Black Box LB8415A-US Manuale utente

Express

Ethernet Switch

LB8415A-US

May, 2006

CUSTOMER

SUPPORT

INFORMATION

Order toll-free in the U.S. Call : 877-877-BBOX ( Outside U. S. call 724-746-5500 )

FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax

724-746-0746

Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018

Web site: www.blackbox.com • E-mail: [email protected]m

Express Ethernet Switch LB8415A-US

FEDERAL COMMUNICATIONS COMMISSION AND

CANADIAN DEPARTMENT OF COMMUNICATIONS

RADIO FREQUENCY INTERFERENCE STATEMENT

Class B Digital Device. This equipment has been tested and found to comply

with the limits for a Class B computing device pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. However, there is no guarantee

that interference will not occur in a particular installation. This equipment

generates, uses, and can radiate radio frequency energy, and, if not installed

and used in accordance with the instructions, may cause harmful interference

to radio communications. If this equipment does cause harmful interference to

radio or telephone reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference

by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

• Consult an experienced radio/TV technician for help.

Caution:

Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to

operate the equipment.

To meet FCC requirements, shielded cables and power cords are required to

connect this device to a personal computer or other Class B certified device.

This digital apparatus does not exceed the Class B limits for radio noise

emission from digital apparatus set out in the Radio Interference Regulation of

the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant

les limites applicables aux appareils numériques de la classe B prescrites dans

le Règlement sur le brouillage radioélectrique publié par le ministère des

Communications du Canada.

Normas Oficiales Mexicanas (NOM)

INSTRUCCIONES DE SEGURIDAD

1. Todas las instrucciones de seguridad y operación deberán ser leídas

antes de que el aparato eléctrico sea operado.

2. Las instrucciones de seguridad y operación deberán ser guardadas para

referencia futura.

3. Todas las advertencias en el aparato eléctrico y en sus instrucciones de

operación deben ser respetadas.

Express Ethernet Switch LB8415A-US

4. Todas las instrucciones de operación y uso deben ser seguidas.

5. El aparato eléctrico no deberá ser usado cerca del agua—por ejemplo,

cerca de la tina de baño, lavabo, sótano mojado o cerca de una alberca,

etc.

6. El aparato eléctrico debe ser usado únicamente con carritos o

pedestales que sean recomendados por el fabricante.

7. El aparato eléctrico debe ser montado a la pared o al techo sólo como

sea recomendado por el fabricante.

8. Servicio—El usuario no debe intentar dar servicio al equipo eléctrico más

allá a lo descrito en las instrucciones de operación. Todo otro servicio

deberá ser referido a personal de servicio calificado.

9. El aparato eléctrico debe ser situado de tal manera que su posición no

interfiera su uso. La colocación del aparato eléctrico sobre una cama,

sofá, alfombra o superficie similar puede bloquea la ventilación, no se

debe colocar en libreros o gabinetes que impidan el flujo de aire por los

orificios de ventilación.

10. El equipo eléctrico deber ser situado fuera del alcance de fuentes de

calor como radiadores, registros de calor, estufas u otros aparatos

(incluyendo amplificadores) que producen calor.

11. El aparato eléctrico deberá ser connectado a una fuente de poder sólo

del tipo descrito en el instructivo de operación, o como se indique en el

aparato.

12. Precaución debe ser tomada de tal manera que la tierra fisica y la

polarización del equipo no sea eliminada.

13. Los cables de la fuente de poder deben ser guiados de tal manera que

no sean pisados ni pellizcados por objetos colocados sobre o contra

ellos, poniendo particular atención a los contactos y receptáculos donde

salen del aparato.

14. El equipo eléctrico debe ser limpiado únicamente de acuerdo a las

recomendaciones del fabricante.

15. En caso de existir, una antena externa deberá ser localizada lejos de las

lineas de energia.

16. El cable de corriente deberá ser desconectado del cuando el equipo no

sea usado por un largo periodo de tiempo.

17. Cuidado debe ser tomado de tal manera que objectos liquidos no sean

derramados sobre la cubierta u orificios de ventilación.

