ABB SREA-01 Guida alla risoluzione dei problemi

ABB Drives

Quick Start-up Guide

SREA-01 Ethernet Adapter Module

3AUA0000042902 Rev A

Effective: 01.10.2008

Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]

SREA-01 Quick Start-up Guide

1. Connecting power and network

Connect 9–28 V AC/DC to Vin+ and Vin-.

Connect a cross-over Ethernet cable directly to the unit for start-

up. You can use a network after you have configured the unit.

2. Connecting to SREA-01 over Ethernet

The default Ethernet configuration is:

IP address: 10.200.1.1

Subnet mask: 255.255.255.0

Username: admin

Password: admin

Connection method 1:

Configure your PC to the same subnet (e.g. IP address 10.200.1.2

and subnet mask 255.255.255.0).

Use Internet Explorer or Mozilla Firefox and go to location

http://10.200.1.1.

Connection method 2:

Install the ABB IP Configuration Tool from the attached CD. When

you start the program, it will search for connected SREA-01

modules. You can change the network settings of the module by

double clicking it.

Use Internet Explorer or Mozilla Firefox and go to location

http://<ip of the SREA-01 module>, e.g. http://10.200.1.1.

Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]

SREA-01 Quick Start-up Guide

3. Connecting drive(s)

If you have a single ACS350, ACH550 or ACS550, it is easiest to

use the supplied RJ45 cable to connect to the panel port.

If you have multiple drives or an ACS800, use the RS-485

connection. Connect the A- channels of the SREA-01 unit and the

drives together, the B+ channels together and the COM connector

to the data ground connectors of the drives. Use 120 ohm

terminating resistors in the network.

4. Basic drive settings

Check the communication settings of the drive (either group 52 or

53 in most drives, depending on the connection type).

Station id/number has to be unique for each drive! The baud rate

selection and parity have to be same on all drives and

SREA-01. You can use for example 9600 bit/s, no parity, 1 stop bit.

5. Basic SREA-01 settings

You can change the Ethernet settings under Setup – Ethernet.

Select the correct drive connection settings under Setup –

Modbus.

• Select Physical Interface.

• Usually most other settings are suitable by default (RTU,

9600 bps, no parity, 1 stop bit).

SREA-01

X1 pin Wire

Panel port

RJ45 pin

RX (RS-232) white-orange 1

TX (RS-232) white-blue 3

COM orange and blue 2 and 6

X1 RS-232: Select EIA-232

X1 RS-485: Select EIA-485

X2: Select EIA-232 D-sub

Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]

SREA-01 Quick Start-up Guide

To search for connected drives, go to page Configuration –

Devices and select autodetect.

6. More information

For more detailed information, please refer to the SREA-01 User’s

Manual located on the attached CD-ROM.

Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]

Altri manuali per SREA-01

Indice

Altri manuali ABB Unità di controllo

ABB

ABB ACS880-14 Manuale utente

ABB

ABB ACSM1 Series Manuale utente

ABB

ABB BCU-02 Manuale utente

ABB

ABB ACS880-04 drive modules Manuale utente

ABB

ABB Baldor BC141 Istruzioni per l'installazione

ABB

ABB FECA-01 EtherCAT Manuale di installazione

ABB

ABB Tina 5A Manuale utente

ABB

ABB RMBA-01 Manuale utente

ABB

ABB Busch-priOn Series Manuale del prodotto

ABB

ABB XIO-00 Manuale utente

ABB

ABB Relion SAM600-IO Manuale utente

ABB

ABB Relion SAM600 Istruzioni per l’uso

ABB

ABB FENA-01 Manuale di installazione

ABB

ABB 616016-T2 Manuale per l'uso e la cura

ABB

ABB ACS880-1604LC Manuale utente

ABB

ABB i-bus EIB Manuale utente

ABB

ABB Relion SAM600-IO Manuale utente

ABB

ABB Relion 630 Series Guida rapida

ABB

ABB i-bus KNX Manuale utente

ABB

ABB FCAN-01 Manuale di installazione

ABB

ABB RTAC-01 Manuale utente

ABB

ABB FAIO-01 Manuale utente

ABB

ABB ACS850 series Manuale utente

ABB

ABB ACS880-04 drive modules Manuale utente

Manuali Unità di controllo popolari di altre marche

Festo

Festo Compact Performance CP-FB6-E Manuale elenco delle parti

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Manuale utente

JS Automation

JS Automation MPC3034A Manuale utente

JAUDT

JAUDT SW GII 6406 Series Guida rapida

Spektrum

Spektrum Air Module System Manuale utente

BOC Edwards

BOC Edwards Q Series Manuale utente

KHADAS

KHADAS BT Magic Manuale utente

Etherma

Etherma eNEXHO-IL Manuale utente

PMFoundations

PMFoundations Attenuverter Manuale utente

GEA

GEA VARIVENT Manuale utente

Walther Systemtechnik

Walther Systemtechnik VMS-05 Manuale utente

Altronix

Altronix LINQ8PD Istruzioni per il montaggio

Eaton

Eaton Powerware Series Manuale utente

WAGO

WAGO 750-407/040-000 Manuale utente

Sony

Sony CCU-590 Manuale utente

Graco

Graco 25D614 Manuale utente

Task Force Tips

Task Force Tips YE-RF-900 Manuale di programmazione

Shini

Shini SPV-U Series Manuale utente