited. All Rights Reserved.
Information in this document is subject to change without prior notice.
P. 6
3. oftware Installation
3.1. Booting up
Power up the module. onnect the Ethernet port to the P . Enter http://10.10.10.254
into Browser (e.g., Internet Explorer) to open the AP/router home page. As below:
Suga Electronics Limited
© Suga Electronics Limited. All Rights Reserved.
Information in this document is subject to change without prior notice.
P. 7
3.2. Operation Mode Configuration
Select “Operation Mode” to configure the operation mode to fit your environment. In
this menu, there are four options. Please follow the description to choose the option
you needed. If you want the module to act as an AP and lient, you should select “AP
lient” mode, choose “Enable” and then “Apply”.
Suga Electronics Limited
© Suga Electronics Limited. All Rights Reserved.
Information in this document is subject to change without prior notice.
P. 8
3.3. Local Area Network (LAN) ettings
Select “LAN” option to set your home page IP address, subnet mask, default gateway,
etc. The default IP is 10.10.10.254.
Suga Electronics Limited
© Suga Electronics Limited. All Rights Reserved.
Information in this document is subject to change without prior notice.
P. 9
3.4. Basic Wireless ettings
You could configure the minimum number of Wireless settings for communication
such as Network Name (SSID), Network Mode (802.11b/g/n) and hannel. The
Access Point can be set simply with only the minimum setting items.
Suga Electronics Limited
© Suga Electronics Limited. All Rights Reserved.
Information in this document is subject to change without prior notice.
P. 10
3.5. Advanced Wireless ettings
Use the Advanced Setup page to make advanced settings for the Wireless. Advanced
Setup includes items that are not available from the Basic Setup page such as Beacon
Interval, ontrol Tx Rates and Basic Data Rates.
Indice
Manuali Scheda di rete popolari di altre marche
Buffalo
Buffalo AirStation WLI-PCM-L11GP Manuale utente
National Instruments
National Instruments NI 9234 Manuale utente
Hama
Hama 49276 Manuale utente
Linksys
Linksys WCF54G - Wireless-G Compact Flash Card Manuale operativo
Compaq
Compaq Wireless LAN 100 Manuale utente
Bose
Bose PowerMatch Dante Manuale utente