AOpen AP5V Manuale utente
AP5V
Mainboard
User Guide
Copyright
ii
Copyright 1996 by this company. All rights reserved. No part of this
publication may be reproduced, transmitted, transcribed, stored in a retrieval
system, or translated into any language or computer language, in any form or
by any means, electronic, mechanical, magnetic, optical, manual or otherwise,
without the prior written permission of this company.
Disclaimer
iii
This company makes no representations or warranties, either expressed or
implied, with respect to the contents hereof and specifically disclaims any
warranties, merchantability or fitness for any particular purpose. Any software
described in this manual is sold or licensed "as is". Should the programs prove
defective following their purchase, the buyer (and not this company, its
distributor, or its dealer) assumes the entire cost of all necessary servicing,
repair, and any incidental or consequential damages resulting from any defect
in the software. Further, this company reserves the right to revise this
publication and to make changes from time to time in the contents hereof
without obligation to notify any person of such revision or changes.
Intel and Pentium are registered trademarks of Intel Corporation.
XT/AT is a registered trademark of International Business Machines Corporation.
Other brand and product names are trademarks and/or registered trademarks of their
respective holders.
FCC Statement
iv
FCC Class B Radio Frequency
Interference Statement
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
4. Consult the dealer or an experienced radio/television technician for help.
Notice 1:
The changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
Notice 2:
Shielded interface cables, if any, must be used in order to comply with emission
limits.
About This Manual
v
Purpose and Scope
This manual tells how to install and configure the system board.
Organization
This manual consists of three chapters and one appendix:
Chapter 1, Overview, covers the specifications, layout, and components of the
system board.
Chapter 2, Hardware Installation, tells how to install the hardware
components, configure the system by resetting the jumpers, install the system
board and add expansion cards.
Chapter 3, AMI BIOS Utility, explains the system BIOS and tells how to
configure the system by setting the BIOS parameters.
Appendix A, Jumper and Connector Summary, gives you a tabular summary
of the jumper settings and onboard connectors discussed in Chapter 2.
About This Manual
vi
Conventions
The following conventions are used in this manual:
Text entered by user,
default settings,
recommended selections
Represent text input by the user, default
settings and recommended selections
a, e, s, etc Represent the actual keys that you
have to press on the keyboard.
NOTE
Gives bits and pieces of additional
information related to the current topic.
WARNING
Alerts you to any damage that might
result from doing or not doing specific
actions.
CAUTION
Suggests precautionary measures to
avoid potential hardware or software
problems.
IMPORTANT
Reminds you to take specific action
relevant to the accomplishment of the
procedure at hand.
TIP
Tells how to accomplish a procedure
with minimum steps through little
shortcuts.
Table of Contents
vii
Chapter 1 Overview
1.1 Board Layout ........................................1-2
1.2 Specifications.......................................1-3
1.3 System Board Parts .............................1-4
1.3.1 Microprocessor.................................1-4
1.3.2 ASICs...............................................1-4
1.3.3 BIOS ................................................1-4
1.3.4 Expansion Slots ...............................1-5
1.3.5 DRAM Sockets.................................1-5
1.3.6 Second-level Cache.........................1-5
1.3.7 Two-channel PCI Mode 4
Enhanced IDE Interface...................1-5
1.3.8 Super I/O Controller.........................1-6
1.3.9 Keyboard Connector ........................1-6
1.3.10 Mouse Connector.............................1-6
Chapter 2 Hardware Installation
2.1 ESD Precautions...................................2-1
