2B Technologies UV-106W Manuale utente
BTechnologies, Inc.2
UV-106W-Aqueous Ozone Monitor™
Quick Start Guide
1) Mount the instrument upright. If there is no structure to mount the instrument to, set it on a block
on the bench-top to keep it level and provide access to the ports on the bottom.
2) Attach the electrical inputs and outputs:
a. Power (required): Use the included AC-12V DC power pack and attach it to the barrel
connector on the cable
b. Serial (optional): Attach one end of the included serial cable to the serial connector on
the cable and the other end through the USB to serial converter to a computer. Open the
desired terminal program (we recommend TeraTerm) and select the appropriate COM
port.
i. The settings on this COM port should be: 38400 baud rate, 8-bits, no parity, 1
stop bit.
c. 4-20mA (optional): The purple wire is the positive side of the 4-20mA output and the
white wire is the ground. See manual for setting the range on this output
d. 0-2.5V (optional): The orange wire is the positive side of the 0-2.5V output and the white
wire is the ground. See manual for setting the range on this output.
3) Attach the tubing connections:
a. Drain: Attach tubing from the drain outlet to waste.
b. Sample Inlet: Attach ozone compatible tubing to the sample inlet port. This tubing should
be as short of a length as possible from your main system in order to reduce response
time.
c. Return: If you are returning this to your system, you should use ozone compatible tubing
and make sure it attaches to a point in your system that is lower pressure than where
you attached the sample line. Otherwise, send to waste.
d. Air Inlet: If the instrument is being used in a hose-down environment, attach tubing and
run it to an area that will not be exposed to water. Otherwise leave open.
e. Air exhaust: If the instrument is being used in a hose-down environment, attach tubing
and run it to an area that will not be exposed to water. Otherwise, leave open.
4) Allow for warmup period:
a. Turn the instrument on and allow it to warmup for 10-20 minutes before taking ozone
measurements.
Indice
Altri manuali 2B Technologies Strumento di misura
2B Technologies
2B Technologies 306 Manuale di installazione
2B Technologies
2B Technologies 405 nm Manuale utente
2B Technologies
2B Technologies AQSync Manuale utente
2B Technologies
2B Technologies POM Manuale utente
2B Technologies
2B Technologies 211 Manuale utente
2B Technologies
2B Technologies Ozone Monitor 106-L Manuale utente
2B Technologies
2B Technologies 211 Manuale utente
2B Technologies
2B Technologies OEM-106-H Manuale utente
2B Technologies
2B Technologies 106-H Manuale utente
