Vestil DCT-85 Manuale utente

Overhead Drum Carrier / Tilter Operating Instructions

IMPORTANT

1. Please read all instructions

THOROUGHLY before attempting to

operate your new drum carrier / tilter.

2. The model DCT-85 has a maximum

capacity rating of 1,500 lbs (680

kilograms) with a full drum and 900 lbs.

(408 kilograms) with a half-full drum.

This product is intended for lifting and

tilting drums of sized and type noted

above. DO NOT exceed these ratings as

the unsafe condition that may result could

cause damage, excessive wear or make

the product awkward to handle.

3. When operating, loading, unloading or

maintaining your drum carrier / tilter,

always have good footing and a firm hold

while using car and good judgment at all

times. Keep hands, loose clothing, etc.

clear and always from all moving parts.

Never allow anyone to be below any part

of a raised drum carrier / tilter or drum.

Read operating instructions before

operating.

OPERATING INSTRUCTIONS

1. Securely attach overhead hoisting hook to

loop of drum carrier / tilter.

2. Ensure carrier / tilter saddle is in the

horizontal position before loading or

unloading drum.

3. Open carrier / tilter saddle completely.

4. Lock drum in place by cinching chain

with ratchet tightener.

5. Ensure drum is in the vertical position for

safe transport.

6. To pour contents of drum: Pull on chain

to rotate drum to angle required to pour

contents. For best control of drum

pouring angle, pay out one side of the

chain loop while pulling in the other side.

7. After pouring, rotate drum back to

vertical position for safe transportation.

CAUTION!

-DO NOT exceed rated weight capacity of

1,500 lbs (680 kilograms) with a full

drum and 900 lbs (408 kilograms) with a

half-full drum.

-ALWAYS transport drum in the vertical

position.

-DO NOT allow drum to impact on floor

ground, dumping station, etc for possible

damage to drum and / or drum carrier /

tilter

MAINTENANCE

1. Lubricate gear-train once a month with a

high grade oil.

2. Oil saddle hinges, ratchet, pawl, chain

and other moving parts periodically.

3. Periodically inspect all moving parts,

framework and contact areas for signs of

wear, fatigue or loosening. Tighten,

adjust or replace parts as necessary to

prevent failure and maintain proper

function.

Model DCT-85

LIMITED WARRANTY

Vestil Manufacturing Corporation (“Vestil”) warrants this product to be free of defects in material and workmanship

during the warranty period. Our warranty obligation is to provide a replacement for a defective original part if the part is

covered by the warranty, after we receive a proper request from the warrantee (you) for warranty service.

Who may request service?

Only a warrantee may request service. You are a warrantee if you purchased the product from Vestil or from an

authorized distributor AND Vestil has been fully paid.

What is an “original part”?

An original part is a part used to make the product as shipped to the warrantee.

What is a “proper request”?

A request for warranty service is proper if Vestil receives: 1) a photocopy of the Customer Invoice that displays the

shipping date; AND 2) a written request for warranty service including your name and phone number. Send requests

by any of the following methods:

Mail Fax Email

Vestil Manufacturing Corporation (260) 665-1339 s[email protected]

2999 North Wayne Street, PO Box 507 Phone

Angola, IN 46703 (260) 665-7586

In the written request, list the parts believed to be defective and include the address where replacements should be

delivered.

What is covered under the warranty?

After Vestil receives your request for warranty service, an authorized representative will contact you to determine

whether your claim is covered by the warranty. Before providing warranty service, Vestil may require you to send the

entire product, or just the defective part or parts, to its facility in Angola, IN. The warranty covers defects in the

following original dynamic components: motors, hydraulic pumps, electronic controllers, switches and cylinders. It also

covers defects in original parts that wear under normal usage conditions (“wearing parts”): bearings, hoses, wheels,

seals, brushes, batteries, and the battery charger.

How long is the warranty period?

The warranty period for original components is 90 days. The warranty period begins on the date when Vestil ships the

product to the warrantee. If the product was purchased from an authorized distributor, the period begins when the

distributor ships the product. Vestil may extend the warranty period for products shipped from authorized distributors

by up to 30 days to account for shipping time.

If a defective part is covered by the warranty, what will Vestil do to correct the problem?

Vestil will provide an appropriate replacement for any covered part. An authorized representative of Vestil will contact

you to discuss your claim.

What is not covered by the warranty?

1. Labor;

2. Freight;

3. Occurrence of any of the following, which automatically voids the warranty:

 Product misuse;

 Negligent operation or repair;

 Corrosion or use in corrosive environments;

 Inadequate or improper maintenance;

 Damage sustained during shipping;

 Collisions or other incidental contacts causing damage to the product;

 Unauthorized modifications: DO NOT modify the product IN ANY WAY without first receiving written

authorization from Vestil. Modification(s) might make the product unsafe to use or might cause excessive

and/or abnormal wear.

Do any other warranties apply to the product?

Vestil Manufacturing Corp. makes no other express warranties. All implied warranties are disclaimed to the extent

allowed by law. Any implied warranty not disclaimed is limited in scope to the terms of this Limited Warranty.

Altri manuali Vestil Sistema di sollevamento

Vestil

Vestil VWS-770-AA Manuale utente

Vestil

Vestil HT-02-1616A Manuale utente

Vestil

Vestil FMDL Series Manuale utente

Vestil

Vestil AIR-1500-D Manuale utente

Vestil

Vestil WTJ-20 Series Manuale utente

Vestil

Vestil MH-V10 Manuale utente

Vestil

Vestil AHS Manuale utente

Vestil

Vestil CH-200 Series Manuale utente

Vestil

Vestil BBL-RK-72 Manuale utente

Vestil

Vestil FMDL Series Manuale utente

Vestil

Vestil DLH-CL2-1 Manuale utente

Vestil

Vestil SST-45 Guida rapida alla configurazione

Vestil

Vestil S-FORK-4-AT Manuale utente

Vestil

Vestil OLF-4-42 Manuale utente

Vestil

Vestil PRRJ-DOL Manuale utente

Vestil

Vestil LLH Series Manuale utente

Vestil

Vestil HDC-305 Series Manuale utente

Vestil

Vestil CART-1000D-DC Manuale utente

Vestil

Vestil DIE-2430-36 Manuale utente

Vestil

Vestil EHE-2 Manuale utente

Vestil

Vestil HLD Series Manuale utente

Vestil

Vestil SCTAB-FP Manuale utente

Vestil

Vestil EHLTD Series Manuale utente

Vestil

Vestil EHLTP-4864-2-60-D2 Manuale utente

Manuali Sistema di sollevamento popolari di altre marche

morse

morse 82H-124 Manuale utente

Braun

Braun NL955 Series Manuale utente

haacon

haacon 1889.10 Manuale utente

Protekt

Protekt AT 252 Manuale utente

R. Beck Maschinenbau

R. Beck Maschinenbau HS 600 Manuale utente

Nova Technology International, LLC

Nova Technology International, LLC NAS Series Manuale utente

Genie

Genie Z-60/34 Manuale utente

Screen Technics

Screen Technics INTERFIT Vertical Up Lift Manuale utente

Mortuary Lift

Mortuary Lift ULTIMATE 1000 Manuale utente

Custom Equipment

Custom Equipment Hy-Brid 3 Series Manuale di programmazione

Custom Equipment

Custom Equipment Hy-Brid Lifts 2 Series Manuale di programmazione

Hy-Brid Lifts

Hy-Brid Lifts HB-P3.6 Manuale di programmazione

BERG

BERG BeNomic EasyLeaf Manuale utente

Powermate

Powermate LiftGate LG-3 Manuale utente

Snorkel

Snorkel TM12 Series Manuale utente

Terberg

Terberg OMNIDEKA Manuale utente

Harmar Mobility

Harmar Mobility AL625 Istruzioni operative

Rotary

Rotary SPO16 Manuale utente