Whadda WPM307 Manuale utente

USER MANUAL

RGB LED module

WPM307

whadda.com

Introduction

To all residents of the European Union

Important environmental information about this product

This symbol on the device or the package indicates that disposal of the device after its

lifecycle could harm the environment. Do not dispose of the unit (or batteries) as unsorted

municipal waste; it should be taken to a specialized company for recycling. This device

should be returned to your distributor or to a local recycling service. Respect the local

environmental rules.

If in doubt, contact your local waste disposal authorities.

Thank you for choosing Whadda! Please read the manual thoroughly before bringing this

device into service. If the device was damaged in transit, do not install or use it and contact

your dealer.

Safety Instructions

Read and understand this manual and all safety signs before using this appliance.

For indoor use only.

•This device can be used by children aged from 8 years and above, and persons with

reduced physical, sensory or mental capabilities or lack of experience and knowledge if

they have been given supervision or instruction concerning the use of the device in a

safe way and understand the hazards involved. Children shall not play with the device.

Cleaning and user maintenance shall not be made by children without supervision.

General Guidelines

•Refer to the Velleman®Service and Quality Warranty on the last pages of this manual.

•All modifications of the device are forbidden for safety reasons. Damage caused by

user modifications to the device is not covered by the warranty.

•Only use the device for its intended purpose. Using the device in an unauthorized way

will void the warranty.

•Damage caused by disregard of certain guidelines in this manual is not covered by the

warranty and the dealer will not accept responsibility for any ensuing defects or

problems.

•Nor Velleman Group nv nor its dealers can be held responsible for any damage

(extraordinary, incidental or indirect) –of any nature (financial, physical…) arising from

the possession, use or failure of this product.

•Keep this manual for future reference.

What is Arduino®

Arduino®is an open-source prototyping platform based on easy-to-use hardware and

software. Arduino®boards are able to read inputs –light-on sensor, a finger on a button or a

Twitter message –and turn it into an output –activating of a motor, turning on an LED,

publishing something online. You can tell your board what to do by sending a set of

instructions to the microcontroller on the board. To do so, you use the Arduino

programming language (based on Wiring) and the Arduino®software IDE (based on

Processing). Additional shields/modules/components are required for reading a twitter

message or publishing online. Surf to www.arduino.cc for more information.

Product Overview

RGB LED module with on-board current limiting resistors.

Specifications

•voltage: 5 VDC

•connection: 4-pin male header

•pins: GND, RED, GREEN, BLUE

•dimensions: 24 x 16 x 16 mm

•weight: 2 g

Connection

Arduino®

WPM307

D11

D10

GND

Coding

Whadda WPM307 RGB LED Module Arduino example code

This Arduino demo will fade the red, green and blue channels of the RGB LED module in

and out.

For more information about the Whadda WPM307 RGB LED Module, consult the manual,

available online at whadda.com

Example based on Arduino fade example:

This example code is in the public domain.

http://www.arduino.cc/en/Tutorial/Fade

// define colors

#define RED 0

#define GREEN 1

#define BLUE 2

// define RGB LED Pins

int rgbLed[] = {10, 11, 9}; // Pin mapping of the Red, Green and Blue LED channels

void setup() {

// Set all of the pins of the RGB LED to OUTPUT

for(int i=0; i<3; i++) {

pinMode(rgbLed[i], OUTPUT);

}

void loop() {

// fade RED LED in from min to max in increments of 5 points:

for (int fadeValue = 0 ; fadeValue <= 255; fadeValue += 5) {

// sets the value (range from 0 to 255) of the RED LED:

analogWrite(rgbLed[RED], fadeValue);

// wait for 30 milliseconds to see the dimming effect

delay(30);

}

// fade RED LED out from max to min in increments of 5 points:

for (int fadeValue = 255 ; fadeValue >= 0; fadeValue -= 5) {

// sets the value (range from 0 to 255) of the RED LED:

analogWrite(rgbLed[RED], fadeValue);

// wait for 30 milliseconds to see the dimming effect

delay(30);

}

// fade GREEN LED in from min to max in increments of 5 points:

for (int fadeValue = 0 ; fadeValue <= 255; fadeValue += 5) {

// sets the value (range from 0 to 255) of the GREEN LED:

analogWrite(rgbLed[GREEN], fadeValue);

// wait for 30 milliseconds to see the dimming effect

delay(30);

}

// fade GREEN LED out from max to min in increments of 5 points:

for (int fadeValue = 255 ; fadeValue >= 0; fadeValue -= 5) {

// sets the value (range from 0 to 255) of the RED LED:

analogWrite(rgbLed[GREEN], fadeValue);

// wait for 30 milliseconds to see the dimming effect

delay(30);

}

// fade BLUE LED in from min to max in increments of 5 points:

for (int fadeValue = 0 ; fadeValue <= 255; fadeValue += 5) {

// sets the value (range from 0 to 255) of the BLUE LED:

analogWrite(rgbLed[BLUE], fadeValue);

// wait for 30 milliseconds to see the dimming effect

delay(30);

}

whadda.com

Modifications and typographical errors reserved - © Velleman Group nv. WPM307_v01

Velleman Group nv, Legen Heirweg 33 - 9890 Gavere.

Indice

Altri manuali Whadda Unità di controllo

Whadda

Whadda WPM402 Manuale utente

Whadda

Whadda Arduino 3.3 V Manuale utente

Whadda

Whadda WPI302 Manuale utente

Whadda

Whadda WPI322 Manuale utente

Whadda

Whadda WPI425 Manuale utente

Whadda

Whadda WPSE353 Manuale utente

Whadda

Whadda WPM349 Manuale utente

Whadda

Whadda WPI405 Manuale utente

Whadda

Whadda WPM400 Manuale utente

Whadda

Whadda DS1302 Manuale utente

Whadda

Whadda WPI317 Manuale utente

Whadda

Whadda WPSE325 Manuale utente

Whadda

Whadda WPI430 Manuale utente

Manuali Unità di controllo popolari di altre marche

Festo

Festo Compact Performance CP-FB6-E Manuale elenco delle parti

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuale utente

JS Automation

JS Automation MPC3034A Manuale utente

JAUDT

JAUDT SW GII 6406 Series Guida rapida

Spektrum

Spektrum Air Module System Manuale utente

BOC Edwards

BOC Edwards Q Series Manuale utente

KHADAS

KHADAS BT Magic Manuale utente

Etherma

Etherma eNEXHO-IL Manuale utente

PMFoundations

PMFoundations Attenuverter Manuale utente

GEA

GEA VARIVENT Manuale utente

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuale utente

Altronix

Altronix LINQ8PD Istruzioni per il montaggio

Eaton

Eaton Powerware Series Manuale utente

WAGO

WAGO 750-407/040-000 Manuale utente

Sony

Sony CCU-590 Manuale utente

Graco

Graco 25D614 Manuale utente

Task Force Tips

Task Force Tips YE-RF-900 Manuale di programmazione

Shini

Shini SPV-U Series Manuale utente