Arbor Technology EasyBoard-650E Manuale utente

EasyBoard-650E

User’s Manual

Version 1.0

Wide Range Temperature

3.5” Compact Board

2012.09

This page is intentionally left blank.

- I -

Index

Contents

Chapter 1 - Introduction......................................................1

1.1 Copyright Notice...........................................................................2

1.2 Declaration of Conformity ...........................................................2

1.3 About This User’s Manual ...........................................................4

1.4 Warning .........................................................................................4

1.5 Replacing the Lithium Battery.....................................................4

1.6 Technical Support ........................................................................4

1.7 Warranty ........................................................................................5

1.8 Packing List ..................................................................................6

1.9 Ordering Information....................................................................6

1.10 Specications .............................................................................7

1.11 Board Dimensions ......................................................................8

Chapter 2 - Installation........................................................9

2.1 Block Diagram ...........................................................................10

2.2 Jumpers....................................................................................... 11

2.3 Connectors..................................................................................12

Jumpers..............................................................................................13

JBAT1: Clear CMOS Setting..................................................13

JAT1: AT/ATX Power Mode Selection ...................................15

JCV1: COM Port Power Selector .........................................16

JV1/ JV2: Voltage/ RI Selector for COM1/ COM2 .................17

JRS1: COM2 RS-232/422/485 Mode Selection .....................18

JRS1: COM2 RS-485 Auto-FLow Selection..........................18

JVLCD1: LVDS1 LCD Panel Voltage Selection ....................20

Connectors.........................................................................................21

INV1: LCD Inverter Connector ..............................................21

LVDS1: LVDS Connector .......................................................22

SATA1: Serial ATA Connector ...............................................24

PWROUT1: SATA Power Connector .....................................25

AUDIO1: AUDIO Connector ...................................................26

COM2: Serial Port Connector................................................27

JCOM1: COM2 RS-422/ 485 Connector ................................28

USB1, 2: USB Connectors.....................................................29

- II -

Index

DIO1: Digital I/O Connector...................................................30

JFRT1: Switches and Indicators...........................................31

12VIN1: ATX +12V Connector................................................33

EATX1: ATX Feature Connector............................................34

MC1: Mini-card Socket...........................................................35

FAN1: CPU Fan Connector....................................................36

LAN1, 2: Gigabit Ethernet Connectors.................................37

USB3: USB Port Connectors.................................................38

DVI1: DVI Connector ..............................................................39

COM1: Serial Port Connector................................................41

CFast1: CFast Socket ............................................................42

2.3 The Installation Paths of CD Driver ..........................................44

Chapter 3 - BIOS................................................................45

3.1 BIOS Main Setup.........................................................................46

3.2 Advanced Settings .....................................................................47

3.2.1 ACPI Settings................................................................48

3.2.2 CPU Conguration .......................................................49

3.2.3 SATA Conguration......................................................50

3.2.4 USB Conguration .......................................................51

3.2.5 H/W Monitor ..................................................................52

3.2.6 Super IO Conguration................................................53

3.3 Chipset ........................................................................................55

3.3.1 Host Bridge Parameters ..............................................56

3.3.2 SB Conguration..........................................................58

3.4 Boot Settings ..............................................................................59

3.5 Security .......................................................................................60

3.6 Save & Exit..................................................................................62

3.7 AMI BIOS Checkpoints...............................................................63

3.7.1 Checkpoint Ranges .............................................63

3.7.2 Standard Checkpoints.........................................64

Appendix ............................................................................72

Appendix A: I/O Port Address Map .................................................73

Appendix B: Interrupt Request Lines (IRQ) ...................................76

Appendix C: BIOS Memory Map......................................................77

Appendix D: Digital I/O Setting .......................................................79

- 1 -

Introduction

1Chapter 1

Introduction

Chapter 1 - Introduction

- 2 -

Introduction

1.1 Copyright Notice

The information in this document is subject to change without prior notice in

order to improve the reliability, design and function. It does not represent a

commitment on the part of the manufacturer.

Under no circumstances will the manufacturer be liable for any direct, indirect,

special, incidental, or consequential damages arising from the use or inability

to use the product or documentation, even if advised of the possibility of such

damages.

This document contains proprietary information protected by copyright.

All rights are reserved. No part of this manual may be reproduced by any

mechanical, electronic, or other means in any form without prior written

permission of the manufacturer.

