BARRON TL301 Manuale utente

TL301

INSTALLATION INSTRUCTIONS

SAVE THESE INSTRUCTIONS!

INSTALLATION INSTRUCTIONS

READ CAREFULLY AND FOLLOW ALL INSTRUCTIONS FOR YOUR OWN SAFETY

• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.

•Installation and servicing of this equipment should be performed by qualified service personnel only.

•Ensure the electricity connections conform to the National Electrical Code and local regulations if applicable.

•Do not mount near gas or electrical heaters.

•Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by

unauthorized personnel.

•The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition. Any

modification or use of non-original components will void the warranty and product liability.

•Do not use this equipment for other than intended use.

800.533.3948 •www.barronltg.com

20070062 REV 2 - 10/13

1. Mount fixture in desired location using the supplied trunnion mounting bracket and appropriate hardware for

application.

2. Unhinge refractor housing by loosing (4) screws and removing reflector.

3. Feed wire leads into fixture through center opening in trunnion.

4. Electrical connection should be made inside fixture. Cap all unused leads to prevent shorting. This

fixture is pre-wired for 277 volt; make sure supply line voltage is 277 volt. For alternate line voltage select proper

ballast lead to match your line voltage.

a. Connect the line fixture lead to the black supply lead.

b. Connect the common fixture lead to the white supply lead.

c. Connect the ground lead from the sevice to green grounding screw.

5. Use approved connectors to connect fixture leads to supply leads and make wire splices inside fixture.

6. Replace reflector, and install lamp.

7. Replace refractor; make sure that the lens gasket is properly seated around the perimeter of the lens to ensure a

weather tight seal.

8. Set desired fixture angle by removing postioning screw, loosing trunnion bolts and rotating trunnion to desired

angle. Then re-insert positioning screw and tighten.

TL301

INSTALLATION INSTRUCTIONS

800.533.3948 •www.barronltg.com

20070062 REV 2 - 10/13

IMPORTANT

To weather-proof your outdoor installation, be sure to seal all holes in fixture housing. (Mounting, conduit,

plugs, and photo controls, etc) with silicone sealant.

TROUBLESHOOTING CHECKLIST

1. Check your power source.

2. If power is on and lamp does not burn. Turn power source off and lock out to prevent power being restored.

3. Check electrical connections.

4. Check to ensure proper seating of lamp.

5. Restore power.

6. Check if lamp is burned out.

REPLACING LAMP INSTRUCTIONS

1. When re-lamping, turn power off and allow the fixture to cool.

2. Prior to installing the lamp in the fixture, check the lamp is of proper type and wattage.

3. Screw the lamp into the socket, back the lamp out slightly, then screw the lamp securely back in to make sure it is

properly seated in the socket.

4. Close the refractor and secure with screws. Be sure that the gasket is firmly seated in the proper channel prior to

closing fixture to maintain weather-tight seal.

NOTE: Replace only with a lamp of same type and wattage as indicated on the fixture product label.

Indice

Altri manuali BARRON Attrezzatura di illuminazione

BARRON

BARRON EXITRONIX 82 Series Manuale utente

BARRON

BARRON Exitronix VEX-8 NEMA Manuale utente

BARRON

BARRON Exitronix NFT Series Manuale utente

BARRON

BARRON Exitronix S900C Series Manuale utente

BARRON

BARRON EXITRONIX SCL Series Manuale utente

BARRON

BARRON EXITRONIX LED-51 Series Manuale utente

BARRON

BARRON Exitronix NY900C Series Manuale utente

BARRON

BARRON EXITRONIX VLEDC Series Manuale utente

BARRON

BARRON Speciality LED FBTCJ-24V Manuale utente

BARRON

BARRON Exitronix CRL Series Manuale utente

BARRON

BARRON Exitronix 900E Series Manuale utente

BARRON

BARRON TRACE-LITE WTA Series Manuale utente

BARRON

BARRON Trace-Lite AXL2 Manuale utente

BARRON

BARRON Exitronix LED-90 Series Manuale utente

BARRON

BARRON Exitronix NFT Series Manuale utente

BARRON

BARRON EXITRONIX VLED-90L Series Manuale utente

BARRON

BARRON TRACE-LITE RHL-ACR Manuale utente

BARRON

BARRON Growlite GRM Manuale utente

BARRON

BARRON Growlite GLB-315-A-120/277 Manuale utente

BARRON

BARRON EXITRONIX ILX Series Manuale utente

BARRON

BARRON Trace-Lite E110 Manuale utente

BARRON

BARRON TRACE-LITE TL101 Manuale utente

BARRON

BARRON TRACE-LITE AXL2 Manuale utente

BARRON

BARRON Growlite GLE-GL Manuale utente

Manuali Attrezzatura di illuminazione popolari di altre marche

Brizo

Brizo 8SP-MU-4 Manuale utente

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manuale utente

IKEA

IKEA BJÖRKSPIREA Manuale utente

Laserworld

Laserworld Evolution Series ES-400RGB Manuale utente

Alien

Alien RG STAR Manuale utente

EuroLite

EuroLite LED B-40 Manuale utente

Qazqa

Qazqa Suplux SL 3 Black 103062 Manuale utente

Commercial Electric

Commercial Electric 54568141 Manuale utente

CREE LIGHTING

CREE LIGHTING 304 Series Manuale utente

Goobay

Goobay 49867 Manuale utente

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manuale utente

Alkalite

Alkalite Krypton KT-81 Manuale utente

Clas Ohlson

Clas Ohlson GU10 Manuale utente

DTS

DTS DELTA 10 F Manuale utente

ring

ring Solar Steplight Manuale utente

One Stop Gardens

One Stop Gardens 57696 Istruzioni per il montaggio

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manuale utente

SIREM

SIREM Swimeo A2 Manuale utente