THIEYE CarView 4 Manuale utente
USER MANUAL
Dual Lens Mirror Dash Cam
CarView 4
USER MANUAL
Guide de démarrage rapide
Deutsche Anleitung
Guida di Operazione Rapida
取り扱い説明書Manual de usuario
Руководство пользователя
01
20
39
58
77
96
115
...........................................
.........................
......................................
........................
............................................
........................................
.........................
What’s Included English
Mirror Dash Cam Rear Camera
With 0.5M Cable
Rear Camera
Screw × 2
7.5M Rear
Camera Cable
GPS Module
Pry Tool 3M Glue For
Rear Camera
Mounting Strap × 4
User Manual
Car Charger
With Additional USB
EN 01
Layout
Reset
Front Lens
Power Button
Speaker
Rear Lens
1
2
3
4
5
Touch Screen
Back Clip Fixed Hook
Mini USB Port
Rear Camera Port
TF Card Slot
GPS Port
6
7
8
9
10
11
2
3 4
1
5
9 10 1186 7
EN 02
Installation Instructions
1.Insert A TF Card (Not included)
Supports up to 128GB (Over U1).
Please format the TF Card in the camera before first use.
Note：1.To keep your TF card in good condition, please format it regularly. As reformatting erases all of your
contents, be sure to back up your photos and videos first.
2.Please remove the TF card in the power-off state to avoid damage to the memory card.
3.To prevent the loss of important data, please pay attention to backup.
EN 03
2.Install the Mirror Dash Cam to the Car
3.Front Camera Installation Wiring Diagram
Or
EN 04
A
C
B
4.Install the Rear Camera
The installation location of rear camera is actually quite flexible, so there are some recommended locations with
different angles of visions.
A:Installed on the front windshield for in-car recording
B:Installed on the rear windshield for recording outside the car
C:Installed near the license plate for recording the rear areas of the car
Mount the rear camera properly
as shown in the picture
A
C
B
EN 05
Connecting the Red Wire with the Reversing Light
Please identify the wire that feeding the Reverse Light from the rear light cluster, although its placement may vary,
so be sure to refer to your car’s manual. Once spotted, use a pair of pliers or wire strippers to peel the rubber to
expose the live wire.
For safety, make sure you do this while the car is turned off. Tie the Red Trigger Wire with the positive terminal of
the correct wire and then wrap it with electrical tape.
Note:
1.DO NOT connect the Red Trigger Wire with Brake Light or Tail Light.
2.While on reverse gear, it will make the dash camera's screen automatically changes to the rearview in order to
view the reversing situation.
Note:
* The installation illustrations are for your reference only. The placement of the devices and cables may vary
depending on the car model. If you encounter any problems during installation, contact a skilled installer (such as
the service personnel of the car) for assistance.
Trigger Wire for Reverse Light (Red)
7.5 Meters Rear Camera Cable
AV Out
Connect to Dash Cam
Rear Camera
Mounting Bracket
EN 06
5.Connect to Power
Front Camera
Rear Camera
Rear Camera Cable (24ft)
The Red Wire
Car Charger
AV-IN Port
Mini USB Port
EN 07
Get Started
1.Power On / Off
①Auto Power On / Off with Ignition
When powered by the car charger, the dash cam will automatically turn on when you start your car engine.
When turning off your car, the camera will automatically turn off after approximately 5 seconds.
②Manual Power On / Off
To manually turn the camera On / Off, press and hold the power button at least 3 seconds.
Note: In low power status, the dash cam will automatically shut down after it displays low battery.
2.Screen On / Off
Simply press the Power Button once to switch the screen off when the Mirror Dash Camera is ON, press it again
or tap the touchscreen to wake the camera up.
Note: When recording, switch the screen off, the dash cam will also keep recording.
3.Touch Screen Overview
A D E FB C
EN 08
Indice
Altri manuali THIEYE Telecamera da cruscotto
