Reset Enables you to reset
the O-105E -- --
4 Install the Access Point
This chapter contains the stepwise procedure to install the access point (AP).
Zero-Configuration of O-105E as Access Point
Zero-configuration is supported under the following conditions:
• The device is in AP mode with background scanning on and no SSID configured.
• A DNS entry wifi-security-server is set up on all the DNS servers. This entry should point to the IP
address of the server. By default, the AP looks for the DNS entry wifi-security-server.
• The AP is on a subnet that is DHCP enabled.
Important: If the AP is on a network segment that is separated from the server by a firewall,
you must first open port 3851 for bidirectional User Datagram Protocol (UDP) and Transport
Control Protocol (TCP) traffic on that firewall. This port number is assigned to Arista Networks.
Zero-configuration cannot work if multiple APs are set up to connect to multiple servers. In this
case, the APs must be configured manually. For details on how to configure an AP manually,
see the Access Point Configuration Guide on our website at https://www.arista.com/en/support/
product-documentation .
Take a configured AP; that is, ensure that a static IP is assigned to the AP or the settings have been
changed for DHCP. Note the MAC address and the IP address of the AP in a safe place before it is
installed in a hard-to-reach location. The MAC address of the AP is printed on a label at the bottom of
the product.
The steps to install the AP with no configuration (zero-configuration) are as follows:
1. Wall Mount the O-105E or Pole Mount the O-105E
2. Power On the O-105E
3. Connect the O-105E to the Network
4.1 Pole Mount the O-105E
Use the pole-mount bracket and pole strap to install the O-105E device on a pole. Standard
accessories include two metal clamps.:
Use the mounting base to install the O-105E device on the wall. To mount the device:
1. Attach the device to the mounting base.
6