18. Servicio por personal calificado deberá ser provisto cuando:

A: El cable de poder o el contacto ha sido dañado; u

B: Objectos han caído o líquido ha sido derramado dentro del aparato; o

Express Ethernet Switch LB8415A-US

C: El aparato ha sido expuesto a la lluvia; o

D: El aparato parece no operar normalmente o muestra un cambio en su

desempeño; o

E: El aparato ha sido tirado o su cubierta ha sido dañada.

Express Ethernet Switch LB8415A-US

Table of Contents

Table of Contents ............................................................................................. 5

About This Manual............................................................................................ 6

Packing List....................................................................................................... 6

Introduction....................................................................................................... 7

Product Features ............................................................................................ 7

Front & Back Panel......................................................................................... 8

LEDs ............................................................................................................... 8

Installation......................................................................................................... 9

Selecting a Site for the Switch........................................................................ 9

Connecting to Your Network........................................................................... 9

Specifications ................................................................................................. 10

Express Ethernet Switch LB8415A-US

About This Manual

This manual describes the Black Box Express Ethernet Switch in these basic

sections:

•FCC Statement

•Introduction

•Product Features

•Installation

Packing List

Please inspect the contents and report any apparent damage or missing items

immediately to Black Box.

•The switch

•User’s Manual

•External AC to DC power Linear Power Supply

Express Ethernet Switch LB8415A-US

Introduction

LB8415A-US is an 8-port Fast Ethernet switch, integrating 10/100BaseTX

networks in a cost-effective desktop package. The TX ports are auto MDIX and

capable of auto negotiate speed and half/full duplex modes.

Product Features

•7-port 10/100BaseTX. & 1-port 100Base FX

•Equipped with US Linear Power Supply (110VAC, 12V, 0.6A)

•Auto MDIX on all TX ports to eliminate the need for crossed over cable

•TX ports are capable of auto negotiate 10/100Mbps speed & full/half

duplex mode

•Broadcast storming filter function.

•True non-blocking architecture.

•Full wire-speed forwarding rate.

•Store-and-forward mechanism.

•Back pressure and IEEE802.3x compliant flow control.

•Supports 2K MAC addresses.

•Supports 1M bits buffer memory.

•Front panel power and port status LEDs.

•Wall-mountable pocket size.

Express Ethernet Switch LB8415A-US

Front & Back Panel

LB8415A-US is a space saving pocket size 8-port TX/FX Ethernet switch designed for wall-

mount or desktop. LED indicators and TX/FX ports are located on front and back panels

respectively. Back panel is equipped with seven TX ports, one FX port, and a DC receptacle.

The front panel displays arrays of LEDs indicating power & individual port activity.

Back Panel

Power Receptacle: Connect the supplied universal power adaptor to the receptacle on back

panel and then plug the cord into standard AC outlet with a voltage range

from 100 to 240

Fiber Port

Front Panel Power PortStatus

LEDs

LED indicators on the front panel convey status information to help you monitor and

troubleshoot the switch.

Power

This LED comes on when the switch is connected to the power adapter.

Port Status

Each port has a matching LED showing the port status. When port LED is on, it

indicates the corresponding port is connected with another switch/hub or

computer. When port LED blinks, it indicates exchanging data or packets

within the network is proceeding.

The table below provides detailed information on LEDs.

LED State Indication

Steady The port has established a valid network connection.

LNK stands for LINK.

LNK/ACT Flashing The port is transmitting or receiving data.

ACT stands for ACTIVITY.

Express Ethernet Switch LB8415A-US

Installation

Selecting a Site for the Switch

As with any electronic device, you should place the switch where it will not be subject

to extreme temperatures, humidity, or electromagnetic interference. Specifically, the

site you select should meet the following requirements:

•The ambient temperature should be between 32 and 104 degrees Fahrenheit (0 to

40 degrees Celsius).

•The relative humidity should be less than 90 percent, non-condensing.

•Surrounding electrical devices should not exceed the electromagnetic field (RFC)

standards for IEC 801-3, Level 2 (3V/M) field strength.

•Make sure that the switch receives adequate ventilation. Do not block the

ventilation holes on the side of the switch or the fan exhaust port on the rear of the

switch.

•The power outlet should be within 1.8meter (6 feet) of the switch.

Connecting to Your Network

Connect network cables from computers or network segments to the TX ports on the

back panel.