1.2 Declaration of Conformity

The CE symbol on your product indicates that it is in compliance with the

directives of the Union European (EU). A Certicate of Compliance is available

by contacting Technical Support.

This product has passed the CE test for environmental specications when

shielded cables are used for external wiring. We recommend the use of

shielded cables. This kind of cable is available from ARBOR. Please contact

your local supplier for ordering information.

This product has passed the CE test for environmental specications. Test

conditions for passing included the equipment being operated within an

industrial enclosure. In order to protect the product from being damaged by

ESD (Electrostatic Discharge) and EMI leakage, we strongly recommend the

use of CE-compliant industrial enclosure products.

Warning

This is a class A product. In a domestic environment this product may cause

radio interference in which case the user may be required to take adequate

measures.

FCC Class A

This device complies with Part 15 of the FCC Rules. Operation is subject to

the following two conditions:

- 3 -

Introduction

(1)This device may not cause harmful interference, and

(2)This device must accept any interference received, including interference

that may cause undesired operation.

NOTE:

This equipment has been tested and found to comply with the limits for a

Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference when

the equipment is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy and, if not installed

and used in accordance with the instruction manual, may cause harmful

interference to radio communications. Operation of this equipment in a

residential area is likely to cause harmful interference in which case the user

will be required to correct the interference at his own expense.

RoHS

ARBOR Technology Corp. certies that all components in its products are in

compliance and conform to the European Union’s Restriction of Use of Haz-

ardous Substances in Electrical and Electronic Equipment (RoHS) Directive

2002/95/EC.

The above mentioned directive was published on 2/13/2003. The main pur-

pose of the directive is to prohibit the use of lead, mercury, cadmium, hexava-

lent chromium, polybrominated biphenyls (PBB), and polybrominated diphenyl

ethers (PBDE) in electrical and electronic products. Member states of the EU

are to enforce by 7/1/2006.

ARBOR Technology Corp. hereby states that the listed products do not contain

unintentional additions of lead, mercury, hex chrome, PBB or PBDB that ex-

ceed a maximum concentration value of 0.1% by weight or for cadmium exceed

0.01% by weight, per homogenous material. Homogenous material is dened

as a substance or mixture of substances with uniform composition (such as sol-

ders, resins, plating, etc.). Lead-free solder is used for all terminations (Sn(96-

96.5%), Ag(3.0-3.5%) and Cu(0.5%)).

SVHC / REACH

To minimize the environmental impact and take more responsibility to the

earth we live, Arbor hereby conrms all products comply with the restriction

of SVHC (Substances of Very High Concern) in (EC) 1907/2006 (REACH

--Registration, Evaluation, Authorization, and Restriction of Chemicals)

regulated by the European Union.

All substances listed in SVHC < 0.1 % by weight (1000 ppm)

- 4 -

Introduction

1.3 About This User’s Manual

This user’s manual provides general information and installation instructions

about the product. This User’s Manual is intended for experienced users and

integrators with hardware knowledge of personal computers. If you are not

sure about any description in this booklet. please consult your vendor before

further handling.

1.4 Warning

Single Board Computers and their components contain very delicate

Integrated Circuits (IC). To protect the Single Board Computer and its

components against damage from static electricity, you should always follow

the following precautions when handling it :

1. Disconnect your Single Board Computer from the power source when you

want to work on the inside.

2. Hold the board by the edges and try not to touch the IC chips, leads or cir-

cuitry.

3. Use a grounded wrist strap when handling computer components.

4. Place components on a grounded antistatic pad or on the bag that comes

with the Single Board Computer, whenever components are separated from

the system.

1.5 Replacing the Lithium Battery

Incorrect replacement of the lithium battery may lead to a risk of explosion.

The lithium battery must be replaced with an identical battery or a battery type

recommended by the manufacturer.

Do not throw lithium batteries into the trash-can. It must be disposed of in

accordance with local regulations concerning special waste.

1.6 Technical Support

If you have any technical difculties, please do not hesitate to call or e-mail our

customer service.

http://www.arbor.com.tw

E-mail:info@arbor.com.tw

- 5 -

Introduction

1.7 Warranty

This product is warranted to be in good working order for a period of two years

from the date of purchase. Should this product fail to be in good working order

at any time during this period, we will, at our option, replace or repair it at no

additional charge except as set forth in the following terms. This warranty does

not apply to products damaged by misuse, modications, accident or disaster.

