WE-EF FLB141 1 LED Manuale utente
Surge Protection
This product features built-in surge protection circuitry in compliance with
applicable standards.
For comprehensive protection of a luminaire installation against lightning and
electrical surges, it is essential to cover mains supply and data input lines at
the distribution board level, by using respective primary (Type 1) and secondary
(Type 2) surge arrestors in compliance with EN61643-11/IEC61643-1.
Warning
Ensure that all required surge protection measures are in place and activated
prior to luminaire installation. Also, disconnect luminaires before operating
high-power devices such as, for example, electrical arc welders.
Do not open during installation
This product is factory-sealed.
Refer to the instructions contained in this
document for details.
WE-EF LEUCHTEN
Installation and Maintenance
Instructions
Floodlight
FLB141 #1 LED
1
Floodlight
FLB141 #1
IP66, IK08. Class I. ta = 40°C
Weight kg
for FLB141 #1 LED 3.1
Windage area m²
for FLB141 #1 LED 0.038
Orientation: all directions
Mounting Accessories
Flat surIace Ƃtter
SF-FLD1 for FLB141 #1 145-9535
ColuPn Ƃtter
CF-FLD1 for FLB141 #1 145-9536
2
Light Source
LED
Maintenance
Apart from cleaning the product’s exterior surfaces, no special maintenance work is required.
Do not use high-pressure cleaners.
In case of component failure due to abnormal circumstances or at end of life, replacement must be carried out
E\DVXLWDEO\TXDOLƂHGDQGWUDLQHGSURIHVVLRQDO
Warning: Do not open luminaire while mains supply is switched on.
3
Installation
The product must be installed and maintained by a
VXLWDEO\TXDOLƂHGSURIHVVLRQDOLQFRPSOLDQFHZLWKODWHVW
building/construction and/or electrical regulations and
relevant legislation.
Warning: Switch off mains electrical supply prior to
installing and connecting the luminaire.
Notice:,IWKHOXPLQDLUHLVPRGLƂHGE\DQ\ERG\RWKHU
than the original manufacturer, then the warranty will
no longer be valid and shall become the full respon-
sibility of the modifying person/organisation. Claims
based on defects attributable to improper installation
and/or application, and the consequences thereof, are
excluded.
The installation on site must comply with local and/or
national health and safety regulations.
4
1) Switch off mains electrical supply.
Installation Procedure
Installation tFlat surIace Ƃtter
3) FeedcableAfrom luminaireBthroughpivot and
KROHRIƃDWVXUIDFHƂWWHUC.
'HWHUPLQHSRVLWLRQVIRUƂ[LQJVFUHZVD. Drill
relevant holes Eand insert nylon plugs. Insert
and tighten screws D.
Warning: Ensure not to damage any electrical
cable, water pipe or other items drilling holes.
2) Check that rating shown on luminaire label
conforms with mains electrical supply.
(example)
FLB141-LED 220-240V50-60/Hz
161-XXXX SOE XXXXXXX
LED 3000K 18W item no. XXX
07/18 IP66
5
5) Loosen screws F6OLGHVOLSƂWWHURYHUSLYRW
while pulling cable Athrough hole.
8) Loosen screw G. Aim luminaire in desired
direction and tighten screw G.
6) Turn luminaire towards object to be
LOOXPLQDWHG(QVXUHVOLSƂWWHULVSURSHUO\
seated on pivot, then tighten screws F.
7) Connect cable Awith mains supply cable.
a) ON/OFF (L = Phase, N = Neutral,
= Earthing)
b) 1-10 V/DALI (L = Phase, N = Neutral,
= Earthing, DA/DA = DALI control line,
D–/D+ = 1-10 V control line).
6
1) Switch off mains electrical supply.
