System air VTK Airvent Manuale utente

Document in original language | · A001

VTK Airvent

Installation instructions GB

| A001

E&OE

Systemair AB reserves the rights to alter their products without notice.

This also applies to products already ordered, as long as it does not affect the previously agreed specifications.

| A001

Contents

1 Making holes for the duct..................................1

2 Mounting ......................................................1

3 Function........................................................1

4 Accessories....................................................2

4.1 Mounting washers..................................2

4.2 Filter change .........................................2

Making holes for the duct | 1

1 Making holes for the duct

Drill holes through the inner wall, dimensions according to the table. See image for suitable location.

VTK ø (mm)

80 85

100 105

125 130

160 165

2 Mounting

1. Cut the duct to adjust to the thickness

of the wall

2. Mount the duct through the wall and

use the fastening lugs to attach the duct

with two screws.

3. From the outside, push the wall grid

with extension against the wall duct. Use

filling material against the outer wall if

needed.

4. From the inside, push the airvent into

the duct. The gasket keeps the airvent in

place, no screws are necessary.

3 Function

VTK has a temperature sensitive and automatic thermostat that regulate the airvent plate and adjust the air gap and al-

so the amount of air depending on the outside temperature. The airvent opens less when cold outside. If the airvent is

in auto mode the supply of outside air decrease gradually down to -5° C.

When the temperature rises the airvent opens gradually and are fully open at +10° C. The setting can easily be ad-

justed. By turning the airvent’s plate from auto position; clockwise if you need it to close earlier or counter clockwise if

it should stay slightly open at temperatures under -5° C.

Locknut

Spring

Thermostat bulb Plate

Valve

Guide notch for auto mode

Condensation insulation

Guide

Stop for locking

guide notch

Drive pin

| A001

2|Accessories

4 Accessories

Filter and accessories are available at www.systemair.com.

4.1 Mounting washers

1. Turn the airvent’s plate counter clockwise from auto mode and detach.

2. Mount the washers to desired gap opening on the guide, add 2 mm (the stud on

the washer shall run in the track of the guide).

3. The washers are available in 2 and 4 mm thickness. A 4 mm washer provides 2

mm gap opening. One 4 mm + 2 mm washer provides a 4 mm gap opening.

4. Turn the plate to auto mode.

4.2 Filter change

It is recommended to change the filters between 1-3 years interval depending on placement and air quality.

1. Mount the filter first on the airvent. Ensure that the

filter encloses the venting house and the rubber seal.

2. Push the airvent and filter in to the duct.

3. If correctly mounted, the gasket should hold the

airvent firmly in the duct, no screws are necessary.

| A001

VTK Airvent · Installation instructions · · en_GB · 01-06-2017 · A001

Systemair Sverige AB

Industrivägen 3

SE-739 30 Skinnskatteberg, Sweden

Phone +46 222 440 00

Fax +46 222 440 99

www.systemair.com

Indice

Altri manuali System air Fan

System air

System air fantech SHR150 Manuale utente

System air

System air SAVE VTC 200 Manuale utente

System air

System air VTR 200 Manuale utente

System air

System air DVV-Ex Istruzioni operative

System air

System air SAVE VTR 100/B Manuale utente

System air

System air ERV RT-EC Series Manuale utente

System air

System air VSR 300 Manuale utente

System air

System air Sinus-G Manuale utente

System air

System air EX 140A Guida alla risoluzione dei problemi

System air

System air K-EF Series Manuale

System air

System air SAVE VTC 500 Manuale utente

System air

System air Topvex FR03 Manuale utente

System air

System air fantech bathfan Simple SMPL Series Manuale

System air

System air TA Series Manuale utente

System air

System air Fantech PRV Series Guida rapida

System air

System air Topvex SoftCooler TR Manuale utente

System air

System air K 100 M Manuale

System air

System air VR-250 EH/B/3 Manuale utente

System air

System air TFER K Guida alla risoluzione dei problemi

System air

System air SAVE CONNECT 2.0 Manuale del proprietario

System air

System air DVN 355 Manuale

System air

System air ZRS Series Manuale

System air

System air IV Manuale utente

System air

System air fantech FIT 120E Manuale utente

Manuali Fan popolari di altre marche

ELTA FANS

ELTA FANS H03VV-F Manuale utente

Hunter

Hunter 20714 Manuale di istruzioni

Emerson

Emerson CARRERA VERANDA CF542ORB00 Manuale utente

Hunter

Hunter Caraway Manuale di istruzioni

Panasonic

Panasonic FV-15NLFS1 Manuale utente

Kompernass

Kompernass KH 1150 Manuale utente

VES

VES FALA100/12V/TR Manuale utente

Vertiv

Vertiv Liebert DCD Manuale utente

Westinghouse

Westinghouse GFP Series Manuale utente

Venmar

Venmar KUBIX HRV PLUS Series Manuale utente

Maico

Maico ECR 31 Manuale utente

Sonnenkonig

Sonnenkonig Dinky Manuale utente

S&P

S&P ECOWATT HXBR Manuale utente

Wider

Wider IMP03369BH Manuale utente

Panasonic

Panasonic F-60DHN Manuale utente

Hinkley

Hinkley HIGHLAND Manuale utente

Broan

Broan 766BN Manuale utente

Premium

Premium PFS16022 Istruzioni per il montaggio