LCD Module User Manual LMT080TDGP01
URL: www.topwaydisplay.com Document Name:LMT080TDGP01-Manual-Rev0.1
Page: 4 of 15
4. Terminal Function (Input Terminal)
Pin Symbol I/O Description Remark
1 NC - No Connect
2 VDD P Power Supply +3.3V
3 VDD P Power Supply +3.3V
4 NC - No Connect
5 RESET I Global reset pin
6 STBYB I Standby mode, Normally pulled high
STBYB = “1”, normal operation
STBYB = “0”, timing controller, source
driver will turn off, all output are GND
7 GND P Power Ground
R0~R5,G0
9 Rxin0+ I +LVDS differential data input
10 GND P Power Ground
11 Rxin1- I -LVDS differential data input G1~G5,B0,B1
12 Rxin1+ I +LVDS differential data input
13 GND P Power Ground
14 Rxin2- I -LVDS differential data input B2~B5,HS,VS,DE
15 Rxin2+ I +LVDS differential data input
16 GND P Power Ground
17 RxCLKIN- I -LVDS differential clock input LVDS clock
18 RxCLKIN+ I +LVDS differential clock input
19 GND P Power Ground
R6,R7,G6,G7,B6,B7(Co
nnect to GND in 6
bit mode)
21 Rxin3+ I +LVDS differential data input
22 GND P Power Ground
23 NC - No Connect
24 NC - No Connect
25 GND P Power Ground
26 NC - No Connect
28 SELB I 6bit/8bit mode select Pin Note2
29 AVDD P Power for Analog Circuit
30 GND P Power Ground
31 LED- P LED Cathode
32 LED- P LED Cathode
33 L/R I Horizontal Scanning direction setting Note3
34 U/D I Vertical Scanning direction setting Note3
35 VGL P Gate OFF Voltage
36 CABCEN1 I CABC H/W enable pin Note4
37 CABCEN0 I CABC H/W enable pin Note4
38 VGH P Gate ON Voltage
40 LED+ P LED Anode
Note:
I/O----definition, I----Input, O----Output, P----Power, No used I/O pin please fix to GND level .
Note1: PWM output after CABC function;
Note2: LVDS mode 6bits/8bits input select pin,If LVDS input data in 6 bits,SELB must be set to high,If LVDS input data in
8 bits,SELB must be set to low .
Note3: When L/R="0",set right to left scan direction, L/R="1" set left to right scan direction, source IC@6 o’clock . When
U/D="0",set top to bottom scan direction, U/D="1" set bottom to top scan direction source IC@6 o’clock .
Note4:
