WinBridge H5 Plus Manuale utente
PORTABLE PA SYSTEM
USER MANUAL
H5 Plus
M
: Press one time to switch modes among UHF, Bluetooth, FM and
USB drive play; ( If you plug USB drive )
: Previous
: Next
: Pause/Resume; Under any mode, Double click to turn on/off voice
prompt, there will be a“Di”sound.
: Long press to start to recording; Short press to play recording or
switch to play USB drive/TF card music.
Mode switching
MIC Volume
ECHO Volume
Previous
Play/pause
USB
Record
Next
: Turn on/off speaker; Control music volume;
1
MIC
DC 9V TF Card
AUX
Pair Key
……………………………
…………………………
How to disassemble the wireless mic:
2
Transmitter:
3
Noted:
The transmitter is used with lapel mic or stand mic, and only one
microphone can be used with the speaker at the same time, which means
if you have paired the headset, you can not use the transmitter, that you
can not use lapel mic or stand mic.
Volume -
Pairing key
Charing indicator
Volume +
Power ON/OFF
DC 5Vport
Press to change mode
(except Recording mode).
MODES
Noted: When connected, by long press wifi button on the mic or long
press the M button on the speaker would disconnect with speaker.
Please refer above steps to re pair mic with speaker manually again.
…………………
How to Pair Wireless Headset Microphone
Turn on U8 wireless headset
microphone with BIue light
becomes constantly lights.
Turn on speaker, short press M button to switch to UHF mode with
screen shows: , then long press M button again for 3 seconds
to enter UHF pairing mode with voice prompt: “UHF is waiting for
connection...”, meanwhile UHF indicator become flashes.
Do a press on the small silicone button wifi on the headset until
speaker prompt: “ UHF is connected”, then you could start to
enjoy it.
4
Noted:
In a small room, when you using lapel microphone, you
will experience feedback noise easily when your volume
is high because the sound will easily bounce from walls
and ceiling and feedback to the microphone. In order to
avoid feedback or howling, volume level needs to be
adjusted depending on the area you are using. Please
try again by increasing volume level slowly to a point just
below you hear feedback noise.
Noted:
If the transmitter and speaker are too close, the howling will be very
loud. Please do not face the front of the speaker at close range. You
can use the MIC volume wheel on the speaker and "-" button on the
transmitter to lower the volume to reduce the howling.
Turn on transmitter
and speaker
Turn on speaker, short press M button to switch to UHF mode with
screen shows: , then long press M button again for 3 seconds
to enter UHF pairing mode with voice prompt: “UHF is waiting for
connection...”, meanwhile UHF indicator become flashes.
Long press on the small silicone button wifi on the transmitter
until speaker prompt: “ UHF is connected”
Plug lapel mic or stand mic into transmitter to use.
How to Use Wireless Lapel/Stand Mic System
……………
5
M
………………………………………………………
How to Play FM ?
Click to switch to FM
mode with a screen
shows like ,
and there will be voice
prompts: FM Mode
Long press for about 3s to start automatic channel search
The search will last about 1 min, just leave it before it’s done.
There will be several or dozens of channels. (The amount depends
on the area. )
Each channel is given a sequence number (in ascending order of
frequency )
For example, = Channel 3
Click to play previous/next channel;
DC 5 V
MI C
M
M
……………………………………………
How to Play Recording ?
Prerequisite: require a USB drive or TF card for storage and a
microphone for input.
Under any mode, long press ( 3s) button to start recording;
There will be a voice prompts “Start recording.”
And the screen shows like this
Connect with wireless mic or plug in an external wired mic to talk with it.
Click button to finish and save recording; At this point, it will play
recording file automatically you just made;
Please click button to pause/resume;
Click to play previous/next recording;
Click again to play USB drive/TF card music.
Click button to quit recording and switch to other modes;
USB
REC
6
Music Play
Supports: Refer to
MODES
Bluetooth USB
flash drive
micro
SD card
3.5mm
audio cable
M
Click to switch to Bluetooth
mode with a screen shows
, and there will
be voice prompts:
Bluetooth is waiting for connection;
Turn on Bluetooth device and search named“H5”to pair.
…………………………………………
How to Connect Blueooth ?
DC 5 V
MI C
M
M
Turn on two H5 speakers, click button to enter Bluetooth mode,
long press one of speaker’s M button to enter pairing status, the
other one Bluetooth indication become solid lights means these two
speakers are connected successfully.
Turn on your phone or Bluetooth device and search named“H5”
to pair.
……………………………………………………
How to Play TWS ?
7
How to Play Aux
AUX
3.5mm
audio cable
plug the 3.5mm audio cable into the AUX hole.
connect to any device with 3.5mm audio output
Audio Format supported:
MP3 WAV WMA APE FLAC
Just connect a USB drive or TF card,
then speaker will play music
automatically. Please make sure your
USB or TF card have music files.
………………………………
How to Play USB drive or TF card
USB
flash drive micro
SD card
8
Indice
