P a g e | 2
! IMPORTANT !
BENETECH, INC. HEREBY DISCLAIMS ANY LIABILITY FOR, BUT NOT LIMITED TO:
IMPROPER INSTALLATION OF EQUIPMENT
IMPROPER SIZING OF EQUIPMENT
DAMAGE DUE TO CONTAMINATION OF MATERIAL
USER’S FAILURE TO INSPECT EQUIPMENT
USER’S FAILURE TO MAINTAIN EQUIPMENT
USER’S FAILURE TO TAKE REASONABLE CARE OF THE EQUIPMENT
INJURIES OR DAMAGE RESULTING FROM USE OR APPLICATION OF THIS PRODUCT CONTRARY TO
INSTRUCTIONS AND SPECIFICATIONS CONTAINED HEREIN.
BENETECH, INC.’S LIABILITY SHALL BE LIMITED TO REPAIR OR REPLACEMENT OF EQUIPMENT SHOWN TO
BE DEFECTIVE.
! SAFETY !
Review and understand all safety rules given herein along with local and Governmental standards and
regulations. Know and understand the American National Standards Institute (ANSI) z244.1-1982
lockout/tagout procedures, the American National Standard for Personnel Protection - Lockout/Tagout of
Energy Sources - Minimum Safety Requirements and the Occupational Safety and Health Administration
(OSHA) Federal Register, Part IV, 29 CFR Part 1910, Control of Hazardous Energy Source (Lockout/Tagout);
Final Rule.
Also observe all local and Governmental regulations concerning entry into confined spaces, welding,
cutting, grinding, wash-down procedures and all Personal Protective Equipment (PPE) regulations.
The following notations are used throughout in this manual.
! DANGER !
Danger: Denotes immediate hazards that will result in severe personal injury or death.
! WARNING !
Warning: Denotes hazards or unsafe practices that could result in personal injury.
! IMPORTANT !
Important: Denotes instructions that must be followed for proper installation and/or operation of
equipment.
NOTE
Note: Denotes general items to assist the reader/ installer/ operator.
***
Please pay close attention to all of these items and warnings.
They have been included here for your safety and for ease of installation.
