Australia - 1800 316 962 | New Zealand 0800 218 020 Page 7
Using your LCD control panel
When the sauna is plugged into your wall
outlet the red Power Indicator light on the
control panel will be on. The Bluetooth audio
receiver on the roof will make a beeping
noise, its indicator light will turn on.
ON/OFF for Heaters: Push the POWER
button to turn the sauna heaters ON. The
various displays will come on. The sauna
heaters will remain ON until the timer runs
down to 00. The sauna heaters can be
turned OFF at any time by pushing the
POWER button.
Timer Adjustment: The default time is 60
minutes. Press + or - to change the Timer
setting. The maximum setting is 60 minutes.
The minimum setting is 5 minutes.
Pre Heat: Sun Stream Infrared Saunas are
typically used by preheating the sauna for
10-15 minutes to allow the heaters to reach
their optimum output, a starting temperature of 38-40°C is highly recommended.
The starting ambient temperature can affect the warmup time especially if the
sauna is located outside or in a cold environment.
Thermostat Adjustment: Press + or - to change the Thermostat setting. Increase
Press the + button to increase the temperature by 1°C increments. The maximum
setting is 65°C. Decrease Thermostat Setting by pressing the - button to decrease
the temperature by 1°C increments. The minimum setting is 25°C.
Thermometer/Thermostat Display: When the POWER button is turned ON the
digital display will show the Thermometer reading. Anytime the + and - buttons
are pushed the Thermostat setting display will show. After setting the thermostat
the display will return to displaying Thermometer reading.
Temperature Control: When the interior air temperature is below the Thermostat
set temperature, the heaters will remain ON. When the interior temperature is
higher than the Thermostat set temperature, the power to the heaters will be
turned OFF. The heater panels will begin to cool down, air temperature and