Vendor assumes no liability for any damages, lost prots, lost savings or any

other incidental or consequential damage resulting from the use, misuse of,

or inability to use this product. Vendor will not be liable for any claim made by

any other related party.

Vendors disclaim all other warranties, either expressed or implied, including

but not limited to implied warranties of merchantability and tness for a

particular purpose, with respect to the hardware, the accompanying product’s

manual(s) and

written materials, and any accompanying hardware. This limited

warranty gives you specic legal rights.

Return authorization must be obtained from the vendor before returned

merchandise will be accepted.

Authorization can be obtained by calling or

faxing

the vendor and

requesting a Return Merchandise Authorization (RMA)

number.

Returned

goods should always be accompanied by a clear problem

description.

- 6 -

Introduction

1.8 Packing List

1.9 Ordering Information

If any of the above items is damaged or missing, contact your vendor

immediately.

Packing List

Before you begin installing your single board, please make sure that the following

materials have been shipped:

1 x EasyBoard-650E 3.5" Compact Board with heatsink

1 x Power cable

1 x Driver CD

1 x Quick Installation Guide

EasyBoard-650E Intel Atom™ N2600 WT 3.5” Compact Board with CFast

socket

CBK-06-2501-00

Cable Kit

1 x COM port cable

1 x Audio cable

2 x USB cables

1 x SATA cable

1 x SATA power cable

Indice

Altri manuali Arbor Technology Scheda madre

Arbor Technology

Arbor Technology PBE-1000 Manuale utente

Arbor Technology

Arbor Technology EmCORE-i2702 Manuale utente

Arbor Technology

Arbor Technology ITX-i45M2 Manuale utente

Arbor Technology

Arbor Technology ITX-i230D Manuale utente

Arbor Technology

Arbor Technology EPIC-747E Manuale utente

Arbor Technology

Arbor Technology ETX-620E Manuale utente

Arbor Technology

Arbor Technology EmETXe-i90M3 Manuale utente

Arbor Technology

Arbor Technology ITX-i2705D Manuale utente

Arbor Technology

Arbor Technology MB-i35Q1 Manuale utente

Arbor Technology

Arbor Technology MB-i89Q0 Manuale utente

Arbor Technology

Arbor Technology EmCORE-i965H Manuale utente

Arbor Technology

Arbor Technology EmCORE-i77M3 Manuale utente

Arbor Technology

Arbor Technology Em104P-i6023 Manuale utente

Arbor Technology

Arbor Technology EmCORE-i55M0 Manuale utente

Arbor Technology

Arbor Technology Em104P-i2904 Manuale utente

Arbor Technology

Arbor Technology MB-i77Q0 Manuale utente

Arbor Technology

Arbor Technology ITX-i87H0 Manuale utente

Arbor Technology

Arbor Technology MB-i77Q0 Manuale utente

Arbor Technology

Arbor Technology ITX-i87H0 Manuale utente

Arbor Technology

Arbor Technology ITX-i9453 Manuale utente

Arbor Technology

Arbor Technology MB-i89Q0 Manuale utente

Arbor Technology

Arbor Technology EmCORE-i9651 Manuale utente

Arbor Technology

Arbor Technology PBE-1702 Manuale utente

Arbor Technology

Arbor Technology EmETXe-i91M0 Manuale utente

Manuali Scheda madre popolari di altre marche

DFI

DFI SD170 Manuale utente

ASROCK

ASROCK ROMED8-2T Manuale utente

Asus

Asus P2L97A Manuale utente

Winmate

Winmate IC70 Manuale utente

Asus

Asus MES-B Manuale utente

Grantech

Grantech SYS8F377VGGA-3OMN Manuale utente

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manuale utente

Gigabyte

Gigabyte GA-9IVDT Manuale utente

Texas Instruments

Texas Instruments ADS8372EVM Manuale utente

Commell

Commell MS-C73 Manuale utente

IBT Technologies

IBT Technologies MB860 Manuale utente

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manuale utente

Biostar

Biostar M7VIT Bravo Istruzioni per l'uso e l'installazione

Intel

Intel D33217CK Manuale utente

Asus

Asus F1A55-M LX PLUS R2.0 Manuale utente

EPC

EPC EPC9147C Manuale utente

Asus

Asus EX-B760M-V5 D4 Manuale utente

EPOX

EPOX MU-8KHA0010 Manuale utente