AT&T E2525 Manuale utente

User Manual (Part 2)

2.4 GHz Expansion

Handset E250

For use with AT&T models

E2555 • E2525 • E2600B

91-5661-20-00.E250.R0.qxd 02/13/1950 19:21 Page 1

Table of contents

AT&T and the Globe Design are trademarks of AT&T Corp.,

licensed to Advanced American Telephones.

ST OP! See pa ges 2-3

for easy instructions.

You must charge

batteries and register the hand -

set before use.

For customer service or product

information, visit our web site at

www.telephones.att.com

or call 1-800-222-3111.

Please also read

Important Product Information

Enclosed in product package.

Before you begin........................................1

Parts checklist.............................................1

Battery installation & charging................2

Registering the handset............................3

Belt clip & optional headset ....................4

Quick reference guide..............................5

91-5661-20-00.E250.R0.qxd 02/13/1950 19:21 Page 2

Before you begin

This cordless telephone operates with

the maximum power allowed by the

Federal Communications Commission

(FCC). Even so, this handset and base

can communicate over only a certain

distance — which can vary with the

locations of the base and handset, the

weather, and the construction of your

home or office. For best performance,

keep the base antenna fully upright.

If you receive a call while you are

out of range, the handset might not

ring — or if it does ring, the call might

not connect when you press PHONE .

Move closer to the base, then press

PHONE to answer the call.

If you move out of range during a

phone conversation, you might hear

noise or interference. To improve

reception, move closer to the base.

If you move out of range without

pressing OFF , your phone will be left

“off the hook.” To hang up properly,

walk back toward the telephone base,

periodically pressing OFF until the call is

disconnected.

Parts checklist

Remember to save your sales receipt and original packaging in case you ever need to

ship your telephone for warranty service. Check to make sure the telephone package

includes the following:

Handset charger

Telephone

handset

Power

adapter

Belt clip

Batteries

91-5661-20-00.E250.R0.qxd 02/13/1950 19:21 Page 1

LOW BATTERY

Battery installation & charging

Install batteries as shown, then place the handset in the charger for at least 8 hours

before use. You can keep batteries charged by returning the handset to the charger after

each use. When battery power is fully depleted, a full recharge takes about 6 hours.

Press coin into slot on

base of handset to

release latch, then

remove battery cover.

Insert supplied

batteries.

Place handset in charger to

charge for 8 hours before first use.

Light remains on while batteries

are charging.

Low battery indicator

Return handset to charger to recharge

when this symbol flashes. (Handset

will beep when battery is low.)

Caution: Use only the supplied

NiCd battery (80-5469-00-00)

or AT&T model 2AA NiMH

replacement battery (SKU

26820). Do not use alkaline

batteries.

Insert top

tab first.

To replace battery cover

Press down to

click in place.

REDIAL MEM

Plug power cord into jack on underside

of charger, then plug transformer into

electrical outlet.

91-5661-20-00.E250.R0.qxd 02/13/1950 19:21 Page 2

Registering the handset

Before using your new handset, you must register it with

the base. During registration, you must enter the 15-digit

ID number of the telephone base. To find this number, go

to the base, press MENU , scroll down to select DISPLAY

BASE ID , then press OK.

The handset provided with your telephone is automatically

registered as Handset 1. Additional handsets will be

assigned numbers in the order they are registered (2, 3, 4,

etc.) up to a maximum of eight.

ENTER BASE ID

123456789012345

Enter base ID, then press OK.

HANDSET 2

Handset 1 Handset 2 Handset 3

REDIAL MEMMENU

91-5661-20-00.E250.R0.qxd 02/13/1950 19:21 Page 3

Belt clip & optional headset

Install belt clip as shown below if desired.

For hands-free telephone conversations, you can use any industry standard 2.5 mm

headset (purchased separately). For best results use an AT&T 2.5 mm headset.

Snap belt clip into notches on

side of handset. Rotate and pull

to remove.

Plug 2.5 mm headset

into jack on side of

handset (beneath

small rubber cap).

91-5661-20-00.E250.R0.qxd 02/13/1950 19:21 Page 4

HANDSET 2

REDIAL MEM

Off/Clear

During a call, press to hang up.

While using menus, press to cancel an

operation, back up to the previous

menu, or exit the menu display.

Quick reference guide

Speaker

Press to activate handset speaker-

phone. Press again to resume normal

handset use (earpiece).

Softkeys

Press a softkey to select a menu item

displayed just above the key.

Phone/Flash

Press to begin a call, then dial a number.

During a call, press to receive an incoming

call, if Call Waiting is activated.

Sound Select

Press to customize the sound at the ear-

piece for clear conversations.

Xfer/Intercom

Press to transfer a call or initiate an

intercom conversation.

Redial Log Phonebook

Screen menus

Item 1 Item 2 Item 3

Menus

Main Menu

Calls Log

Play Messages

Handset Settings

Set Time

Clock Mode

Handset Settings

Ringer Volume

Ringer Melody

Low Batt Tone

Range Tone

Keypad Tone

Contrast

Language

For complete instructions, please refer to the manual provided with your telephone.

91-5661-20-00.E250.R0.qxd 02/13/1950 19:21 Page 5

AT&T and the Globe Design are trademarks of AT&T Corp.,

licensed to Advanced American Telephones. Printed in China. Issue 2 AT&T 06/04.

91-5661-20-00

www.telephones.att.com

91-5661-20-00.E250.R0.qxd 02/13/1950 19:21 Page 6

Altri manuali per E2525

Questo manuale è adatto per i seguenti modelli

Indice

Manuali Cornetta popolari di altre marche

Swissvoice

Swissvoice ePure HD Manuale utente

Philips

Philips TD6736/BH051P Manuale utente

ASCOM

ASCOM I62 - Manuale utente

LG-Ericsson

LG-Ericsson LIP-9010 Manuale utente

GE 1583 Manuale utente

iiNet

iiNet Handset Manuale utente

ASCOM

ASCOM 9p23 Manuale utente

AirCell

AirCell ST 3100 Manuale utente

Eaton

Eaton HHIR-LCD-PROG Istruzioni per il montaggio

Mitel

Mitel 112 Manuale utente

SBC

SBC SBC-381H Manuale utente

Mitel

Mitel 5602 Manuale utente

ASCOM

ASCOM d81 Messenger Istruzioni per l'installazione

SpectraLink

SpectraLink 7522 Manuale utente

Avaya

Avaya L100 Series Come usare

ooma

ooma HD2 Handset Manuale utente

Yealink

Yealink IPW56 Manuale utente

Sony

Sony SBH52 Manuale utente