(2) Method 2 【Menu linking】
Open TX system
【MODEL SETUP】-【External RF】-【Mode】When the protocol is set to CRSF, the function setting
will bedisplayed.Long press the transmitter 【SYS】key to enter the 【TOOLS】-
【Crossfire configure】-【WFLY TX】function interface.
In the WFLY TX interface, press the 【Bind】key to check the code.
2. Receiver
(1) Linking mode within 0.13 seconds after power-on
Note: The RF module status needs to be in the linking mode.
(2) Long press the 【SET】key to enter the link state, the indicator light state: the yellow
light flashes.
Note: After the code is successfully link, if you need to enter the link again, the receiver
needs to be powered on again. Long press【SET】key to exit the linking mode.
Ⅳ. Telemetry interface
When the module is connected to the receiver normally, long press the 【MDL】key to
jump to the 【TELEMETRY】telemetry interface.
Shenzhen WFLY Technology Development Co., Ltd
C3 Buliding,Xiangli Industry Park,Heping Haoye Road,Fuyong
Town,Baoan District,Shenzhen,Guangdong Province,China
Scan the code to
download the details
CROSSFIRE SETUP
WFLY TX
WFLY RX
WFLY TX
Set Failsafe
Bind
Bind.Parameter
Re-Flag
Re-Num
TX .Power
Transfer_Mode
L_Freq
H_Freq
Firmware:
Enable
1
5mW
P2P
1
100
V1.0.1
WFLY ET16/S
Function path: 【Linkage setting】-[Bind】
①The built-in module is set to 【Disabled】
②Set the external module to【W.CRSF】
③Click 【Start】to check the code.
Ⅴ.
Technical parameters
Product model: MG216
Suppor：ET16 ET16S Open TX
（Includes JR slo）
Frequency band：2.4GHz
working frequency：2.400-2.483 GHz
Modulated emission：LoRa
Adjustable position：Power adustable
Transmit power：20dBm
Flying range：>3km（No interference,
open area）
High refresh rate：200/135Hz
Delay：5ms（CRSF）
Set interface：Support LUA script
（OpenTX）
Wireless protocol：Third Generation
Signal input：CRSF、S.BUS、PPM
Transmission channel：16
Antenna type：External single antenna
Antenna interface：Internal thread inner hole
Antenna gain：3dbi
Power supply range：3.5~13V
Power consumption：0.36W
Weight：45.0g (including antenna)
Online upgrade：Suppor
Product dimensions：65mm*53mm22mm
Installation slot size：60.mm*45mm19.5mm
TOOLS
01 Crossfire configure
02 FrSky GaSuite
03 FrSky SBEC
04 FrSky SxR
05 Graupner HoTT
06 Spectrum(INT)
