Trendmedic TM-2000 Manuale utente

Model: TM-2000 .

TABLE OF CONTENTS

Introduction----------------------------------------------------------------------------------------

Correct Measurement---------------------------------------------------------------------------

Description of Parts------------------------------------------------------------------------------

Power Supply--------------------------------------------------------------------------------------

Operation-------------------------------------------------------------------------------------------

Accessories----------------------------------------------------------------------------------------

Error and Troubles-------------------------------------------------------------------------------

Important Notes-----------------------------------------------------------------------------------

Specifications--------------------------------------------------------------------------------------

Calibration and Record--------------------------------------------------------------------------

Precautions-----------------------------------------------------------------------------------------

Distribution Contact ------------------------------------------------------------------------------

Introduction

The device is intended to measure alcohol in the human breath. Measurements obtained by

this device are used in the diagnosis of alcohol intoxication.

The accuracy of this device has been established at a Blood Alcohol Concentration of 0.00,

0.20, 0.50 and 0.80‰BAC.

Preparation for Correct Measurement

•Before testing, wait at least 15 minutes after your last drinking.

•Only use the device in a temperature 5°C ~ 45°C or 40°F ~ 114°F.

Description of parts: LCD screen, Mouthpiece, Test button, Rating label, Battery cover

Power Supply

•Slide back the battery cover on the back of the device.

•Insert 2 piece AAA battery, making sure that the “+/-“symbols are correctly.

•

•If the power is too low, the unit may display a battery symbol “ “and the device may

not use correctly. You need to change a new battery.

Operation

(Test mode)

•Insert one of the mouthpieces into the ‘blow in’ hole.

•Press and hold the TEST button until power on. Release it after power on.

•The WAIT displays on the screen and countdown 10, 9, and 8… to zero.

•The BLOW displays on the screen, and displays “C” with flashing. Take a deep breath,

blowing steady into the mouthpiece until beeping stops (about 6 seconds).

•The device displays “WAIT” and flashing the “0” on the screen.

•Your test result will be displayed on the screen for 20 seconds.

•Your test result will be changed the color with beeping sound if above alarm limit.

•It will show error when incorrect blowing. Refer to the chapter of the “Errors and

Troubles” in detail. The device will be turned off after indicated error.

Accessories

•5 Mouthpieces

•Manual

•Soft carry bag

Important notes

•Before testing, wait at least 15 minutes after your last drinking.

•The blowing time must be enough until beeping stops.

•It may show ERR (error) if none, interrupt or shorter blowing.

•Recalibration interval suggest: 12 months or 800 tested times

•Never store the device in a corrosive gas room.

•Never store the device under sun exposure area.

•Avoid dropping or subjecting the device to a strong shock.

Errors or Troubles

Error

message

or Troubles

Description

Remarks

No display

-Press and hold the TEST button until power on.

-Check the battery and use alkaline battery only

Auto Off

-Low battery

-Over the period of test stage

Err

-Blowing unsteady or interrupt

-Blowing less than 6 seconds

-Blowing flow too weak

-No blow during BLOW mode.

-Low battery indication

-Need to change new battery

-Use alkaline battery only

Alarm sound

-During the blowing mode

-Error message indication

-Above alcohol set point

-Above tested times

-The blood alcohol content above the display range.

Specifications

Electrochemical sensor (Fuel Cell Sensor)

Blowing time about 6 seconds

Blowing flow about 10L/min

Blowing flow interrupt detection

Test counter to display the operated number when power on

4 digits display with status and backlight

Display range: 0.000-3.000‰

Show “HI” if above the display range

Accuracy: +/-0.05‰ at 0.50‰

5 replaceable mouthpieces

Warm up time: 10 seconds

Testing Time: 10 seconds

Repeat test: less than 30 seconds.

Audible sound and change LCD color if above alarm limit

Power supply: 2 pcs AAA 1.5V alkaline battery

Battery for standard testing is about 800 times

Low battery indication and auto power off function

Operation: 5°C ~ 45°C or 40°F ~ 114°F

Store: 0ºC ~ 50ºC or 32°F~122°F

Size: 105x55x23mm

Calibration and Record

•You should have your alcohol tester calibrated every 12 months or 800 tested times.

Failure to do so may cause your readings to be inaccurate.

Calibration Record

Date First

Used

Serial Number

Calibration Date

Remarks

Recalibration by

Precautions

•Your blood alcohol content (BAC) may change some minutes later.

•You should have your alcohol tester calibrated every 12 months or 800 tests. Failure to

do so may cause your readings to be inaccurate.

•Do not use this device to determine if you can drive.

•You cannot use the test results of device in court of law.

•You cannot use the test result of device against police’s unit.

Distribution Contact

Trendmedic

Nonnenwaldstr. 26A

D-82377 Penzberg

Germany

Phone: +49 (0) 8856 - 9377288

E-Mail: [email protected]

Web: www.trendmedic.de

Indice

Altri manuali trendmedic Apparecchiature di prova

trendmedic

trendmedic TM-9500 Professional Guida rapida

trendmedic

trendmedic TM-7500 Guida rapida

trendmedic

trendmedic TM-8500 Premium Guida rapida

Manuali Apparecchiature di prova popolari di altre marche

SMART

SMART KANAAD SBT XTREME 3G Series Manuale utente

Agilent Technologies

Agilent Technologies BERT Serial Manuale utente

Agilent Technologies

Agilent Technologies N3280A Manuale utente

Vernier

Vernier Go Direct Voltage Manuale utente

Lifeloc

Lifeloc R.A.D.A.R. Manuale utente

Fluke

Fluke T5-600 Istruzioni per l'uso e l'installazione

Mercury

Mercury TSL01 Manuale utente

MAHA

MAHA MBT Series Manuale utente

Fuji Electric

Fuji Electric P-61 Manuale utente

ETC

ETC SealerAtor Manuale utente

Skyfine

Skyfine ETHYWAY V2 Manuale utente

Appion

Appion G5 Twin Manuale utente

PCB Piezotronics

PCB Piezotronics 8159-0112A Manuale utente

BW Technologies

BW Technologies MicroDock II Manuale utente

Sun Nuclear

Sun Nuclear 1027 Manuale utente

Biomark

Biomark HPR LITE READER Manuale utente

Hioki

Hioki 3169-20 Manuale utente

Ashcroft

Ashcroft ATE-100 Manuale utente

trendmedic TM-2000 Manuale utente

Manuali Apparecchiature di prova popolari di altre marche