Installation - ColuPn Ƃtter
6XLWDEOHIRUFROXPQGLDPHWHUŰPP
6HUYLFHGRRURQFROXPQKDVWREHSURYLGHGIRUFDEOHWHUPLQDWLRQPD[LPXPPIURPFROXPQƂWWHUPRXQWLQJSRVLWLRQ
3) Drillscrewholes Aand cableentry hole Bon
column.Ensure cableentry hole BKDVVXIƂFLHQW
diameterto feedcable fromluminaire.
6HWDQGƂ[FROXPQƂWWHUCin position. Insert and
tighten screws D
2) Check that rating shown on luminaire label
conforms with mains electrical supply.
(example)
FLB141-LED 220-240V50-60/Hz
161-XXXX SOE XXXXXXX
LED 3000K 18W item no. XXX
07/18 IP66
7
5) Loosen screws F. Feedcable Dfromluminaire
Ethroughpivotand cable entryhole B.
Connectluminaire EZLWKFROXPQƂWWHUCby
VOLGLQJVOLSƂWWHURYHUSLYRW
8) Loosen screw G. Aim luminaire in desired
direction and tighten screw G.
6) Turn luminaire Etowards object to be
LOOXPLQDWHG(QVXUHVOLSƂWWHULVSURSHUO\
seated on pivot, then tighten screws F.
7) Connect cable Dwith mains supply cable.
a) ON/OFF (L = Phase, N = Neutral,
= Earthing)
b) 1-10 V/DALI (L = Phase, N = Neutral,
= Earthing, DA/DA = DALI control line,
D–/D+ = 1-10 V control line).
www.we-ef.com
WE-EF LEUCHTEN
Germany
Tel +49 5194 909 0
Fax +49 5194 909 299
info.germany@we-ef.com
WE-EF LUMIERE
France
Tel +33 4 74 99 14 44
Fax +33 4 74 99 14 40
info.france@we-ef.com
WE-EF HELVETICA
Switzerland
Tel +41 22 752 49 94
Fax +41 22 752 49 74
info.switzerland@we-ef.com
WE-EF LIGHTING
United Kingdom
Tel +44 844 880 5346
Fax +44 844 880 5347
info.uk@we-ef.com
WE-EF LIGHTING
Thailand
Tel +66 2 738 9610
Fax +66 2 175 2174
LQIRDVLDSDFLƂF#ZHHIFRP
WE-EF LIGHTING
Australia
Tel +61 3 8587 0444
Fax +61 3 8587 0499
info.australia@we-ef.com
WE-EF LIGHTING
United States of America
Tel +1 724 742 0030
Fax +1 724 742 0035
info.usa@we-ef.com
TO9250W0519 © WE-EF 2019
7HFKQLFDOVSHFLƂFDWLRQVDUH
subject to change.
Altri manuali per FLB141 1 LED
1
Indice
Altri manuali WE-EF Proiettore
WE-EF
WE-EF FLA740 LED Manuale utente
WE-EF
WE-EF FLC250 Manuale utente
WE-EF
WE-EF FLC210 LED Manuale utente
WE-EF
WE-EF FLA740 Manuale utente
WE-EF
WE-EF FLC240 Manuale utente
WE-EF
WE-EF FLB440 Manuale utente
WE-EF
WE-EF FLB141 4 LED Specifiche tecniche
WE-EF
WE-EF FLB400 Series Manuale utente
WE-EF
WE-EF FLC240 EVG Manuale utente
WE-EF
WE-EF FLA440 Series Manuale utente
WE-EF
WE-EF FLC220 LED Manuale utente
WE-EF
WE-EF FLC210 Manuale utente
WE-EF
WE-EF FLB141 Manuale utente
WE-EF
WE-EF FLB141 #6 LED Manuale utente
WE-EF
WE-EF FLA730 Manuale
WE-EF
WE-EF FLC200 LED Series Manuale utente
WE-EF
WE-EF FLC280 Manuale utente
WE-EF
WE-EF FLB141 2 LED Manuale utente
WE-EF
WE-EF FLA740 LED Manuale utente
WE-EF
WE-EF FLA740 LED Manuale utente
