Timeguard NTTWIFI Manuale
JOB NUMBER TITLE PG VERSION DATE Size at 100%
XTIM2046 NTTWIFI Instructions 99 719/04/2018 120 x 90 @ 100%
DESIGNER Org A/W A/W AMENDS C: DATE:
ST ST, TM, ST
Installation & Operating Instructions
Wi-Fi Controlled Time Switch
Model: NTTWIFI
1
2
1. General Information
These instructions should be read carefully, in full, before installation.
Please note that all instructions are to be left with the customer
after installation.
Note: Timeguard reserve the right to alter these instructions,
and the SupplyMaster app, at any time.
Up to date instructions will always be available for
download at www.Timeguard.com.
2. Safety
• Before installation or maintenance, ensure the mains supply to the
time switch is switched off and the circuit supply fuses are removed
or the circuit breaker turned off.
• It is recommended that a qualified electrician is consulted or used
for the installation of this time switch and install in accordance with
the current IEE wiring and Building Regulations.
• Check that the total load on the circuit including when this time
switch is fitted does not exceed the rating of the circuit cable,
fuse or circuit breaker.
2
3
3. Technical Specifications
• 230V AC 50 Hz
• This time switch is of class I construction and must be earthed
• Switch Rating: 16A Resistive (3.68kW) Immersion Heaters
1kW Incandescent and Halogen lighting
500W Fluorescent lighting
100W Compact fluorescent
and LED lighting
• Contact Type: Normally Open, micro disconnection
• Wi-fi specification: 2.4GHz b/g/n
• Frequency Range: 2.412 – 2.484 GHz
• Operating Modes: Permanent ON or OFF, Auto timed, Holiday
• Boost Times: 1 or 2 hour
• Output Light: Yes
• Operating Temperature: 0°C to +40°C
• IP Rating: Intended for indoor use only
• CE compliant
• Dimensions (H x W x D): 120 x 74 x 42mm
Note: Not suitable for use with Discharge Lighting.
3
4
ON/OFF
indicator
Override
button
and Wi-Fi
connect
Terminal
cover
Wi-Fi
connection
indicator
Terminal
cover fixing
screw
Note: The timeswitch comes with a tamper proof cover
which is padlockable.
4
5
NTTWIFI MAC address and ID Wi-Fi number label
Important: Do not remove this label from the side of the product.
4. Contents
• 1x NTTWIFI time switch
• 2x Mounting screws
• 2x Cable clamp set
• 1x Plastic insert
• 1x Tamper-proof cover
• 1x Instruction manual
Note: all instructions are to be left with the customer after installation.
5. Installation
The NTTWIFI is a Wi-Fi controlled time switch which surface mounts.
There is provision for two front cables, with built in cable clamps.
The contacts are not volt free. There is a loop terminal for earth continuity.
5.1 Ensure the mains supply is switched off and the circuit supply
fuses are removed or the circuit breaker turned off.
5.2 Remove the terminal cover by undoing the fixing screw
on the bottom of the time switch.
5
6
5.3 Mark the position of the top wall mounting screw. Drill out the
top mounting hole taking care to avoid any joists, electrical cables
or water/gas pipes that may be hidden beneath the surface.
Insert the rawl plug into the hole.
5.4 Fix the top mounting screw and leave 2.5mm proud off of the wall.
5.5 Place the key hole in the top of the product, over the screw head,
and slide down.
5.6 Mark the position of the lower mounting hole on the wall using
the wall plate as a template.
5.7 Remove the product and drill out the lower mounting hole again
taking care to avoid any joists, electrical cables or water/gas pipes
that may be hidden beneath the surface. Insert the rawl plug into
the hole.
5.8 The 230V 50Hz supply and load cables can enter through the
rear knock outs or the front cable entry ports provided. If the rear
knock outs are being used, remove the blanking plates and pass
the supply and load cables through the holes.
5.9 Place the key hole in the top of the product again, over the screw
head, and slide down.
5.10 Secure the unit to the wall using the lower mounting screw.
If the wiring is through the front cable entry ports, use the cable
clamps provided to secure the supply and load cables.
5.11 Terminate the supply and load cables to the terminal block
ensuring correct polarity is observed and that all bare conductors
are sleeved. Please note the connections are marked beneath
the terminal block (see section 6. Connections).
5.12 Secure the terminal cover back into place using the fixing screw.
6
7
Neutral
Load
Terminal
(Blue or
Black)
Live Supply
Terminal
(Brown or
Red) 230V
50Hz
Neutral
Supply
Terminal
(Blue or
Black)
Loop
terminal
for earth
continuity
Green/
Yellow
Switched
Live Load
Terminal
(Brown or
Red)
6. Connections
• The terminals are marked as follows;
7
8
7. Setup
Note: the mobile or tablet device must be connected to a 2.4 GHz band
on the router. Pairing on the 5GHz band will result with paring either
timing out or being unsuccessful. Refer to your ISP (Internet Service
Provider) on separating the bands if required.
7.1 Ensure your phone or tablet is connected to your local
Wi-Fi network.
7.2 Download the Timeguard Supplymaster App onto your phone
or tablet by searching for Timeguard on Google Play store or
the Apple App store.
8
9
7.3 Install the App, and open it to the registration page.
7.4 Users must first register, and then log in to use App.
First time users must use the main account log in.
Note: User names and passwords cannot contain any
spaces or special characters, and must use letters and
numbers only.
7.5 Then, press the + button (bottom right on the phones screen
to open the add devices menu.
7.6 The Wi-Fi network the mobile or tablet is connected to will be
shown on the App, enter the password for the network SSID.
Important – DO NOT PRESS START AS OF YET.
7.7 On the NTTWIFI, hold down the override button, until the blue
LED light starts to flash.
7.8 Once the blue LED is flashing press start in the App.
The App will search for an available device.
7.9 Once the App has found and configured the NTTWIFI to the
network. the App will prompt the user to rename the device.
If this fails to happen the device name can be manually changed
at any time. From the devices menu swipe left on the device that
requires renaming, then press press edit. An editable name field
called ‘Name:’ will be shown under device information, tap the
field to rename the device. When the name has been changed
confirm this action by pressing the tick icon.
Note: If the device is to be sold, it must be deleted from
the App by the Main account holder. The device can only
be registered to one account at a time.
9
10
8. Features of the NTTWIFI Device
Micro Disconnection
• The unit offers micro disconnection of the load using the
programmed times.
• Micro disconnection can also be applied using the override switch
on the front of the unit.
Manual Override
• The override button on the front of the unit provides a permanent off,
or on, until the button is pressed again. It is not overridden by the
next program from the App.
• During the overridden period, the App will show permanent ON, or
permanent OFF. The override can be cancelled in the App by putting
the mode back to Auto Timed.
Light Indicators
• Red ON/OFF indicator. The red light will turn ON when there is
output, and will turn OFF when there is no output. The red light
will flash if there is output, but there is no output load detected.
• Blue Wi-Fi connection indicator. This will illuminate when the
device is connected to Wi-Fi, as detailed in section 7. Setup.
This indicator will flash slowly when attempting to connect to
the server.
Indice
Altri manuali Timeguard Timer
Timeguard
Timeguard ETU17 Manuale
Timeguard
Timeguard NTT02 Manuale utente
Timeguard
Timeguard NTT08 Manuale
Timeguard
Timeguard BoostMaster TGBT6 Manuale
Timeguard
Timeguard NTT08 Manuale
Timeguard
Timeguard TS840 Manuale utente
Timeguard
Timeguard MEU11 Manuale
Timeguard
Timeguard TG77 Manuale
Timeguard
Timeguard NTT03 Manuale
Timeguard
Timeguard NTDR1C16 Manuale utente
Timeguard
Timeguard SupplyMASTER FST11A Manuale
Timeguard
Timeguard NTT06 Manuale
Timeguard
Timeguard TG24 Manuale utente
Timeguard
Timeguard EL17 Manuale utente
Timeguard
Timeguard NTT06 Manuale
Timeguard
Timeguard TS800N Manuale
Timeguard
Timeguard FBT4 Manuale
Timeguard
Timeguard BoostMaster FBT4 Manuale
Timeguard
Timeguard ETU17N Manuale
Timeguard
Timeguard NTT03 Manuale
