Quick unpacking/mounting steps:
1. Remove all parts from shipped BOX.
Prepare additional tools: RJ45
connectors (pcs.2), UTC or STP cat.5
(not included to shipment), Ethernet
crimping tool, screwdriver, scissors etc.
2. Mount GNSS receiver on the top point of
roof of a building. It should access
possible a 360o sky view to receive max.
available satellite vehicles (SVN). Do not
mount GNSS receiver nearby: wall,
chimney, electric engines, fans and air-
conditions. The min. recommended
distance to keep between other: GNSS,
TELECOM transmitters at least 2 meters!
3. Lunch UTP (STP) cables down to server
room. Cables should not be located in
direct neighborhood of other power lines.
Try play gently with cables (do not cut
cables, nor break cable). Well done cable
installation should be tested for
connectivity and resistance before using.
4. (optionally) Mount NTS-surge protection
on the back of rack’19 shell. Ensure, it is
properly grounded to PE lines. Ask,
certified authority to assist you, if you are
not qualified for electric installations.
Read all safety instructions first.
5. Crimp RJ45 connectors to terminate
antenna cables. Test connection again.
6. Locate Time Server in rack”19 shell.
Please keep min. 1U space to
neighborhood product that can
unexpectedly hit your NTS-x000.
7. Connect all POWER lines 110-230VA.
8. Switch POWER-ON. Observe server’s
LCD and 6x LED during BOOT, and
GNSS synchronization.
9. Setup basic LAN configuration from front
panel KEYBOARD.
10. Prepare PC for SSH/www advance setup
via interface LAN1 or LAN2.
