Viglen D925XCV Manuale utente
Page 1 of 17
Quick Start Guide
ViglenProductDescription:Intel D925XCV Motherboard
Viglen OrderCode:PMPCV001
Viglen System: GeniePro(S775)
•Productphoto
Page 2 of 17
Product specification.
Motherboard Form Factor D925XCV: ATX (10.20 inches by 9.60 inches [259.08 millimetres
by 243.84 millimetres])
Motherboard chipset Intel® 925X Chipset, consisting of:
. Intel® 82925X Memory Controller Hub (MCH)
. Intel® 82801FR I/O Controller Hub (ICH6-R)
. 8 Mbit Firmware Hub (FWH)
CPU connector type (s370,
slot1 etc) LGA775 socket
Number of CPUs supported 1
If >1 does it require a
terminator? No
Supported CPU types (C,
P3 or P4 etc) P4
Supported CPU speeds CPU No. CPU speed FSB L2 cache L3 cache
- 3.40 GHz 800 MHz 512 KB 2 MB
560 3.60 GHz 800 MHz 1 MB -
550 3.40 GHz 800 MHz 1 MB -
540 3.20 GHz 800 MHz 1 MB -
530 3 GHz 800 MHz 1 MB -
520 2.80 GHz 800 MHz 1 MB -
Front side bus speed 800MHz and 533MHz
Number of PCI slots 4
PCI slot speeds 33
Number of PCI-E slots 1 x PCI-E x16 and 2 x PCI-E x1
Number of AGP slots 0
Number of AMR slots 0
Additional slots 0
On board video fitted?
Type No
Ram size? 4GB
Upgradeable? Yes
Onboard audio fitted? Type
Intel® High Definition Audio subsystem using the Realtek
ALC860 audio codec.
Front facing audio header
and type Yes
Audio Upgradeable? Yes via PCI/PCI-E
Onboard network fitted?
Type Gigabit (10/100/1000 Mbits/sec) LAN subsystem using the
Marvel* Yukon* 88E8050 PCI Express* Gigabit Ethernet
Controller
Number of network
connections? 1
Upgradeable? Via PCI or PCI-E
Onboard SCSI fitted? Type No
No of channels? N/A
Manufacturer? N/A
Model Number? N/A
Speed? N/A
Number of IDE channels 1
Number of SATA channels 4
Maximum number of disks 6 (2 x IDE 2 x SATA) this would require full height ATX case
Rear I/O connectors 4 x USB 2 1 x MIC
Page 3 of 17
Note 2 x USB 2 front headers 1 x audio out
1 x serial 1 x audio in
1 x parallel 1 x PS2 mouse
1 x RJ45 LAN 1 x PS2 keyboard
1 x IEE1394 (plus one onboard
front header for an additional
port)
Memory type 240-pin DDR2 SDRAM DIMM sockets DDR2 400 and DDR2 533
For RIMMs install CRIMM in
empty sockets Na
Number of memory sockets Four 240-pin DDR2 SDRAM DIMM sockets
Maximum memory support Support for up to 4 GB of system memory
Supported memory speed DDR 2 5400and DDR2 533
MTBF 105,577 hours.
Note:
Trusted Platform Module (TPM)
The D925XCV motherboard incorporates the TPM “Trusted Platform Module”.
The Trusted Platform Module is a component on the desktop board that is specifically
designed to enhance platform security above-and-beyond the capabilities of today’s
software by providing a protected space for key operations and other security critical tasks.
Using both hardware and software, the TPM protects encryption and signature keys at their
most vulnerable stages — operations when the keys are being used unencrypted in plain-
text form. The TPM is specifically designed to shield unencrypted keys and platform
authentication information from software-based attacks.
Warning of Potential Data Loss!
The D925XCV motherboard incorporates the TPM “Trusted Platform
Module” this is disabled by default in the BIOS setup utility please
refer to the accompanied D925XCV motherboard manual.pdf,
TPMQuickReference.pdf and TPMFlyer.pdf.
Page 4 of 17
Upgradingand ESD precautions
WARNING
Unplug the system before carrying out the procedures described in this document. Failure
to disconnect power before you open the system can result in personal injury or
equipment damage. Hazardous voltage, current, and energy levels are present in this
product. Power switch terminals can have hazardous Voltages present even when the
power switch is off.
The procedures assume familiarity with the general terminology associated with personal
computers and with the safety practices and regulatory compliance required for using and
modifying electronic equipment.
Do not operate the system with the cover removed. Always replace the cover before
turning on the system.
As the colours of the wires in the mains lead of this computer may not correspond with the coloured
markings identifying the terminals in your plug proceed as follows:
The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked
by the letter Eor by the safety Earth symbol :or coloured green or green-and-yellow.
The wire which is coloured blue must be connected to the terminal which is marked with the letter Nor
coloured black.
The wire which is coloured brown must be connected to the terminal which is marked with the letter Lor
coloured red.
Make sure you are earthed and free of static charge before you open the computer case. If you are
unsure about upgrading your computer, return it to Viglen so a qualified engineer can perform the
upgrade.
CAUTION!
The Viglen D925XCV motherboard
and associated components are
sensitive electronic devices. A small
static shock from your body can
cause expensive damage to your
equipment.
Page 5 of 17
STEPS TO TAKE TO PREVENT STATIC DISCHARGE:
1. The best way to prevent static discharge is to buy an anti-static strap from your local electrical
shop. While you are wearing the strap and it is earthed, static charge will be harmlessly bled to
ground.
2. Do not remove the component from its anti-static protective packaging until you are about to
install it.
3. Hold boards by the edges - try not to touch components / interface strips etc.
Note:
We recommend that you return your computer to the service department for upgrading. Any work
carried out is fully guaranteed. Upgrades should only be carried out by persons who are familiar
with handling IC's, as incorrect installation will invalidate the guarantee.
Page 6 of 17
•SystemBoardComponents
Figure 1 Motherboard Layout & Components
Table 2.
A PCI Express x1 bus add-in card connectors R Power connector (24 way ATX2.2)
B Realtek ALC860 audio codec S Diskette drive connector
C Front panel audio connector T Parallel ATE IDE connector
D PCI Conventional bus add-in card
connectors U Battery
E Marvell Yukon 88E8050 PCI Express
Gigabit Ethernet Controller V Chassis intrusion connector
F PCI Express x16 bus add-in card connector W BIOS Setup configuration jumper block
G Rear chassis fan connector X 4 Mbit Firmware Hub (FWH)
H Back panel connectors Y Front chassis fan connector
I Alternate power connector (not used) Z Serial ATA connectors
J +12V power connector (ATX12V) AA Auxiliary front panel power LED
connector
K LGA775 processor socket BB Front panel connector
Page 7 of 17
L Hardware monitoring and fan control ASIC CC SCSI LED connector (optional)
M Processor fan connector DD Auxiliary power connector (not to be
used to power HDD’s optical drive’s etc
N Intel 82925X MCH EE Front panel USB connectors
O DIMM Channel A sockets FF Intel 82801FR I/O Controller Hub
(ICH6-R)
P DIMM Channel B sockets GG Speaker
Q I/O controller HH Auxiliary rear fan connector
•BackPanelConnectors 5.1Audio ALC860
Figure 2. Back Panel Connectors.
Table 3.
Item Description Item Description
A PS/2* mouse port (Green) G Mic in/Retasking Port B (Pink)
B PS/2 keyboard port (Purple) H USB ports (two)
C Serial port A (Teal) I IEEE-1394a (optional)
D Parallel port (Burgundy) J LAN
E Audio line in/Retasking Port C (Blue) K USB ports (two)
F Front left/right channel audio out/Two
channel audio line out/Retasking Jack
D [Lime green]
Note: The back panel audio line out connector is designed to power headphones or amplified
speakers only. Poor audio quality occurs if passive (non-amplified) speakers are connected to this
output.
Page 8 of 17
•Frontpanelconnections
The following are all connectors situated along the front edge of the motherboard. They are often
connected to buttons and LED’s situated on the front panel.
Reset Switch
+
Power Switch
Power LED H.D.D. LED
+
2
9
1
8
Front Panel
Connections Header
4
+1
Auxiliary Power LED
3Power LED
Figure 3. Front panel connectors
A-Hard Disk L.E.D. Connector
This goes to the Hard Disk L.E.D. on the front panel, which lights up when the IDE Hard Disk is in use.
B - Reset switch connector
When these pins are shorted, it will cause the computer to perform a cold reboot.
C - Power L.E.D.
This attaches to the power L.E.D on the front panel, to display if the computer is active or not.
D- Power On/Off
When these pins are shorted it turns the computer on and off.
Page 9 of 17
•MotherboardConnectors
There are connectors on the motherboard for FAN, IDE, Power supply, CD audio, Floppy, IDE, &
Front Panel Connectors. The location and/or details of these connections are shown below.
Figure 4. Motherboard Connectors
Page 10 of 17
•Jumpersettings
CAUTION Do not move any jumpers with the power on. Always turn off the power and unplug the power cord from the computer
before changing a jumper setting. Otherwise, the board could be damaged.
Figure 5. Motherboard jumper.
BIOS Setup Configuration Jumper (J6J3) Settings
The 3-pin jumper block determines the BIOS Setup program's mode. The table below describes the jumper settings for the three
modes: normal, configure, and recovery. When the jumper is set to configure mode and the computer is powered-up, the BIOS
compares the processor version and the microcode version in the BIOS and reports if the two match.
Table 4.
Function/Mode Jumper Setting Configuration
Normal 1-2 The BIOS uses current configuration information and passwords for booting.
Configure 2-3 After the POST runs, Setup runs automatically. The maintenance menu is
displayed.
Recovery None The BIOS attempts to recover the BIOS configuration. A recovery diskette is
required.
Indice
Altri manuali Viglen Scheda madre
Viglen
Viglen vig830s Manuale utente
Viglen
Viglen Vig103M Manuale utente
Viglen
Viglen VIG610M Manuale utente
Viglen
Viglen PMPLM001 Manuale utente
Viglen
Viglen Vig660W Manuale utente
Viglen
Viglen EQ100 Manuale utente
Viglen
Viglen Motherboard Vig390s Manuale utente
Viglen
Viglen Vig644M Manuale utente
Viglen
Viglen Vig665W Manuale utente
Viglen
Viglen Vig395p Manuale utente
Viglen
Viglen Vig770S Manuale utente
Viglen
Viglen L440GX+ Manuale utente
Viglen
Viglen VIG520S Manuale utente
Viglen
Viglen VIG555M Manuale utente
Viglen
Viglen Vig760S Manuale utente
Viglen
Viglen Vig451J Manuale utente
Viglen
Viglen Vig396M Manuale utente
Viglen
Viglen VIG615M Manuale utente
Viglen
Viglen Vig710W Manuale utente
Viglen
Viglen Vig535b Manuale utente
Manuali Scheda madre popolari di altre marche
Telit Wireless Solutions
Telit Wireless Solutions SL869-3DR Manuale utente
Gigabyte
Gigabyte GA-9IVDT Manuale utente
Texas Instruments
Texas Instruments ADS8372EVM Manuale utente
Commell
Commell MS-C73 Manuale utente
IBT Technologies
IBT Technologies MB860 Manuale utente
Nvidia
Nvidia TEGRA DG-04927-001_V01 Manuale utente
