Aeris A100 Manuale utente
Surface Main
(after Dive # 2)
<< WARNING >>
You must read and understand the Operating Manual (on the enclosed
CD) and the Dive Computer Safety and Reference Manual (booklet
enclosed) before diving with this product.
Press the button (B) to activate.
Once 10 minutes elapse, while on the suface prior to a dive, operation enters
Power Saver Mode (PSM) until the button is pressed to resume operation.
Surface Sequence:
MAIN >> ALT 1 > ALT 2 > FLY/DESAT > LOG > SET GAS > SET ALM > SET UTL > ID.
• Press & release repeatedly
to step through the Surface
Sequence.
• Press & hold (2 sec) to access
Sequence selections.
• Press & release repeatedly to
increase setting values.
• Press & hold (2 sec) to save or
accept setting values.
B
B
© 2002 Design, 2012 Doc. No. 12-7272-r01 (4/27/12)
Dive Main
(No Deco Nitrox)
<< NOTE >>
Dives begin automatically upon descent to 5 FT (1.5 M) for 5 seconds.
Upon ascent to 2 FT (0.6 M) for 1 second, operation shifts to Surface Mode.
Once 10 minutes elapse after surfacing from a dive, another descent is
considered a new dive.
Once 20 minutes elapse after surfacing from a dive, operation enters Power
Saver Mode (PSM) until the button is pressed to resume operation.
• Press & release - to view ALT 1
(Max Depth, Elapsed Dive Time).
• Press & release again - to view
ALT 2 (O2 data).
• Press & release again - to revert
to Dive Main.
B
B
Indice
Altri manuali Aeris Strumento di misura