Table 2: Cabling Information

Speed Connector Port Speed

Half/Full Duplex Cable

100BaseTX RJ-45 100/200 Mbps 100 m, Category 5 STP/UTP

10BaseT RJ-45 10/20 Mbps 100 m, Category 3, 4, or 5 STP/UTP

100BaseFX

Multi-mode SC, ST, MT-RJ,

VF-45, or LC 100/200 Mbps Up to 2km, 50 or 62.5/125µm

Multi-mode fiber cable

100BaseFX

Single-mode SC 100/200 Mbps Up to 75km, 9 or 10/125µm

Single-mode fiber cable

Express Ethernet Switch LB8415A-US

Specifications

Applicable

Standards

IEEE 802.3, 10BaseT,

IEEE 802.3u, 100BaseTX/FX

LED Indicators Per unit – Power Status

Per Port – LNK/ACT

Cable

10BaseT 2-pair UTP/STP Cat. 3,4,5, up to 100m

100BaseTX 2-pair UTP/STP Cat.5, up to 100m

100BaseFX 50 or 62.5/125µm Multi-mode fiber optic cable, up to 2km

100BaseFX 9 or 10/125µm Single-mode fiber optic cable, up to 75km

Switching

Methods Store-and-Forward

Forwarding

Rate 14,880pps for 10Mbps,

148,800pps for 100Mbps

AC Input 110VAC, 50-60Hz, external linear power supply

Power

consumption 110VAC, 12V, 0.6A

Operating

Temperature 0°C~40°C (32°F~104°F)

Storage

Temperature -25°C~70°C (-13F°~158°F)

Humidity 10%~90%, non-condensing

Emissions FCC part 15 Class B, CE Mark-B,

Dimensions W160 x D81 x H28mm palm size

Weight 0.42kg (0.92lb.)

Indice

Altri manuali Black Box Router di rete

Black Box

Black Box COS-4P Manuale utente

Black Box

Black Box LEH1008A Manuale utente

Black Box

Black Box LB9019A-R2 Manuale utente

Black Box

Black Box LW6001A Manuale utente

Black Box

Black Box LEH1208A Manuale utente

Black Box

Black Box LDM-MR128 Manuale utente

Black Box

Black Box LB611A Manuale utente

Black Box

Black Box LR120A Manuale utente

Black Box

Black Box LR0003A Manuale utente

Black Box

Black Box LR5100A-T Manuale utente

Black Box

Black Box LGB2008A-R2 Manuale utente

Black Box

Black Box LR1530A-EU-R3 Manuale di istruzioni

Black Box

Black Box VOE241 Manuale utente

Black Box

Black Box Series 500 Manuale utente

Black Box

Black Box LB5000A Guida rapida

Black Box

Black Box LB9002A-ST-R2 Manuale utente

Black Box

Black Box LW6005A Manuale utente

Black Box

Black Box 1000 Series Manuale utente

Black Box

Black Box WRT-300BGN-R2 Manuale utente

Black Box

Black Box LR1531A-R2 Manuale utente

Black Box

Black Box LR0019A-4U Manuale utente

Black Box

Black Box LRU4240 Manuale utente

Black Box

Black Box WS100A Manuale utente

Black Box

Black Box LPB1308A-R2 Manuale utente

Manuali Router di rete popolari di altre marche

Allnet

Allnet ALL0333AU Manuale utente

HomeSeer

HomeSeer HT-SEL Manuale utente

Sercomm

Sercomm Genesis OC3505D Manuale utente

Billion

Billion BIPAC 5102 Series Manuale utente

TP-Link

TP-Link TD-8817 Manuale utente

Motorola

Motorola MR1900 Manuale utente

Digi

Digi IX14 Manuale utente

Cisco

Cisco NCS 540 Manuale

XAVi

XAVi X8821e Manuale utente

BEC

BEC 6200WZL Manuale utente

MikroTik

MikroTik hAP ac3 Series Manuale utente

Korenix

Korenix JetNet 5428G Series Manuale utente

NETGEAR

NETGEAR FS526T - Switch Manuale utente

Korenix

Korenix JetNet 5710G Series Manuale utente

Automated Logic

Automated Logic ZN551 Manuale del proprietario

Cisco

Cisco ASR 1000 Series Manuale dell'operatore

EnGenius

EnGenius ESR-9710 Manuale utente

Cisco

Cisco 805 Series Istruzioni operative e di sicurezza