2.2 Jumper Locations.................................2-2
2.3 Setting the Jumper...............................2-3
2.4 Installing a Microprocessor.................2-4
Table of Contents
viii
2.5 Upgrading the Microprocessor ...........2-6
2.6 Voltage Regulator Module ...................2-7
2.6.1 Installing VRM..................................2-7
2.6.2 Removing a VRM.............................2-8
2.7 Configuring the System Memory ........2-9
2.7.1 Installing a DIMM ...........................2-10
2.7.2 Removing a DIMM .........................2-11
2.8 Customizing your Hardware Setup...2-12
2.8.1 Selecting the DIMM Type...............2-12
2.8.2 Selecting the ECP DMA Channel...2-12
2.8.3 Clearing the CMOS........................2-13
2.8.4 Disabling the Onboard Super I/O
Controller.......................................2-13
2.8.5 Setting the ISA System Clock ........2-13
2.8.6 Disabling the PS/2
Mouse Function.............................2-14
2.8.7 Selecting the Flash ROM Type ......2-14
2.8.8 Setting the Keyboard Clock............2-14
2.9 Installing the System Board ..............2-15
2.10 Connecting Peripherals .....................2-16
2.10.1 Power Cable...................................2-16
2.10.2 Mouse ............................................2-16
2.10.3 Serial Devices (COM1/COM2).......2-17
Table of Contents
ix
2.10.4 Floppy Disk Drives.........................2-18
2.10.5 Printer ............................................2-18
2.10.6 IDE Devices ...................................2-19
2.10.7 Front-panel Switches and LEDs.....2-20
2.10.8 Keyboard........................................2-21
2.10.9 Keyboard Connector Bracket.........2-22
2.11 Installing Expansion Boards .............2-23
Chapter 3 AMI BIOS Utility
3.1 Entering the AMI BIOS Setup ..............3-1
3.2 Setup Menu...........................................3-3
3.2.1 Standard Setup................................3-3
3.2.2 Advanced CMOS Setup...................3-8
3.2.3 Chipset Features Setup..................3-13
3.2.4 Power Management Setup.............3-17
3.2.5 PCI/PnP Setup...............................3-21
3.2.6 Peripheral Setup ............................3-24
3.3 Security Setup ....................................3-26
3.3.1 Supervisor Password .....................3-27
3.3.2 User Password...............................3-28
3.3.3 Anti-virus........................................3-29
3.4 Utility Setup.........................................3-29
3.4.1 Color Set........................................3-30
Table of Contents
x
3.4.2 Language.......................................3-30
3.5 Default Setup ......................................3-31
3.5.1 Original...........................................3-31
3.5.2 Optimal...........................................3-32
3.5.3 Fail-safe .........................................3-32
3.6 Exiting Setup.......................................3-33
3.7 NCR SCSI BIOS and Drivers..............3-34
Appendix A Jumper and Connector Summary
Indice
Altri manuali AOpen Scheda madre
AOpen
AOpen MX4GR Guida all'installazione
AOpen
AOpen MX 36 LE-U Guida all'installazione
AOpen
AOpen AX34 Pro II Guida all'installazione
AOpen
AOpen AK33 M Guida all'installazione
AOpen
AOpen AX4C-G Guida all'installazione
AOpen
AOpen i945Ga-PLF Manuale utente
AOpen
AOpen s760GXm-SL Scheda tecnica
AOpen
AOpen s661FXm-7US Manuale utente
AOpen
AOpen AX45-533 Max Guida all'installazione
AOpen
AOpen MX34 Scheda tecnica
AOpen
AOpen MX4LR TV Manuale utente
AOpen
AOpen AK77-333F Guida all'installazione
AOpen
AOpen AX3S Pro-U Scheda tecnica
AOpen
AOpen MK79 Manuale utente
AOpen
AOpen AK77-600GN Guida all'installazione
AOpen
AOpen MX4GR Scheda tecnica
AOpen
AOpen MX46U2-GN Guida all'installazione
AOpen
AOpen MK33M(A) Scheda tecnica
AOpen
AOpen AX4SG WLAN Scheda tecnica
AOpen
AOpen AX4SP-G Guida all'installazione
Manuali Scheda madre popolari di altre marche
Telit Wireless Solutions
Telit Wireless Solutions SL869-3DR Manuale utente
Gigabyte
Gigabyte GA-9IVDT Manuale utente
Texas Instruments
Texas Instruments ADS8372EVM Manuale utente
Commell
Commell MS-C73 Manuale utente
IBT Technologies
IBT Technologies MB860 Manuale utente
Nvidia
Nvidia TEGRA DG-04927-001_V01 Manuale utente
